Jump to content
SAU Community

Recommended Posts

The Hicas system is uses the pwr steering fluid to run it's system. One of the warnings that you can get with Hicas is low fluid levels, which also means your pwr streering couls also be low (quite probably.) Check fluid and check for leaks around the hoses to the system. Leaks are not uncommon - GTR, GTS 300ZX, etc...

r33gts, I would recommend you first check the power steering fluid as that may cause the heavy steering, and the HICAS light to illuminate.

Alternatively check the connections to the electric HICAS unit behind the diff as some experience heavy steering when it is disabled.

The power steering in the skyline is variable, getting heavier at high speed so it may be some other electronic fault. With that in mind do a diagnostic check on the ecu as well.

  • 1 month later...
i have the same problem buy mine is caused by fitting an aftermarket steering wheel did you fit a aftermarket wheel?

Hey man,

I have an aftermarket wheel and my HICAS light is on 24/7.

Just wondering if yours is on ALL the time aswell or if its only on around corners etc.

Also has your steering become quite heavy since the new wheel?

For those with aftermarket steering wheel and boss kits, HICAS is a common problem.....firstly make sure your Boss kit is HICAS compatible it needs sensors in the boss kit.

Secondly, make sure your steering wheel is on straight......loosen it off again, drive along in a nice straight line say 20m, then pull the wheel off and put it on again. Then repeat until you are certain it is straight. HICAS will report an error if the wheel is crooked since it thinks the car is turning all the time :D

  • 2 weeks later...

Revolution race gear sell the HKB boss kit for HICAS equipped cars. Well they got mine in. My HICAS light comes on sumtimes after 20-30 mins sumtimes not at all. I think my car needs a wheel allignment, as either way i adjust the boss kit one spline either way is still out... Would this cause the light to come on?? There is a HICAS diagnostic isnt there?

Revolution race gear sell the HKB boss kit for HICAS equipped cars. Well they got mine in. My HICAS light comes on sumtimes after 20-30 mins sumtimes not at all. I think my car needs a wheel allignment, as either way i adjust the boss kit one spline either way is still out... Would this cause the light to come on?? There is a HICAS diagnostic isnt there?

yea my hicas light comes on after 20-30 mins driving also.. only really comes on if im a freeway or something..

also running a HKB boss kit with hicas support

Guys you can run a hicas diagnostic by following these steps:

Procedure:

➢ Switch ignition off, transmission in neutral or auto in Park.

➢ Start engine

➢ Very quickly (with a couple of seconds), turn the steering wheel left and right about 20

degrees from centre five times, and then pump the brakes five times, then press the

brake pedal once more this will enter diagnostic mode.

➢ Drive forwards or backwards about 5 metres at a speed less than 10km/hr, this will

enter full diagnostic mode.

➢ The HICAS light in the instrument cluster will be flashing quickly (for normal) or will

flash a code indicating any problems.

➢ Long flash = first digit, short flash = second digit.

➢ Diagnostics will return to normal after five minutes, or any speed over 10km/hr,

or ignition is turned off.

The codes are as follows:

HICAS Diagnostic Codes 1989-1993

1 HICAS solenoid right hand

2 HICAS solenoid left hand

3 Cut off valve

4 Power steering solenoid

5 Vehicle speed sensor

6 Steering angle sensor

7 Neutral position sensor

8 (Auto) Parking brake sensor,

(Manual) Clutch sensor

9 (Auto) Inhibitor switch,

(Manual) Neutral sensor

HICAS Diagnostic Codes 1993-1999

11 HICAS control unit

12 HICAS motor power supply not present

13 HICAS motor output not present

21 Vehicle speed sensor not present

22 Steering angle sensor not present

23 Steering angle sensor neutral or not present

24 Rear main sensor input not present

25 Rear sub sensor input not present

31 Parking brake sensor input not present

32 (Auto) Inhibitor switch input not present

(Manual) Neutral switch input not present

33 Engine speed signal not present

Hope this helps!

My light also seems to come on from time to time. When I start the car it stays on for a couple of hundred meters, then when I tip into conrners it comes on again, and sometimes when I give it a boot full in a straight line. Weird?? I have the standard wheel so I assume the boss kit hasn't been tampered with...

Does anyone know if the light is meant to come on whislt cornering?

  • 1 month later...

After running my R32 GTR in diagnostic mode the Hicas light flashes four times quickly and then the fifth flash is a long one. The Hicas light turns off for a couple of seconds before repeating the above sequence.

I have read the Hicas diagnostic codes above but I am unsure how to interpret them. Any help would be appreciated.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Thank you GTSBoy and MBS206 I have done the compression test with the motor out of the vehicle, reason for the test was to see if I needed to remove the head and do rings etc while its out. I'm in the process of respraying the vehicle and tidying up a few things. Story behind it all is I've just purchased the skyline and it was running when I got it, never drove it on the street though as I wanted to pull it down and do it all up again before registering it. the gentleman I purchased it from told me the motor has a forged bottom end and has a decent tune through it but I was going to pull the sump off anyway to see if it is a forged bottom end. that's why I thought id do a compression test beforehand. 
    • Man, I'm kind of amazed that the price of the turbo has not changed in 7 years. Everything else is inflating beyond reason, but not this? Good on Tao / hypergear I guess? Anyways, good luck with the sale!
    • I'm selling my brand new, in the box, never used Hypergear ATR45 - and I had some additions I paid for a few yrs back when I purchased it. Never ended up having the rest of the money to add all the mods at once, so I just ended up slowly selling each part. I originally had it internally gated, with the dump pipe, however I found it was incompatible with what I was going to use it for, so I contacted (I think Ken) from Hypergear, and he and I messaged back and forth & he got me to ship the turbo back, where they modified it & made it externally gated, and gave me the 5 bolt dump pipe attachment for custom welding. (Photos below) This turbo like I said has never touched the inside of an engine bay, it's completely brand new, never used, been sitting in the same box it arrived in, covered in plastic & all. Below are the photos of it: And while the guys at Hypergear were making it in-shop, they sent me some photos of the process: I'm looking at selling this just because I'm in need of the money right now, and don't have plans on modifying the 34 anytime soon - and from reviews & peformance sheets, this turbo had amazing results back when I was researching. The turbo was purchased in 2018 for $1.9k, with the mods I got added on. Looking at the website now, for the same turbo they sell (ATR45SAT), with the current addons it adds up to $1830 for the turbo Current addons included: - Bolted dump adaptor - Ball bearing CHRA - Braided oil feeding line So I'm looking to possibly sell it for around $1800, with shipping included in that 1.8k, It cost me around $120 to ship - so yeah thought I'd throw it out there and see if anyone was interested in purchasing. Cheers!
    • Turn up your speakers https://youtu.be/5_GK5ChNjOs?feature=shared
×
×
  • Create New...