Jump to content
SAU Community

Recommended Posts

Well here is it again strut brace GB #5 back due to popular demand.

Here is the deal

buy 5 for $60 each

buy 10 for $55 each

buy 15 or more for $50 each

Postage

WA, TAS, SA, VIC = $15 registered post

NSW, QLD, ACT = $10 registered post

Here is the list of strut braces I can get

skyline

R33 front strut brace

R32 (incl GTR) front and rear strut brace

Silvia

s13 front and rear strut brace

ca18 - requires a little mod

sr20

Supra

Fits JZ80 and 70 series front strut brace

Soarar

Fits on soarer twin turbo and non turbo front strut brace

GB will finish up on th 11th of June.

Link to comment
https://www.sau.com.au/forums/topic/74838-strut-brace-group-buy-5/
Share on other sites

  • Replies 56
  • Created
  • Last Reply

Top Posters In This Topic

strut braces have been picked up. $55 each woohoo...

R33 all ready to go. I Will ship them all on staurday.

I have 1 r32 rear. BUt I do have 2 s13 rear which are the same just different hole positions. If you want it I have 2 of them and can sell them for $50.

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Ah! I actually managed to snag a lightly used set.... that aren't so suitable for me right now. They don't work on a GTT without some cutting or creative heat moulding. I thought about reselling them myself cause I didn't want to murder them, but it looks like I'm probably going to attempt to murder them/melt them because I may as well. @GTSBoy @PranK can somebody close this thread?
    • Hey mate,  I have a set, one is slightly damaged but wont be noticable once installed.  Shoot me a message if your still after them 
    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
    • You have a knack for photography my friend. It makes the 86 look like a complete bucket. The 34 went with you to Europe and back. It's special. (we all feel the same about our 'shitboxes' that every bystander seems to absolutely love)
×
×
  • Create New...