Jump to content
SAU Community

Recommended Posts

with your usb/serial adaptor you should have drivers that come with it, that when installed will make a virtual com port (usually com4). is the issue that its not showing up as a com port at all? or that its showing up as somelike like com5+?

see attached image about how i can change my settings with my one via the control panel->system (device manager) thing, if thats what you're after

post-4553-1132365696.jpg

Edited by NewKleer
  • Replies 91
  • Created
  • Last Reply

Top Posters In This Topic

the com port dropdown (in calumsult) should list available com ports in it?

The usual painful com port problems, I never have any joy with them.

Have to restart the laptop every time I try something, so time consuming.

Plus the batery is now flat.

I can't get the Calumsult to see the ECU. Just to check that the interface is working OK, I have;

Solid red LED

Bright yellow LED until engine is running, then it goes dull, with an accasional flash

Green flashes at all times when the engine is running

:P cheers :D

Edited by Sydneykid

once ive confirmed more are available (hopefully tonight or tomorrow), just pm me when ur sure about order - payment is as stated in the first post, either bank deposit or paypal - if u dont use internet banking then u can go into whichever bank is more convenient (stg/anz, let me know in pm) and ask to deposit money into the account (with details i give you).

then ill normally get the money by the next day (as long as its done before end of previous business day) and can normally send it out that day (or the next) and you should receive it the following day (if ur inside express post network). advantage of paypal is its instant and would mean if its done early enough in the day, that i can send it out that day

2 will be $94 (if sent to same address) or $97 with paypal

Edited by NewKleer
I can't get the Calumsult to see the ECU.  Just to check that the interface is working OK, I have;

Solid red LED

Bright yellow LED until engine is running, then it goes dull, with an accasional flash

Green flashes at all times when the engine is running

theoretically (and checking with a bench ecu):

red on, green/yellow off (doing yellow wire bypass in construction)

open calumsult, choose com4 and click open com port - yellow and green flash then go back off (getting ecu number)

switch to gauges screen, turn switch to on, and yellow flashes once, then green is on constantly

some more kits are available now, see the main post

my brothers gonna have a shot at constructing some, if that goes well then assembled ones will be available for those who dont wish to construct them themselves - no promises yet though (depends how long they take to construct etc). if that goes ahead, id guess around $70 for those

thanks! thats just what i always wanted :(

now if only i had a consult capable car! (im casually looking at the moment now for something cheap with a consult capable sr20det/rb20det so i can get some more exciting projects going)

Edited by NewKleer

I'd like a pre-constructed one ASAP please, when/if you can organise it. I am happy to pay a little extra if you can get it to me very soon :) Thanks.

theoretically (and checking with a bench ecu):

red on, green/yellow off (doing yellow wire bypass in construction)

open calumsult, choose com4 and click open com port - yellow and green flash then go back off (getting ecu number)

switch to gauges screen, turn switch to on, and yellow flashes once, then green is on constantly

Thanks for the extra bits, it now works perfectly.

:) cheers :D

I'd like a pre-constructed one ASAP please, when/if you can organise it. I am happy to pay a little extra if you can get it to me very soon :D Thanks.

ive got a new group buy thread for a limited number of assembled interfaces. at this stage i hope to have 10 available, but obviously demand for these vs kits will determine how many of the 20 (in which 10 are listed as up to number 32. here) will be available for each

ive added u to list in that thread, ill let u know when the first is available, should be sometime this week. if you want to make payment before its confirmed (one is ready, but needs cable done), then pm me with bank preference (if any) and ill pass on dd details.

Peter

my pre-made consult arrived today - not even 24 hours after ordering it. Amazing service, and an amazing product. Awesome work!!!! EVERYBODY NEEDS one of these!

sent a couple more out today, only a few left now.

note that after 33., there may be up to 2 more, but then thats it - ive got no plans at this stage of extending the group buy any further.

excellent to hear!

seems i underestimated everyone here, as i guessed that maybe 1/3 to 1/2 of the people who get a kit would have some issue with construction they wouldnt be able to figure out, but overall its gone quite well :D

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Back again. I returned to Japan in Jul/Aug to spend time with the car on my birthday and remind myself what all the sacrifice and compromise is for. It happened to line up with the monthly morning meet in Okutama, which I have been wanting to go to for a long time. It's a unique event at a unique spot with really rare, interesting, and quirky cars. It's where all the oldheads and OGs gather. The nighttime scene at DKF certainly has its place and should be experienced if you're into cars, but there's too much bad attention and negativity around it now. IMO the better time is Sunday morning at DKF or Okutama; it's more chill and relaxed. I'm glad I was finally able to go, but not sure it's worth the drive from all the way from Nagoya immediately the day before, unless I was already staying in Tokyo for the days right before the meet, because you have to wake up quite early to make it in time. Funnily enough though I didn't drive the car all that much this trip because it was just too damn hot. While there were zero issues and running temps were nominal and the A/C was strong, RBs already run crazy hot as it is. Sure, it took it all like a champ but something about driving these cars in the ridiculous heat/humidity bothers me and makes me feel like I'm asking too much of it. I'm just me being weird and treating the car like a living thing with feelings; I'm mechanically sympathetic to a fault. Instead I was mainly driving something else around - a KX4(silver) 2001 X-Trail GT, that I acquired in May. There's a few different flavors to choose from with Xs, but visually it's the Nissan version of the Honda CR-V. Mechanically it's a whole different story as this, being the top-trim GT, has an SR20VET mated to a four-speed auto and full-time AWD! It was a very affordable buy in exceptional condition inside and out, with very low mileage...only 48k kms. Most likely it was owned by an older person who kept it garaged and well-maintained, so I'm really happy with how it all worked out. It literally needs zero attention at the moment, albeit except for some minor visual touch-ups. I wanted something quirky, interesting, and practical and for sure it handily delivers on all three of those aspects. I was immediately able to utilize the cargo and passenger capacity to its full extent. It's a lot of fun to drive and is quite punchy through 1st and 2nd. It's very unassuming -in the twisty bits it's a lot more composed than one would think at a glance- and it'll be even better once I get better tires on it(yes, it's an SUV but still a little boat-y for my liking). So...now I have two golden-era Nissans in silver. One sports car and one that does everything else; the perfect two-car solution I think👍 The rest of the trip...I was able to turn my stressed brain off and enjoy it, although I didn't quite get to do as much as I thought. I did some interesting things, met some interesting people, and happened into some interesting situations however, that's all for another post though only if people really want to know. Project-wise, I went back to Mine's again to discuss more plans and am hoping to wrap that up real soon; keep watching this space if that interests you. Additionally, while working in the tormenting sweatbox that is the warehouse, I was able to organize most of the myriad of parts that my friend is storing for me along with the cars, and the 34 has a nice little spot carved out for it: And since it can get so stupid hot in there, that made it all the more easy -after I was standing there looking at the car and said 'f**k it'- to finally remove all the damn gauges that have mostly been an eyesore all this time. Huzzah. The heat basically makes the adhesive backing on the gauge mounts more pliable to work with, so it was far less stressful getting this done. I didn't fully clean it up or chase the wiring though; that will happen once I have the car in closer possession. Another major reason to remove all that stuff is to give people less reasons to get in my car and steal s**t while it's being exported/imported when/if the time comes, which leads us to my next point... ...and that is even though it's time in Japan is technically almost up since it's a November car and the X would be coming in March, I'm still not entirely sure where my life and career is headed; I don't really know what the future looks like and where I'm going to end up. I feel there's a great deal of uncertainty with me and as a result of that, it feels like I'm at a crossroads moreso now than any point in my life thus far and there are some choices I need to make. Yes, I've had some years to consider things and prepare myself, however too much has happened in that time to maintain confidence and everything feels so up in the air; tenuous one might say. Simply put, there's just too much nonsense going on right now from multiple vectors. Admittedly, I'm struggling to stay in the game and keep my eyes on the prize. So much so in fact, that very recently I came the closest I ever have before to calling it quits outright; selling everything and moving on and not looking back. The astute among you will pick up on key subtext within this paragraph. In the meantime I've still managed to slowly acquire some final bits for the car, but it feels nice knowing there's not much left to get and I'm almost across that finish line; I have almost everything I'll ever want for my interpretation and expression on what it is I think an R34 should be. 'til later.
    • Thanks for that, hadn’t used my brain enough to think about that. 
    • Also playing with fire if they start to flow more air down low than what the stock twins can. It's not even up top you need to worry, it can be at 3000rpm and part throttle and it's getting way more flow than it should.
    • Any G40/1000 or G40/1250 results out there?  
    • You still want a proper tune on the stock ECU though. Stock tune + stock ECU with GT-SS/-9s is probably playing with fire if you're running more than stock airflow/power.
×
×
  • Create New...