Jump to content
SAU Community

Recommended Posts

Plan on taking our extensively enhanced GTR R34 to Tassie for a short trip. As there is no 98 octane fuel available there it has been suggested to lower my boost to say .8 bar ( currently it is configured through an Apexi AVC-R boost controller at 1.2 bar) and use a good octane booster with premium fuel (95 octane) which is available over there.

Any one had any experience or comments re the suggestion ? I'm presuming these octane boosters work.

Of course being a retiree the beast probably won't even get to its boost parameters (chuckle). What am I saying! I lie.

post-25792-1136464128.jpgpost-25792-1136464009.jpg

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/
Share on other sites

octane boost is good, only use it if you have to... e.g. when your using 95 or when ur gonna race someone :D

i've used it before and yes i feel the extra boost not much but it works magic :) cheers hope that helps

also the come in different brand but the all work the same u wont notice the difference in brand unless u put it on a dyno and you wouldn't wanna waste ur time seeing which one is better they all do the job. :)

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1839782
Share on other sites

Be careful using octane booster! I, personally will never use it again!

Recently I had to use octane booster due to the lack of 98 ron fuel. Not long after using it my car developed a 'miss' during idling and acceleration.

After taking the car to my mechanic, the spark plugs were removed and had to be replaced. As soon as my mechanic saw the condition of the spark plugs he knew that I had been using octane booster and hadn't told him.

Rarely do I drive the car hard as I value my licence and my car too much! Not sure how common this kind of thing is, but just thought I would let you know of my experience with octane booster and why I will never use it again!

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1840016
Share on other sites

I'm pretty sure octane booster only adds 1/10th of a RON...so you can go from 95 to 95.1 if you add a bottle....not good enough.....

Also AFAIK there is only 95 octane at one place in Hobart and that won't get you around the whole state.

At targa we run 98 octane, nothing special, but we have to get it trucked around the state it drums.

I reckon the best thing to do is turn the boost as low as you can, and retard the timing a few degrees, I'm sure Ali can give you a hand.

Maybe post up in the Tassie section and see how thsoe guys are doing it? Its a great place for a driving holiday, enjoy!

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1840031
Share on other sites

It says on that pretty spec sheet that it's running a Powerplay-tuned ECU.

Best bet is to call Alistair and ask him what fuel he tuned it to... Hopefully he tuned it on 95 for safety, but if he tuned it to 98, just turn the boost down a bit like you planned, and she should be fine. If you're REALLY worried, get the timing retarded a bit.

Forget those octane boosters. They don't work and just foul your plugs.

edit: Damn you Dundan, stop copying me :D

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1840283
Share on other sites

Hmm.. wasn't aware of the fact that tasmania is so removed from the rest of australia and doesn't have 98RON.. was thinking about doing a road tour down there..

What do all the Tassie people do for fuel?

I'd check what they say in their little forum area. Good luck - let us know..

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1840296
Share on other sites

After taking the car to my mechanic, the spark plugs were removed and had to be replaced. As soon as my mechanic saw the condition of the spark plugs he knew that I had been using octane booster and hadn't told him.

maybe you need to run hotter plugs.

octane boost will give a brown layer of crap over your spark plug tip. it will eventually need to be replaced but it wont immediately effect a decent set of spark plugs.

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1842011
Share on other sites

As Duncan said above, octane boosters only raise the octane level of fuel one or two tenths of a point (0.1 to 0.2) at best. They are a waste of money and would be better sending the $20 or $30 on regular fuel instead, whilst running less boost and not loading the engine too much. Retarding the timing is the best insurance against detonation.

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1842501
Share on other sites

what a lovely looking car. not bad for an old retiree. much better choice than a tinny and a caravan. hehe. very nice taste indeed!

duncan, andrew and nxtime have the right idea. octance booster can cause more trouble than it's worth. start with a full to the brim tank (of 98ron) before you hop on the ferry then try and fill up when you still have half a tank left. that should effectively give you a full tank of 96.5 octane (plus you have been able to use half a tank of 98 in the meantime). do the same again at half tank and you get a tank of near enough to 96 octane. after that, you are down to pretty much straight 95. which should be fine on your low boost setting. just keep a little eye on your MFD for anything abnormal, and have fun.

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1847794
Share on other sites

maybe you need to run hotter plugs.

octane boost will give a brown layer of crap over your spark plug tip. it will eventually need to be replaced but it wont immediately effect a decent set of spark plugs.

I had NGK spark plugs in it, almost certain they were NGK iridium spark plugs, aren't they supposed to be good?! Are there better plugs?

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1849704
Share on other sites

Guest Mashrock
eh? Tassie has the best driving roads in Aus.

And I'm sure that with standard boost and a few degrees timing retarded you will still be able to get to the speed limit ok......

they have speed limits in tasmania?

p.s. say hi to uncle chop chop for me

Edited by Mashrock
Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1850647
Share on other sites

From the BP web site..............

2. How can I boost my octane?

The octane of a fuel can be boosted by adding proportions of a higher octane fuel. Also available is toluene, which can be used as an octane booster in both unleaded and leaded fuels. Generally each 5% addition of toluene will increase the fuel's octane rating by one number. It is not recommended to add more than 30% of toluene to the fuel. Because of the dangers with incorrect mixing, individual motorist are advised against mixing additives with fuels without first consulting their car engine manual or their fuel supplier.

So check with the Tassie guys where you can get toluene.

:P cheers :D

Link to comment
https://www.sau.com.au/forums/topic/100810-octane-booster/#findComment-1853026
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • The oil pressure sensor for logging, does it happen to be the one that was slowly breaking out of the oil block? If it is,I would be ignoring your logs. You had a leak at the sensor which would mean it can't read accurately. It's a small hole at the sensor, and you had a small hole just before it, meaning you could have lost significant pressure reading.   As for brakes, if it's just fluid getting old, you won't necessarily end up with air sitting in the line. Bleed a shit tonne of fluid through so you effectively replace it and go again. Oh and, pay close attention to the pressure gauge while on track!
    • I don't know it is due to that. It could just be due to load on track being more than a dyno. But it would be nice to rule it out. We're talking a fraction of a second of pulling ~1 degree of timing. So it's not a lot, but I'd rather it be 0... Thicker oil isn't really a "bandaid" if it's oil that is going to run at 125C, is it? It will be thicker at 100 and thus at 125, where the 40 weight may not be as thick as one may like for that use. I already have a big pump that has been ported. They (They in this instance being the guy that built my heads) port them so they flow more at lower RPM but have a bypass spring that I believe is ~70psi. I have seen 70psi of oil pressure up top in the past, before I knew I had this leak. I have a 25 row oil cooler that takes up all the space in the driver side guard. It is interesting that GM themselves recommend 0-30 oil for their Vette applications. Unless you take it to the track where the official word is to put 20-50w oil in there, then take that back out after your track day is done and return to 0-30.
    • Nice, looks great. Nice work getting the factory parts also. Never know when you'll need them.
    • Thanks @jtha7 I will have a look around tomorrow but it is a prick of a spot. These are some photos i tried taking 
    • I take it that the knock retard is from bearings tapping a little tune? Thicker oil is a fragile bandaid. You need a much bigger oil cooler and probably the bigger pump being discussed.
×
×
  • Create New...