Jump to content
SAU Community

Recommended Posts

A few friends of mine (Frink & Bullet32 on here among them) absolutely swear by them in terms of bang for buck, apparently they stick like shit to a blanket, though I hear some people saying that they tend to go off after they've travelled a certain amount of kms, and have noticeably less stick and generate more noise.

Link to comment
https://www.sau.com.au/forums/topic/119074-federal-595s/#findComment-2193740
Share on other sites

I run federals on the front now... 235-17s I don't find them to be anything special....

Werd, albeit a good tyre for the price. I'd like to try K104s too.

On my R32 the 595s lockup before ABS engages.

Without meaning to be rude, a search would probably find a thread from a few months ago discussing these very tyres :P

Link to comment
https://www.sau.com.au/forums/topic/119074-federal-595s/#findComment-2196503
Share on other sites

I'm pretty sure there are two different types of 595s - the SS595 and the 595 RS. The SS595s are these ones;

http://www.federaltyres.com.au/car/ss595.htm

The 595RS's were reviewed along with 8 other tyres in either Motor or Wheels recently. The short of it is that they were the best in the dry, the worst in the wet, and the cheapest by a fair margin. The mag suggested thay may be a good choice for ppl who do the occasional track day. They sort of seem like they're a bit more like an R spec tyre than the others in the test.

HTH,

Kot

Link to comment
https://www.sau.com.au/forums/topic/119074-federal-595s/#findComment-2196973
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • Great work! Thanks for documenting the process.
    • How would you even adjust the clutch if the pedal already has the correct free play? The operating cylinder has no adjustment in mounting position or rod length. On pull style clutches there is also no ability to adjust the bearing carrier. Push type I can see how adjusting the carrier height makes it all work.   If this is the twin plate clutch did you verify that your friction disks were oriented correctly? It's not mentioned in the directions at all you just have to notice that one side the friction disks have a part number on the hub fingers and a subtle coning to those fingers. Another thing that I noticed was if you put the friction disks in backwards the pressure plate fingers will not be even and flat when the clutch is installed.
    • yeah, mechanically, it is probably do-able, off the top of my head, there would be the transfer case, which I believe will bolt up to the rear of the RWD transmission, the shorter rear tail shaft. A front drive shaft, front diff, engine upper sump, front drive shafts, front hubs and front AWD struts (they are shaped around the front drive shafts), LCAs (at the very least from the front suspension) oil cooler.  You might want the rear diff from an AWD too, so you can be certain the front and rear diff rations are identical.  Who knows what brackets and mounts you might need.  So a whole doner car might be the best option if you need to maintain RHD. Then actually making it work, that would be a whole different story.
    • Take the fall as a warning sign for future endeavours  Stay safe mate
×
×
  • Create New...