Jump to content
SAU Community

Recommended Posts

G_day mate

I use Mobil 1 5w-50 its 65.99 at autobarn

If you buy a oil filter and pod ya get 15% off

i got a pod on special for $30

oil filter for$8

Mobil 1 oil $65.99 gran total of $104 all that for $88 worth a look mate.....

  • Replies 92
  • Created
  • Last Reply

Top Posters In This Topic

you have to remember that alot of people don't just baby their cars but regularly thrash them either drags/drift, general spirited driving...

and australian conditions are pretty warm compared to the USA where it snows in winter thus we can use thicker oil.

In USA they do have summer too. Places like Texas or New Mexico are pretty damn hot during some part of the Summer.

trex101... you seem to know your oil...

do you recommend motul 4100 turbolight 10w 40?

Motul 4100 is semi-synthetic, i couldn't find it's product data sheet so i don't know how's it cold flow or HTHS. IMO, i would choose a oil with good startup flow (depend on ambient temp) and high HTHS, how you know the figure? Check out it's product data sheet.

what is the viscosity range of the motul 300v ?

The 300V range has quite a few viscosities to choose from, but the 300V chrono is 10W-40

here's the list:

300V LE MANS 20W60

300V COMPETITION 15W50

300V CHRONO 10W40

300V POWER 5W40

300V POWER RACING 5W30

300V HIGH-RPM 0W20

300V 4T COMPETITION 15W50

300V 4T SPORT 10W40

300V 4T FACTORY LINE 5W40

see -> http://www.motul.com.au/product_line_up/4s.../4stroke01.html

In USA they do have summer too. Places like Texas or New Mexico are pretty damn hot during some part of the Summer.

yes, but those people that live up north close to canada don't have to worry about very hot climates and so would choose an oil that is suitable for very cold conditions and moderate temps.

People living in hotter average climates will choose a slightly thicker oil to match the average temps.

You can't expect people to change oil depending on what season it is, you just chose something that suits the average tempreture and driving style of where they live- you don't have to be exact with the viscosity, as long as the oil is good quality, changed regularly and is 'about right' with the viscosity, its good enough. :bunny:

I use Mobil Synth S 10W40.

Used it in my rotor, and now use it in my 32 gtst. Don't have any probs. Cheapish ($30), but not nasty. Just bought another 2 x 5L yesterday at Repco's sale.

Fixxxer

You should have heard my mechanic go off at me about that stuff, mobil 1, penrite stuff etc. He said ONLY motul as its easy enough to get now, and not all that exxy. The turbolite stuff being fine for resonably stock cars. He does stock it, but he also tells me to go get it from autobarn as its cheaper than him selling it to me. So he isnt getting anything out of it.

The 300V range has quite a few viscosities to choose from, but the 300V chrono is 10W-40

here's the list:

300V LE MANS 20W60

300V COMPETITION 15W50

300V CHRONO 10W40

300V POWER 5W40

300V POWER RACING 5W30

300V HIGH-RPM 0W20

300V 4T COMPETITION 15W50

300V 4T SPORT 10W40

300V 4T FACTORY LINE 5W40

see -> http://www.motul.com.au/product_line_up/4s.../4stroke01.html

Hi mate, u reckon 15w50 is too thick for street use for a R33 GTR? im currently using Motul 4100 10w40.

Hi mate, u reckon 15w50 is too thick for street use for a R33 GTR? im currently using Motul 4100 10w40.

If you choose 15w50 oil, you must not floor your ride for the first 20min before your engine oil is up to temp. Anyway 15w50 will cause more startup wear, not suitable for short trip or city driving.

15W is the cold viscosity which isn't hugely different to 10W - the difference in wear will be minimal

If you choose 15w50 oil, you must not floor your ride for the first 20min before your engine oil is up to temp. Anyway 15w50 will cause more startup wear, not suitable for short trip or city driving.
Hi mate, u reckon 15w50 is too thick for street use for a R33 GTR? im currently using Motul 4100 10w40.

if your having any problems with oil consumption then a thicker oil will help. A 15w-50 is good for summer use/thrashing, and if you get a full synthetic like motul 300V its better then the 4100 as thats only a semi-synthetic so despite the thicker oil a 15w-50 will be better then a semi 10w-40 as the motul full synthetics use ester component in the oil which greatly reduces startup wear. Just look at their website it explians the benefits of fully synthetic ester oils :)

ester benefits -> http://www.motul.com.au/fact_sheets/estel_oil.html

thanx guys, i might give the 300v 15w50 a try next time, see how i go.

I know with my FTO which rev's out to about 8k I can't use more than about 30 (operating) in it. If u use a 50 (good for stopping tappets etc!! which is good) is it too thick at high revs...I mean we usually rev it out when we get it some...

Although I'm not sure if 40 or 50 will be much different..maybe the Motul oil is better..15W-50 would stop a lot of tappet noise for sure...10W-40 seems pretty normal though...would be a low enough viscosity to be safe at high revs.

KJ

I know with my FTO which rev's out to about 8k I can't use more than about 30 (operating) in it. If u use a 50 (good for stopping tappets etc!! which is good) is it too thick at high revs...I mean we usually rev it out when we get it some...

Although I'm not sure if 40 or 50 will be much different..maybe the Motul oil is better..15W-50 would stop a lot of tappet noise for sure...10W-40 seems pretty normal though...would be a low enough viscosity to be safe at high revs.

KJ

Thinner oil will has less drag on the engine component during operation. It will actually increase hp and improve your FC with thinner oil but the cons are lower HTHS at 150'c. This is the oil thickness when the oil reach 150'c during load or stress.

The best oil would be a thin 30wt oil with high HTHS. It will give you good hp and FC plus great protection during full throttle run.

IMO Redline 5w30 with HTHS of 3.8 are make up of mostly polyolester (group V) base stock couple with killer additives are the best money can buy. The oil film strength at high temp are stronger than most 40wt fully synthetic oil in the market.

FYI Mobil 1 fully synthetic 0w40 HTHS are only 3.6

true, and if you get a full synthetic 15W then there will be no difference :D

Whether an oil is synthetic or not makes no difference to the viscosity. A 20W50 mineral oil will be exactly the same as a 20W50 synthetic oil. How long it stays like that is a whole different issue, however. Use a synthetic oil as it will keep the motor cleaner (ie allow less black gunk to build up) when the thing gets exposed to high temperatures.

Secondly there is a considerable diference between an oil with a low temp viscosity of 5 and one with a low temp viscosity of 10. Try it next time you buy some oil. Pick up the two different containers in the shop & slop them around a bit. You will be surprised....

Lastly, it will take longer to fill the motor with say a 10W60 Castrol than a 5W50 Mobil. Have just done this (I used some of both as I had some Mobil 1 left over) & I can assure you there is a large difference. This is a good indicator of the diference in the oils viscosity.

Semi-Synthetic or Full is the go and you won't go wrong with the Motul 4100 Turbolight although I would use the 10W over the 15W, especially in a street driven turbo engine. Check your factory engine requirements.

I've been using Penrite HPR10 for over 60,000km and it's fine (RB25DET).

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • The rain is the best time to push to the edge of the grip limit. Water lubrication reduces the consumption of rubber without reducing the fun. I take pleasure in driving around the outside of numpties in Audis, WRXs, BRZs, etc, because they get all worried in the wet. They warm up faster than the engine oil does.
    • When they're dead cold, and in the wet, they're not very fun. RE003 are alright, they do harden very quickly and turn into literally $50 Pace tyres.
    • Yeah, I thought that Reedy's video was quite good because he compared old and new (as in, well used and quite new) AD09s, with what is generally considered to be the fast Yokohama in this category (ie, sporty road/track tyres) and a tyre that people might be able to use to extend the comparo out into the space of more expensive European tyres, being the Cup 2. No-one would ever agree that the Cup 2 is a poor tyre - many would suggest that it is close to the very top of the category. And, for them all to come out so close to each other, and for the cheaper tyre in the test to do so well against the others, in some cases being even faster, shows that (good, non-linglong) tyres are reaching a plateau in terms of how good they can get, and they're all sitting on that same plateau. Anyway, on the AD08R, AD09, RS4 that I've had on the car in recent years, I've never had a problem in the cold and wet. SA gets down to 0-10°C in winter. Not so often, but it was only 4°C when I got in the car this morning. Once the tyres are warm (ie, after about 2km), you can start to lay into them. I've never aquaplaned or suffered serious off-corner understeer or anything like that in the wet, that I would not have expected to happen with a more normal tyre. I had some RE003s, and they were shit in the dry, shit in the wet, shit everywhere. I would rate the RS4 and AD0x as being more trustworthy in the wet, once the rubber is warm. Bridgestone should be ashamed of the RE003.
    • This is why I gave the disclaimer about how I drive in the wet which I feel is pretty important. I have heard people think RS4's are horrible in the rain, but I have this feeling they must be driving (or attempting to drive) anywhere close to the grip limit. I legitimately drive at the speed limit/below speed the limit 100% of the time in the rain. More than happy to just commute along at 50kmh behind a train of cars in 5th gear etc. I do agree with you with regards to the temp and the 'quality' of the tyre Dose. Most UHP tyres aren't even up to temperature on the road anyway, even when going mad initial D canyon carving. It would be interesting to see a not-up-to-temp UHP tyre compared against a mere... normal...HP tyre at these temperatures. I don't think you're (or me in this case) is actually picking up grip with an RS4/AD09 on the road relative to something like a RE003 because the RS4/AD09 is not up to temp and the RE003 is closer to it's optimal operating window.
    • Either the bearing has been installed backwards OR the gearbox input shaft bearing is loosey goosey.   When in doubt, just put in a Samsonas in.
×
×
  • Create New...