Jump to content
SAU Community

Recommended Posts

HI all

OK i dont know if i have a problen here and i was wondering if someone could shed some light on this.

When i forst got the GTR up untill just recently it used to really hammer. and looking at the torque gauge on the dash it would rarly go to the front wheels, would when i launched and if i changed gears hard but once moving it would show 0 to the fronts and really hammered. Recently i have had new tires and a wheel alignment done. now it always seams to show around 10 on the gauge, if im just cruising around it wont but as soon as i put the foot down doesnt matter what gear what speed the torque gauge will go up and will stay there till i take my foot off, because of this it doesnt seam to be as quick when its up and moving still lightnight of the start but once moving i can feel the lack of power because its going to the fronts when it used to be all at the rears.

Would anyone know whay this is??? cause im not sure which way is normal.

also i was driving say a month back and one of the wheels came loose and my torgue gauge was up and down like a yoyo but once i got new nuts for it it and it wasnt moving around the car went back to normal, so im guessing the wheels can change this is some way, so did the alignment make it the way it is and how do i ge it back to the way it was??

cheers

Link to comment
https://www.sau.com.au/forums/topic/65072-question-about-an-r32-gtr/
Share on other sites

The 4WD is directly integrated with your ABS sensors. Are you having any problems with your ABS?

The torque split control should be active when you power down. The more slip it gets in the rear, the more torque is applied to the fronts.

You could take it on a dyno and have them diagnose it for you. You would also be able to get an indication of it's power. Sometimes, well I know I did, you get used to the power and it doesn't seem to go as quick. I'm not sure if your is the same but the dyno would explain it.

What complete utter crap!!

How is ABS dangerous to drive with? ABS can activate/de-activate a 100 times quicker than your brain/leg/foot can so having ABS makes you certainly no worse off than not having ABS.

About 3wks ago I was dropping a friend off home in my estate at 2am on a very windy road (50km/h) when I came around a sharp blind corner to find some dickhead put 2 old tyres right in the middle of the road. I slammed on the brakes (activating ABS) and 'turned' around them (thankgod for the smooth curved gutters otherwise i'd have no frontbar) and drove along the side of the gutter.

I'd put money on it that without ABS you would have driven straight into the 2 tyres ripping your frontbar off whilst your front wheels were pointed towards the side gutter.

Now back on topic....

Learn how to drive instead of relying on driving aids would be my motto. Dosen't take much to learn how to cadance brake. ABS makes up for what a good driver dosen't have: so overall yes it is good to have on a road car.

Nugget what size front and rear tyres do you have

My torque guage starts to move as soon as i start boosting. If i take a corner hard and power into it, guage goes way up. Always has been like this since i got it. If it's constanly on 10, you have tire size issues. I got a flat and chucked the Nissan cheese cutter (space saver) on, i have 17", cheese cutter is 16", and my guage stayed on 10 all the time.

Can't argue with Morgs on this one. I have trouble activating the ABS, because I've learned to threshhold brake.

...I slammed on the brakes (activating ABS)...
This is Morgs point - a properly trained driver would not have done this.

As for throwing away the fuse - if you don't want AWD, then don't get a GT-R!

Now, back on topic - Nugget, did you replace all 4 tyres? Did you replace them with the same type / size at each corner?

This is Morgs point - a properly trained driver would not have done this.
Bad choice of words, it was a figure of speech. However driving in pitch black around a corner sweeping corner, black tarmac road, 2 black tyres sitting in the middle, doing 50 in a 50 zone and good luck without ABS is all I can say.

ahh cmon even the best drivers will hit ABS.

on the track is different, same corner, surface, tyres and you did it all 2 min ago.

On the road you have different surfaces, hotter or colder tyres, hotter or colder day and road, oil/dust/debris on the surface. No way you can be *sure* of where the threshold is until you go over it...then ben's point come into play....by the time you feel or hear the lock up ABS would have pulsed 100 times.

Most likely if you aren't hitting abs or locking up you aren't braking hard enough...often people think they are getting the most out of their brakes, but when someone shows what they can really do, they are amazed.

Give me ABS on the road any day.

BTW I was watching an interesing video from 1991 the other day of the winfield GTR on slicks and a standard road car pulling up. The standard road car with ABS was 10m less :cheers:

Sorry about the OT....my guess is your front and rear tyres are different sizes. You need to get it fixed ASAP either way because it will excessively wear your transfer case.

Hey Duncan well said. And Morgs do you think Nissan fitted ABS to GTR's just to look after "unskilled" drivers? No. The reason they fitted it is because that it is the best system!! By your estimations Grand Prix drivers are "bad" drivers because they lock brakes occasionally!! They lock brakes because they are pulling 6G under brakes with NO ABS not because they don't know how to cadance/ threshold brake!! If you are so skilled can you left foot brake your GTR and downshift clutchless? When you can maybe you could give us all some driving lessons! How is it that someone who has been driving for ten minutes assumes they are great and everybody else is shite?

Point is this. If you don't like ABS, that's fine. Don't buy a car that has it.

But don't tell someone else to do something when you don't know enough about it yourself and, in turn, causing them to be without something they have grown used to over the period they have owned the car.

Go ahead and pull your own fuse out. Don't tell other people to when it could result in someone's loss of life. And if you do advise it, make sure you have the knowledge and experience to tell them what happens when you do.

Hey Duncan well said.  And Morgs do you think Nissan fitted ABS to GTR's just to look after "unskilled" drivers?  No.  The reason they fitted it is because that it is the best system!!  By your estimations Grand Prix drivers are "bad" drivers because they lock brakes occasionally!!  They lock brakes because they are pulling 6G under brakes with NO ABS not because they don't know how to cadance/ threshold brake!!  If you are so skilled can you left foot brake your GTR and downshift clutchless?  When you can maybe you could give us all some driving lessons!  How is it that someone who has been driving for ten minutes assumes they are great and everybody else is shite?

Perhaps you should relax and re-read my and your own statements before coming to such ridiculous assumptions about my driving experience, and stop putting words in my mouth.

I've never had to activate ABS on the road because I am overly cautious.

Or maybe you don't brake hard enough in the first place?

Perhaps what you and I do on the road is a different story.

I did not claim to be the best driver in the world. Perhaps if your comprehension of what am I saying was as good as your 'lecturing' skills then we would get somewhere with this discussion. We are all entitled to our opinions and if you so choose to resort to personal attacks this I will be the bigger man and let you have the satisfaction of letting you have a go....

Sure ABS is the perfect system - theres no argument there. What if a driver steps from an ABS car to a non-ABS car, with the assumption in an emergency that the fastest way to stop the car is to trump the brake pedal onto the floor? See my point now?

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yeah it is always worth testing and balancing actuators out of the box, just set the pressure regulator on a compressor very low (eg 5 psi) and increase it slowly to see when they both move.....unfortunately while you may be able to adjust the length of the actuator rod to minimise any difference, the actual pressure they move from is not adjustable so you need a well matched pair. And yes, the VCAM is probably contributing; the earlier in the rev range they come on boost and the slower the revs build (I think your demo was in 5th), the more you notice it.  Driving at WOT through 1st, 2nd, 3rd etc you will probably never hear it as any shuffling starts and is over super quickly
    • oh they were with that motor, you need to remove the engine to change the spark plugs (don't have to, but it does make it easier)
    • I certainly fall into the annoyed camp, but glad to hear that if it's happening at low boost then I'm not likely going to blow a turbo and end up with metal shards in my oil. Just feels like it prevents me from really driving it without hesitation and "peak" performance. Wonder if it's the VCAM, it did an impressive job of shifting the torque curve and faster spool, but maybe now it's "too fast" and there's too much air for how open the throttle is.  Based on some other threads, will also do some reading on synchronizing the actuators. They are the default actuators that come on the Garrett's and I would think they would be set the same coming from the factory, but if the turbos don't actually work exactly the same way at the same time as previously mentioned, it would be worth making sure the actuators are actuating together properly
    • I went down this rabbit hole before, ended up sourcing a motor from the UK (I'm in Japan) which also didn't function correctly. With the original motor, I disassembled it and reassembled it and it works somewhat, sometimes. What I could deduce from all my screwing around is that there is calibration of the gears on the inside of the motor and two ramps on the main gear which activate switches that operate the motor and move the sunroof either to retract into the roof or tilt. Where I got stuck was that, it seemed in my case that one or both of the switches that are activated by the ramp on the gear did not always activate and thus the motor did not move, causing it to sometimes not retract or tilt (apologies, I've forgotten which way it didn't work.).  Of course this part is discontinued at Nissan now, it's the same part in the S15 but no other models. I also contacted the manufacturer of the component for schematics - forgot the name, they're based in Gifu - but they declined to share the information due to being bound by an NDA, sadly. Looking through my pictures now, it seems I last had a crack at this in 2022. See, I so kindly wrote "open" and "close" next to the switches. If you figure it out, please do tell me. Those little switches, with the red buttons may need to be replaced.
×
×
  • Create New...