Jump to content
SAU Community

Recommended Posts

Thanks buddy....

I got a set of semi slicks last night so ill be heating those babies up!!!

Any tips??

I dont know, i havent ran mine yet those RA1's.

Give it plenty of revs, ease out the clutch and then slam those gears. I wanna see a 12.

I dont know, i havent ran mine yet those RA1's. 

Give it plenty of revs, ease out the clutch and then slam those gears.  I wanna see a 12.

Id love to see a 12... i know the car is capable, it will just be the driver that isnt!!!

Didnt have a very good night at all....

Ran a 13.8 best time and had about 12 runs!!

As stupid as it sounds i must have been backing off before the end because mid track i was really moving but by the end the numbers just didnt work out...

I ran another R33 a few times, only mods he had were exhaust, cooler, safc and .8 bar boost... pulling 190rwkw!

It was good to compare, here was one of our runs:

Me:

60ft 2.375

660ft? 85.41

Et 13.813

Mph 105.38

Him:

60 Ft 2.436

660ft? 78.35

Et 14.157

MPH 105.55

As you can see I had a better 660 ft? or 1000ft time not sure which one it was but he had a better ET.... it doesnt make sence...

That was a bad run for me, i had a best of 2.1 60ft and 660 or 1000 ft of about 87mph but the Et was never under 13.8 sec??

Any suggestions? I think im going to have to go down again soon and this time keep the power down after the time posts and beyond!

The car seemed drive fine and pull really hard... mid track it was really moving compared to other R33's....

Any help is appreciated guys..

Cheers

Edited by silva33

It was my first time and by the time i realised i may be backing off short it started to rain... so i guess i wont know till i run again which will be soon!!! but im positive i could see the time flash before i backed off...

Then again i didnt keep an eye on the boost guage so who knows, it may have been a boost problem!

Anyway, ill have to wait and see on the next Calder trip!

Edited by silva33
With 105mph, it doesnt seem like you were backing off. 105 is good for very low 13s or high 12s...

60ft time seems to be your problem considering you were using slicks. Practice your launches :D

105 isnt bad but i was running another R33 GTST with stuff all mods and he was getting higher ET's... the figures dont add up as he only has 190rwkw and i have 244 rwkw!! surely my ET would blow him away even with a worse 60ft time... i also had a better 60ft time and got a 13.8 where he go a 14.1 and his MPH was still better!

Mid track my Speed way quite a bit higher than his and by the end he was just faster than me... so there is either something wrong with the car or i was backing off becasue i was redlining every gear....

I would have expected a mid 12 with a good 60ft and at least a 110mph pass...

It was my first time and was great fun so im going to head down soon to get me that 12 and learn how to launch her!

Edited by silva33

Definately you where backing off with 85mph half track, my best was 89mph half track and i finished with 113mph. I've done it before as it doesnt really show you where the finish line is as there are 3 sets of lights.

Might head down with you if you wait a few weeks and im planning on a real low 12 or even possible 11

yeah somethings not right seeing as my gfs soarer with nothing but a catback and pod ran a 13.8 and my R32 with stock cooler, stock engine and just 14psi, ecu tune and exhaust ran a flat 14... all with crappy street tyres.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Hi...so a "development" here aswell The swap is "done" and car went "test drive" BUT it seems the clutch(maybe gearbox?) is a little bit sad? I bought this clutch kit https://justjap.com/products/xtreme-heavy-duty-organic-clutch-flywheel-kit-nissan-skyline-r31-r32-r33-push-type "Problem" is that the first gear is hard to put into and it seems that the clutch is not disengaged. It was not the problem with the old clutch...(or like sometime the first gear would not get as easy specialy when the fluid was cold) So? Can it be like...bad "install" or is the clutch wrong ((it should not have been) i done research to get the right one) Or is this "normal" with new clutch and needs to be break in? 
    • @Duncan I can try  and thanks i did not thought about VIN and part numbers for 33/34. @GTSBoy yeah it looks like iam gonna do that  
    • Forgot to include this but this is the mid section of my steering rack that looks like it has a thread/can be turned with that notch mentioned in the post:
    • Hey everyone, Wanted to pick some brains about this issue I'm having with rebuilding my 33 rack (PN is 49001-19U05). All of the tutorials/videos I've seen online are either R34 or S Chassis racks which seem to be pretty straightforward to disassemble but this process doesnt carry over to my rack. Few of the key differences that I've noted The pinion shaft on the other racks bolt on with 3 torx bolts: Whereas my rack bolts on with 2 allen head bolts: These changes are pretty inconsequential but the main difference is how you pull the actual rack out of the housing. The other skyline/s chassis racks can be taken out by tapping the rack out of the body with a socket and it just slides right out. I'm unable to do that with my rack because there's a hard stop at the end that doesn't let the seal/shaft be tapped out. Can also see a difference in the other end of the rack where mine has a notch that looks like you're able to use a big wrench to unthread 2 halves of the rack whereas the other racks are just kinda set in with a punch. My rack: Other racks: TLDR; Wanted to know if anyone has rebuilt this specific model of steering rack for the R33 and if there were any steps to getting it done easier or if I should just give this to a professional to get done. Sorry if this post is a bit messy, first one I've done.
    • I would just put EBC back on the "I would not use their stuff" pile and move on.
×
×
  • Create New...