Jump to content
SAU Community

  

266 members have voted

You do not have permission to vote in this poll, or see the poll results. Please sign in or register to vote in this poll.

Recommended Posts

I like one of the previous posts about the Turbo Timer

Go set it for 10 mins and lock the car.

Jump in and set to go!

Got me looking now for one.

Be worth the $120 to be able to have a nicely warmed motor.

Particularly after a night shift when I'm straight out the door and into city traffic and duckin' weavin'

No time for warm ups there!

u could do that or u could just get a remote engine starter like me and turn the car on from inside the house and let it idle for a bit

you only really need enough time for everything to be covered in oil. 30sec to a min should be plenty of time. Idling might help with lubing up the engine but the cat doesn't like it and will kill it faster.

Correct me if i am wrong but after everything is covered in oil the only problem is parts heating up (expanding) at differnt rates. So if you wait untill the water is up to temp then the whole block should be nice and warm due to the hot radiator fluid running through everywhere. So once your water temp is up you should be right to have some fun.

Aslong as you don't thrash it for the first few minutes it will be fine.

I usually back out of the garage, and close it (around 30secs) and then take off slowly until i get out of my suburb (3-4mins)

When i start my car however, the oil light stays on for about 2seconds then goes off.. is this normal??

The oil atm is sitting halfway inbetween L and H (on the dipstick)

Just drive straight off and don't boost or rev too much for the first 5 miuntes!!  

If you idle for longer thatn 20 seconds you are:

1. Wasting fuel

2. Increasing pollution

3. Wasting some of your life

4. NOT doing your car any favours.  

 

These are modern cars.  They are made to be driven straight off.

CASE CLOSED

My car won't move if I don't idle it for atleast 1-2mins. It just dies if you put the accel in.

My car is also not stock, so it wasn't "made" to be driven straight off it was made to make more power, handle better and stop better.

Does that mean I'm injuring it and I should try to make it be able to take off in around 20secs?

most oil lights weill stay on for a few seconds. AS long as it turns off and stays off then you should be fine. Aslong as you check you fluids regularly (AS WE ALL MUST) there will be no problem.

Thanks for clearing that up, i was starting to worry!!:P I check it 1-2times a month.

My car won't move if I don't idle it for atleast 1-2mins. It just dies if you put the accel in.

My car is also not stock, so it wasn't "made" to be driven straight off it was made to make more power, handle better and stop better.

Does that mean I'm injuring it and I should try to make it be able to take off in around 20secs?

Are you running an a/m ecu? Your car shouldn't really die if you put your foot down when it is cold.

If you have done any engine mods then warming it up at least a little bit would be a good idea. But the best way to warm up your car is to baby it on the streets.

idle for a minute or so, then take it easy till i see some decent temp, usually about 10 minutes or so. which sucks cause it only takes about 10.5 minutes to get to work!

Sounds like you need to find a longer way to work.

Have you guys had a lok in the car manual (if you got it) I have had a look through a few differnt cars manauals and they all say the best way to get the car up to temp is to drive it normally. They also say that excessive idling with kill your cat(if you have one).

idle for a minute or so, then take it easy till i see some decent temp, usually about 10 minutes or so. which sucks cause it only takes about 10.5 minutes to get to work!

Me too!!

I take a detour when going to work now though. It's still only takes about 15mins, use to take 10.

Yeah, I have a "startup routine" in the morning.

Get in the car and start it up. Then put the belt on, turn off the TCS, and adjust the stereo. Maybe clean out the centre console of the various bits of paper that gather in there.

When I see the revs drop from its "cold idle" 1500RPM and the oil pressure drops from 6kPa, I'll drive it at low RPM and load for a while. Luckily there's downhills away from my street, so I'll just select whatever gear keeps it at the speed limit without using the pedals for as long as I can.

Tend to warm it up atleast until the oil temp stabilises.. once it's there - i'm happy.. it's happy..

not good for any cars to just start up and thrash off, can cause a bit of damage - I think.. might be wrong though..

bit like stretching before going for a run eh! if you don't do it, you'll regret it.. if you do - everything is sweet..

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
    • Yeah - I mean, go the other way. Smaller range. Not larger.
    • To re-cap, I bought: https://www.alibaba.com/product-detail/Lsailt-8G-Infiniti-Q50-Q60-2014_1601171829627.html?spm=a2756.trade-list-buyer.0.0.2cd476e9FTIlKE As you can see, if I bought 20 it was $653, but I bought 1 so it was $1,170. I was very tempted to buy 2 and resell 1 at 25% cheaper. @MBS206, I am not sure if they do a Kluger one, here is their list but it might be there under a global model name: http://www.lsailt.com/product/android-interface?page=1 Keep in mind these full android replacements have basically all the bits a phone does (cpu, ram, storage, wifi, bluetooth, usb interfaces) other than a screen (it uses a host), thus the $800+ cost. Android Auto screen mirroring is MUCH cheaper as it's just a cut down shell, input mirroring and output mirroring BTW I also need that "screen off" feature, it is much harder to see wildlife even if a dash is reasonably dark. Both the Fuga and V37 have display off buttons for night use, they just come back on for a second or 3 if you interact with it, eg skip a song.
×
×
  • Create New...