Jump to content
SAU Community

Recommended Posts

OK thats 10 short shift kits so far. :rolleyes:

Monday (6-12-2004) I will call the last day for this batch becase I know some of you are keen to get the kit installed... I will email everyone on monday.

There is still room for more people. If you want one better get in while its cheap...

  • Replies 69
  • Created
  • Last Reply

Top Posters In This Topic

My mate wants one aswell - so now I'll grab 2 for R33. What is the postage costs for 2?I reckon we'll hit the $110 mark at this rate. 15 now 5 more to go.... :(

At this rate I reckon we will hit the $120 dollar mark... awesome.. Unfortunately I  will have a lot of posting to do :(

I have just notified everyone who was interested. If you have not received an email or PM then PM me so I can send you the details.

Also I have extended the deadline till the end of the week possible early depending on when people get back to me. So if somebody out there still wants a short shift kit let me know. They will be $120 each plus 13 for p&h.

Those that got Rafael's e-mail will now know there is some doubt whether these kits will fit an R32 GTR. I've indicated that I'm not prepared to continue with my purchase unless it can be confirmed that it will fit without problems - is there someone in Brisbane with an R32 GTR and who is planning to buy that can get the situation confirmed one way or another ??.

With the number planning to purchase I don't see why one or two dropping out should make any difference to the final price.

Good Luck.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
×
×
  • Create New...