Jump to content
SAU Community

Recommended Posts

So far, i've not been spotted.

The first person to spot me tommorrow day/avo wins $20...... ! (Either pickable up at a SAU meeting or transfer)

I'm having a run down from Bathurst in the morning, (thurs) - to Syd and then down to Berry......

The First person to see me, and say what colour shirt i'm wearing, gets it...

(Can't you tell i'm bored)

Silver R33 SII, R400 Front & Sides, FMIC, Plate ZEBHAX.

<-------------------------------- See Pic

Any Takers...... ?

Edit : I'll also be doing the reverse on Sunday, if i'm not spotted, which'd be right......

Link to comment
https://www.sau.com.au/forums/topic/61950-to-be-spotted-challenge/
Share on other sites

  • Replies 45
  • Created
  • Last Reply

Top Posters In This Topic

My Missus reckons that she may have spotted you around Kiama.

She was parked under a overhead bridge as it was about to piss down, and I rang and told her it was hailing in Nowra.

Will have to put her under hypnosis to try and remember the shirt colour though.

Enjoy Berry.

El Bee & Humbla.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Mixing things up - installed some leather recaros to match the leather seat covered rear seats. Interior looks pretty schmick now except for some slight wear on the steering wheel which I will monitor and address if it becomes worse or actually noticeable!  
    • Didnt realise RB's had more then 1 head.
    • I'm normally copping my own abuse from neglecting my daily drivers. "Those suspension bushes will last a bit more", "Don't worry about the oil leak, just keep topping it up". The project cars I'm always doing things slowly on them as I'm wanting them to be done better, and neater, and nicer. Luckily I don't have to deal with 18 year old Matt's "Learning to wire" stuff in the project cars. And there's only one piece of wiring I'm displeased about in the Landcruiser, and it's about to be cut out... However, the box loads of parts that have been going through this place lately for the Landcruiser... Brake pads Brake Rotors Full handbrake overhaul Wheel Bearings Seals Swivel hubs Steering Boxes Half the suspension joints Shocks Air bags (Ones to go in the rear springs for towing) Water pump Timing kit Lower timing case Harmonic Balancer Radiator Lots of other little seals and shits Gas struts for the bonnet New power window switches And god knows what else I've forgotten... Ha ha ha I have my fingers crossed the pinion seals don't start leaking on the diffs, that the transfer case doesn't leak, and the gearbox input shaft doesn't leak, nor the rear main seal. As they're about the only seals I haven't replaced in the driveline! I'm seriously eyeing off buying new caliper rebuild kits front and rear brake calipers... I'll probably recheck all the valve clearances soon too, and hopefully, it should be all good and sweet to haul some long distance trips again!
    • Every time I pull my 3x gauges out of the console and see the crack-addict way that I did the wiring, and I just can't bring myself to tear it all apart and "make it nice", because it is currently working. In fact, the last time I was in there I probably made it worse.
    • The best part is when you own the car long enough that you look back and find your OWN ham fisted amateur shit!
×
×
  • Create New...