Lazy-Bastard

Starcorp Impuls......I like them personally, but not in chrome.

It's also been prepped and painted. Do you think that comes for free?

You don't know when to admit defeat do you. That's OK though....you are providing everyone with a good laugh. You have been undeniably exposed as a wanker and a bullshit artist, but you continue with your pissweak attempt to save face. You obviously have no shame, or no brain.....probably both. Carry on......I'm loving it

I have neither the time nor the inclination to stalk a loser like you. But I will flame you when you give crap advice, which seems to be quite often, so be prepared. You already made a fool of yourself in the fabrication thread and have been caught out lying about your age and occupation. I'd quit now before you lose even more face.

keep digging mate...... you're a classic

Again with the bad advice......give it a rest

You are a wanker.....stop giving bad advice! And stop bullshitting. It serves no purpose and makes you look like a knob! Mods....apologies for the whoring

So you started there when you were 12? Your profile says you are 20 years old, so you must have done a speed degree ....or is that bullshit as well?

Well it wouldn't secure if you didn't so that's a mute point. I hope for the best, but plan for the worst.....It's always safest What are you smoking?....a weld in fitting is flush inside the pipe They're called Nylock nuts mate.........So are you a qualified aircraft engineer??? I thought they were called aeronautical engineers anyway

I can think of 2 good reasons NOT to use that method. 1. You have created a restriction (however small) in your inlet piping. 2. Imagine if that nut ever came off!!! You could kiss your engine goodbye! I hope you used a nylock nut at least....

Very sexy car! Good luck with the sale.

I bought some piping recently that had a thread welded in. I just bought a brass nipple from Autopro and screwed it in with a few turns of plumbers tape.

re-route the BOV return piping to your new BOV if it's a plumb back. If it's an atmo venting BOV then block the return.

BOV return pipe

Either StockyMcStock or Macguiver is running a twin charge system, maybe get details from whichever one it is.

Children for sale!

Sounds like speculation to me.......

P.S. I was woken this AM at 3.30 rather than the usual 4.30, hence I am a lil narky

Do you actually have any runs on the board anywhere? or do you just like to speculate as to how you will perform?

lolz.....you could probably own all on a mtn run in a f**king Barina That said, as you know I don't go 10/10ths on mountains.......bring it to QR!

I sense some tension......

EXACTLY!! If they are the same as standard WRX seats, I HATE them. They get so uncomfortable on a long drive (anything over 1 -2 hours). I don't know about GTR seats, but standard GTST seats are much more comfortable. I can do Bris to Syd with only fuel stops in the GTST with little to no discomfort, whereas in the WRX my arse and hamstrings are hurting after about 200k's.

1. Why is this in FI? 2. SECURITY - For someone who until today, was promoting Sliding Performance in their sig, you sure are quick to turn sides...people are so fickle these days.... 3. What is it with everyone getting all litigious these days. FFS, this isn't the U.S (thank fark). Talking it out usually results in a better outcome for everyone. 4. I'm willing to bet if you (SECURITY) hadn't started this thread that Sliding Performane would have been happy to honour your warranty (I suspect they still will if you go about things in a reasonable fashion). Not having a go or taking sides.....just a commentary.

rofl

Thanks Dale. Trader feedback left