Jump to content
SAU Community

Recommended Posts

  • Replies 294
  • Created
  • Last Reply

Top Posters In This Topic

i so regret having missed out on this dyno day.

had a family gathering i had to go to. judging by the photos and everybody's comments in this thread, i shoulda pulled a sickie on the family gathering and gone along to the dyno day to be with my *preferred* family!

nice work will and the boys at boostworx! nice photos too ;)

Come on you R33 Girls... Post your dyno sheets. :)

Yeah! I want to see what torque figures you guys where making out of the RB25's for comparison with my RB20

I'll post mine when i have it on me and a scanner is near by......besides i only got 1 run cos it was leaning out over 5,500, God Damn. I think everyone was having some form of issues on the day!!!!!!

Yeah, allot of people where down on power from what I saw. I think, typically, Boostworx dyno is down a bit compared to others. The dyno room doesn't get good airflow, so the air your car is sucking in isn't the most productive for power, especially on a dyno day where you get lots of cars in and out

Yeah, allot of people where down on power from what I saw. I think, typically, Boostworx dyno is down a bit compared to others. The dyno room doesn't get good airflow, so the air your car is sucking in isn't the most productive for power, especially on a dyno day where you get lots of cars in and out

Yeah i would agree chris, it was pretty muggy in the workshop compared to outside, my car was also slightly down on power to what it usually runs.

Yeah i would agree chris, it was pretty muggy in the workshop compared to outside, my car was also slightly down on power  to what it usually runs.

Even though the runs where performed in shootout mode, that cannot factor in the lack of oxygen in the air, its only a air temp correction, so I wasn't surprised that most where down a bit. Its all relative though, as we all ran on the same day in the same conditions, on the same dyno etc

Nice run of yours, bit of a hard act for me to follow straight up afterwards with the ol RB20 :rolleyes:

Yeah! I want to see what torque figures you guys where making out of the RB25's for comparison with my RB20

Keep in mind the torque figures displayed on a chassis dyno are only comparable if the gear they were run in and the diff ratio are identical.

I'm not 100% sure of the gear and diff ratio differences (if any) between R33 and R32s.

I had runs done in 2nd and 3rd gear, and obviously the ones in 2nd gear showed higher torque figures, due to greater torque multiplication.

Keep in mind the torque figures displayed on a chassis dyno are only comparable if the gear they were run in and the diff ratio are identical.

I'm not 100% sure of the gear and diff ratio differences (if any) between R33 and R32s.

I had runs done in 2nd and 3rd gear, and obviously the ones in 2nd gear showed higher torque figures, due to greater torque multiplication.

I think comparing R32/33 runs should be pretty similar, I think there are very minor differances between the two in 4th gear

Keep in mind the torque figures displayed on a chassis dyno are only comparable if the gear they were run in and the diff ratio are identical.

I'm not 100% sure of the gear and diff ratio differences (if any) between R33 and R32s.

I had runs done in 2nd and 3rd gear, and obviously the ones in 2nd gear showed higher torque figures, due to greater torque multiplication.

Chops, can you post your dyno run? I'll do the calcs to compensate for your diff ratio, just so I can compare how the N/A 5.7ltr looks against an rb30det.

Edited by Cubes

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
    • Also playing with fire if they start to flow more air down low than what the stock twins can. It's not even up top you need to worry, it can be at 3000rpm and part throttle and it's getting way more flow than it should.
    • Any G40/1000 or G40/1250 results out there?  
    • You still want a proper tune on the stock ECU though. Stock tune + stock ECU with GT-SS/-9s is probably playing with fire if you're running more than stock airflow/power.
×
×
  • Create New...