Jump to content
SAU Community

Recommended Posts

after 6 years of jealosy and yearning for my liner...i finally got it...but theres 1 problem ...my bloody driveway is too steep...scraped the bottom of the lip when trying to get it down the driveway ...now my baby has to sit out in the cold :)

I think its time to get the construction crew in to fix up the driveway...

anybody know any quick fixes to get the car down a steep drivway?...

if so, where do i get the materials to solve the problem....??

Link to comment
https://www.sau.com.au/forums/topic/85565-i-got-my-car/
Share on other sites

Yeh thats what I was going to sugest, planks of wood... work a treat. if they dont work.. then your driveway must be reaaaaaaaaly steep!!

welcome to the car owning side of SAU mate, it was about 4 yrs before I bought my r32 :)

Link to comment
https://www.sau.com.au/forums/topic/85565-i-got-my-car/#findComment-1548968
Share on other sites

sledge hammer :)

but in all seriousness, I have to use planks of wood. if you go to your local bunnings, and buy some offcut 2x4 preferreably 2 bits 1m in length, and lay them down in the gutter.

I only drive my car on the weekend, so it'd not too much hassle, but it'd drive me nuts doing it everyday. If you leave em there, some little pricks might take em.

cheers

Link to comment
https://www.sau.com.au/forums/topic/85565-i-got-my-car/#findComment-1549063
Share on other sites

buy a sheet of that thick checker plate alluminium (Bunnings Dural has them).

Lay that across the front of your driveway, use a hammer drill to drill into the concrete, and use some bolts to bolt the alluminium down. If council complains, unbolt and remove... Then replace when they're gone... :D

Link to comment
https://www.sau.com.au/forums/topic/85565-i-got-my-car/#findComment-1549525
Share on other sites

Thanks for the suggestions guys, ill give the planks of wood a go for now.....its almost impossible to go in on an angle because its such a small driveway, its not the initial gutter im having problems with its the flat bit just before it enters the garage...basically from the gutter its flat, then it goes down on about a 35-40 degree angle then its flat again ..its the bottom section i had probs with...

I'll stick pics up soon, but its pretty much stock looking sII with stock rims ....(next purchase)

Link to comment
https://www.sau.com.au/forums/topic/85565-i-got-my-car/#findComment-1549681
Share on other sites

Need to go side way down.. used to happen to my ex-line with 400R front bar everyday (steep driveway). Just remember to let 1 front wheel reach the ground first then the other.

If still impossible, cheapest way is get a long timber and trim it suit ur driveway. I've seen few tyre shops use this way for customers with LOW cars.

Link to comment
https://www.sau.com.au/forums/topic/85565-i-got-my-car/#findComment-1549916
Share on other sites

IMG_2486.jpg

IMG_2500.jpg

My precious...

Still needs some pretty rims....

I should take it out for a proper fotoshoot when i get them...

Anyway ...thanks for looking ...

ill get a foto of the driveway to explain my dilema properly when theres light...

oh yeah...those halogen lights...is it illegal for me to drive with them on?

Link to comment
https://www.sau.com.au/forums/topic/85565-i-got-my-car/#findComment-1551863
Share on other sites

at my old place my parents bought a sedan that was quite low, couldnt get over the edge going down to the driveway, within a couple of weeks they got construction people in, they jackhammered the concrete down and relaid half of the driveway so it was a smooth angle lol

Link to comment
https://www.sau.com.au/forums/topic/85565-i-got-my-car/#findComment-1552129
Share on other sites

Huge thread (do a search for Driveway Problems) about driveway problems when I first got my Skyline (well after I lowered it :))... I have one bloody steep driveway and if it weren't for the planks of wood, my front bar would be no more :)

Pros for the wood:

1) They are very very cheap, use offcuts from anywhere

2) Quite light and not too hard to setup

Cons for the wood:

1) Not good in the rain

2) Gets bloody annoying when they start to rot away

3) Depending on your road surface, it will start to destroy itself.

My next plan is to get some steel drainage vents (maybe 2m x 1m) which I can mount on top of the driveway as stated above in a previous post. Not only will this get rid of most of the cons, but will also make a nice addition to my shoddy driveway :D

Just some thoughts...

Link to comment
https://www.sau.com.au/forums/topic/85565-i-got-my-car/#findComment-1564870
Share on other sites

Thanks for the suggestions guys, but the real problem isnt entering the driveway from the road, its at the bottom of the driveway. *see attatched* Ive tried reversing it in to no avail.. Close, but no cigar. Anyway, i think the only option is to tear up the driveway and build a new one.

THe red bits on the images indicate where the front would hit if i drove it down front first or reversed it in.

driveway1.jpg

driveway2.jpg

driveway3.jpg

Link to comment
https://www.sau.com.au/forums/topic/85565-i-got-my-car/#findComment-1575619
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • So either way it is gearbox out and look what is wrong?  I know about the input shaft bearing. Even before swap/new clutch the it sounded exactly like this: So is that inout shaft bearing or the other was installed backwards?  And can some please tell me the part number for that input shaft bearing? The gearbox is small box from R34 N/A and number is FS5W71C. Thank you  
    • I am yet to see anyone ever regret a quaife or helical. ...other than drifting/skidpan duties. I kind of want to upgrade my factory helical with a Quaife (but really it's not ultimately that different, and is a MASSIVE UNDERTAKING), that's how good the hype is about them, that I want to try them 'just to see'  
    • D2 and Ksport are essentially the same thing and basically just generic Taiwanese manufacture. Better than ChinaBay crap, but... not top shelf. Öhlins have got to be some of the best dampers around, so likely to be a good option. It's going to get to the point though where I suggest you buy from Oz. We have at least 2x excellent options here. If I were you though, I'd be talking to KW about doing something for the R33. There's bugger all difference between that and the 32. In GTR land, anyway.
    • KW only offers a set for the R32 GTR. Popular options are D2 racing, Ksport or Öhlins. I have a D2 Racing coilover set, though I don't know for sure which one.
    • Well, the good news is you have more than one very good option for new coilovers in and around your country. Worth the drive over to KW to talk about GTR stuff.
×
×
  • Create New...