Jump to content
SAU Community

Recommended Posts

  • Replies 40
  • Created
  • Last Reply

Top Posters In This Topic

I was hoping there won't be any charge actually, should be, well hope it to be part of their after sales service, hope that this type of thing still exists.

I know my tuner in Melbourne always gives me aftersales service & I always go back to him and recommend others.

Hope all tuners out there adhere to the same principles

Edited by WetGTR

I hope they look after him as well.

My car has gone back after initial ecu install at least ten times ( one occasion they used 120 litres of fuel and 15 sets of plugs) with niggling dramas and I have never received an invoice. Top guys. But to be fair they were not the cheapest workshop out there but its paid off with the phenomenal after sales support.

If your initial tune was dirt cheap I dare say they mapped for outright power/safety and not much else. Going back asking for economy might incur a bill. As the saying goes you get what you pay for. Good luck.

I'd be very suss about that fuel economy level. Take a look at what I have. Ive used your template as we have similar mods.

List of Upgrades:

1) T04e 460hp Turbo

2) Wolf3Dv4

3) Walbro fuel pump

4) Stock Injectors

5) Fuel Pressure Regulator Malpassi

6) No AFM (Wolf Map Sensor)

7) 240rwkw

If I drain the tank to pretty much empty I'll get 400km a tank. However, this is quite conservative driving.

i understand all the thoughts going round, but i will be taking the car back to the tuner... as for getting what you pay for, i paid $700 for the tune which is not that cheap.... hopefully he will come up with something and maybe ill get same if not more power with better fuel economy.

Go and speak to your tuner - he tuned the car, so he should be the best person to diagnose what's causing your bad fuel economy (presuming he's a decent tuner) and therefore hopefully rectify the problem as a result.

It's not un-common for tuners to have to perform a bit of a 'touch up' after an initial tune. They can't always get it 100% right first time after a dyno tune as obviously normal street driving can dish up a number of different driving conditions as opposed to the constant conditions on a dyno.

You have to also remember that your tuner isn't a mind reader. You need to speak to him so he can understand exactly what you're after. If you told him to tune for maximum power, then he probably predominantly concentrated on your top end power. You do have standard internals (I think), so your tuner was probably being safe by running the car a little rich in the top end. Presumably, he didn't pay as much attention to your light load AFR's (which he probably should have done regardless of whether you told him to or not), so they're probably a little rich as well. If that's the case, he should be able to pull some fuel out there which should improve your economy as that's where the majority of your daily driving probably occurs.

Good luck. Let us know how you go.

yeh will do guys, i havent had a chance to speak to him yet, but i will be having a chat, i think he has run it a little rich to be safe, but i dunno if he meant it to be as rich, it has a bad flat spot at about 2000rpm, which i thought at start was just the huge GT30R, but now its become obvious it just a fuel prob....

ill keep u guys up to date

Query: Did you reset your ECU after the addition of the new aftermarket parts?

If not, do so, it might help somewhat. From what I understand, you should always reset the ECU after adding new parts. And you wont 'lose your tune' that you just paid for, as such.

Hope that helps?

Brendan

I dunno what's with my car then, but I get better fuel economy when I thrash it for the first 1/3 of a tank or so...just seems to burn more efficiently or something. Again, my R is fairly standard (310ps @ 1.0 bar), but if I drive it like a nanna everywhere, i'm lucky to 430km's to the tank. When I give it stick everywhere, I get 470....Go figure.

Maybe there's something odd about the way my car is setup *shrugs* I have a mines ecu, pretty sure there's an aftermarket fuel pump in there but dunno what as it came over from Japan like that.

Hope your car gets fixed up soon though :O

something else to consider for bad economy

ive been getting approx 350 ks to a tank

when i got my new fuel pump fitted, foudn out that my fuel lines were perishing and that there was a fuel leak!

if u got an old car, its worth checking out

ive replaced a heap of piping now due its age;

hmmmm its gooood!! :)

Nice to hear that he didn't charge.

I think its a good idea to always try discussing your problem if your not happy with something. At least it gives them a chance to discuss it.

What the worst that can happen....they do nothing, your no worse off.

If your still not happy, go back again. Same situation as above.

Hope all it well now and keep us up-dated.

thanks guys, seems ok now, i think he just fine tuned it a little more...

as for those leaking lines, i wudnt mind knowing where abouts i should look, as i have already replaced the lines from the fuel filter to the rail and just before the filter.

i would say from the pump as he was installing a new pump for me

i could always smell heavy petrol reversing up my driveway, but thought it was due to our lines running so rich

never noticed any leaks

could never smell petrol when the car was left over nite in the garage

Edited by Spooks_Skyline

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Hope you aren't too sore after that one, might take a day or 2 to notice yet and I guess it is a loooooong drive home. On the bright side, tube frame front end is a thing at superlap, right?
    • https://www.facebook.com/share/p/18rmVb1SKB/ 
    • The chart of front pressure to rear pressure (with one being on the x axis and the other being on the y axis) is not a straight line on a typical proportioning valve. At lower pressures there is a straight line with one slope, and at higher pressures that changes to a lower slope. That creates a bend in the line at that pressure, called the knee point. If you do not change the proportionng as the pressure gets higher, you will suffer excessive pressure (at one end of the car or the other, depending on which way you look at the proportioning action) and then get lockups at that end. The HFM BM57, from my memory of previous discussions, is based on the BM57 from a different car (to a Skyline), with a different requirement for the location of the knee point and the distribution of pressure front to rear, and so is not a good choice for an upgrade on a Skyline. Here's a couple of links to some old posts, one from here, one from elsewhere. A lot of it pertains to adjustable prop valves, but the idea is the same. There are plenty of discussions on here about this issue from al the many years of people wanting a cheap/accessible option. https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/ https://grassrootsmotorsports.com/forum/grm/learn-me-brake-proportioning-valves/236880/page1/  
    • Yeah dunno why johhny posted that here with no context, just post on FB/insta bro where he put it up?  Laine had an off at T4 during Thurs prac, he's ok, car is less than perfect, they are done for the weekend, he can fill in the rest. Bando also binned it like 100m up the road.   
    • I feel there must have been a FB/insta post and the weekend did not start well at all I hope everyone is all okay
×
×
  • Create New...