Jump to content
SAU Community

Recommended Posts

HOWTO: Disable R33 Door Unlock Button

Intended Audience: Anyone concerned about their car safety

Technical Level: Low

Duration: 15 minutes

Effort: Low

Result: Very High

!!!Caution/Achtung/Attenzione!!!

Follow this guide at your own risk. You have been warned. We are not responsible for any actions you take. The information contained herein is a guide and should *not* be acted upon with consultation from your local tuner (he/she may not agree with my comments / suggestions). If you are unsure or are not confident don't do it.

This guide shows you how to disable the door unlock button on the R33 Skyline. It is a common known security flaw that this button works when the car is locked/alarm is on. Thieves can bend back your window and then press this button to unlock the passenger door. Once this has been done they are free to enter your car and do as they please. The factory alarm doesn't seem to be triggered by this break in method.

Tools you will need;

Phillipshead Screwdriver

Electrical Tape

Scissors or Pliers

1. Open driver side door. Remove the screw cover inside the door handle area and undo the phillips head screw. Carefully lift up the Power Window / Door Button harness cradle from the door.

post-2054-1149320362.jpg

2. Locate the wiring loom attached to the end of the controller unit and cut the Brown wire. Once this wire has been cut tape up both ends with Electrical tape.

post-2054-1149320460.jpg

post-2054-1149320543.jpg

3. Put keys into your ignition and turn to ACC. Test to see if the door unlock button works. It shouldn't

4. Tape up the remaining part of the loom and place the cradle back into the door. Screw it back into place and place the screw cover back on.

  • 1 month later...
  • 2 weeks later...

Sounds like a good idea, but you loose the door unlock function to go with it I take it? I do actually find this very handy as my alarm auto locks the doors when driving & I let passengers in & out with it a lot.

If you had a relay linked to the ignition power it would still allow this function to be used while securing your car when it is locked/alarmed too.

  • Like 1
  • 3 weeks later...

youll have to pull out your door lock button and have a look.

i dont see why they would have changed it for the gtt.

the wiring should be common on all the skylines, at least you would expect

Sounds like a good idea, but you loose the door unlock function to go with it I take it? I do actually find this very handy as my alarm auto locks the doors when driving & I let passengers in & out with it a lot.

If you had a relay linked to the ignition power it would still allow this function to be used while securing your car when it is locked/alarmed too.

best idea. there is an IGN feed already there to do it.

  • 3 weeks later...
Sounds like a good idea, but you loose the door unlock function to go with it I take it? I do actually find this very handy as my alarm auto locks the doors when driving & I let passengers in & out with it a lot.

If you had a relay linked to the ignition power it would still allow this function to be used while securing your car when it is locked/alarmed too.

just finished doin this on my dad's ceffy (which also has the same button in a similar position). Made sure the switch only worked when the alarm was disabled by using an alternate earth signal (which I got from the ignition switch).

  • 6 months later...

I have a '97 skyline r33 Series II. I tried pressing the passenger window button when i locked the car with the alarm on and the window didnt come down. I also tried it on the drivers side button while doors were closed and the window didnt come down. This exploit must of been fixed in the '97 skylines?

I have a '97 skyline r33 Series II. I tried pressing the passenger window button when i locked the car with the alarm on and the window didnt come down. I also tried it on the drivers side button while doors were closed and the window didnt come down. This exploit must of been fixed in the '97 skylines?

nope your talking about a completely different button... its not the power window switches..

its the passenger door unlock button.. Just below the passenger window button

  • 8 months later...

whats/wheres the ignition switch ?

i wana do this, but make it so it still works when the cars turned on.

just finished doin this on my dad's ceffy (which also has the same button in a similar position). Made sure the switch only worked when the alarm was disabled by using an alternate earth signal (which I got from the ignition switch).
whats/wheres the ignition switch ?

i wana do this, but make it so it still works when the cars turned on.

You need to buy a relay and switch it via the IGN wire on the connector.

If you need help i could do it for you, you just need to go to Jaycar, or wherever, and buy the relay.

oh ya i found the ign wire just now with the multimeter. think its the big yellow one.

couldnt i just chop the brown wire and connect it the yellow/ign ??

with the relay there will be 3 points ya ?? what would i connect them upto

thanks :thumbsup:

Have looked for the last 1/2hr for the farken life of me i can't find a simple farken wiring diagram for a common farken relay. Therefore i can't tell ya what to hook up to where.

THE WEB IS FULL OF USELESS SHIT!!!

You need one pin to hook to ACC

the 2nd to hook to GND

The 3rd to one half of the brown wire

The 4th to the other half of the brown wire.

I think it's:

Pin 86 => Acc

Pin 85 => GND

Pin 87 => 1st half of Brown wire

Pin 30 => 2nd half of Brown wire

Your common 10amp relay is more than enough.

ya i was looking on google 2.. 'howto use a relay' etc etc. then i got tired of looking and pm'd you :thumbsup:

3 --/ -- 5

1 --88-- 2

is on the relay i got

That should be it!

Pin 1 = ACC

Pin 2 = GND

Pin 3 = 1st half of Brown wire

Pin 5 = 2nd half of Brown wire

post-1811-1198678615_thumb.jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • I have been being VERY quiet about what you're alluding to, as it is something that ticks me off... The number of cars from factory that run coil overs is HUGE! Most of them these days do... The other part that annoys me, is people saying "Well all the incabin adjustable suspension is illegal by blah blah blah"... If that's the case, then why can I buy a car brand new that can do it if, FULL STOP in cabin adjustable suspension is illegal...   Also, I could just chuck some aftermarket shocks in my car, throw the stock springs on, after my blue slip, dump my super low springs back in. Same shock and spring style setup... Hell, they could also be the same colour springs etc.     I'm voting, BlueSlipper didn't want to touch the above car for some reason. Whether it be some sort of bias against the car, the owner, them maybe having previously done dodgy shit and now they're being super careful in case they get slapped in the face by the Gumbyment again... Find a new blueslip place.   And can confirm as you had said, yes there are holy bibles of vehicle heights, and all sorts of other suspension stuff. Heck your run of the mill mechanic, and tyre shop has access to all of that stuff. It's how they do wheel alignments...
    • Funny story Heading to Sydney this morning on the HWY there was some slow traffic, so I gave it the beans and midway through my overtaking "power run" I lost all power It seems that I missed a hose clamp,  and the MAF and filter went WiFi To make this more problematic, the little tool kit that lives in the boot, is sitting in the sun room at Goulburn......LOL Luckily for me I found a bit of steel on the side of the road that could be used like a rusty and bent flat head screw driver to tighten it up enough that it got me into Sydney, it is now all tight like a tiger with the aid of a 8mm socket Note to self: Use my brain and double check stuff, and always keep that little tool kit in the car for when I have a brain fart
    • Oh, and as for everyone with their fuel economy changes, I switch between E10 and 98 in the company car. Even do when I had personal cars that could run on E10. You know what changed my fuel economy in any noticeable way? How I drove, and where I drove. Otherwise, say on full tanks of just back and forth from work only (So same trips, same sort of traffic), couldn't notice a difference that I can correlate to the type of fuel in use. In the current vehicle, that's over 42L of USABLE fuel. While 98 is all "more energy dense", it also has higher knock resistance as it takes more energy to get it to ignite too. The longer hydrocarbons, typically more tightly bound. So running the same ignition map, can also produce less power, if there isn't enough time to get it all burnt through properly, as yep, the flame propagation speed is different from lower octane fuel to higher (Higher has a lower flame propagation, due to the more tightly bound and harder to self ignite funs. This is also typically where, a vehicle that is designed purely to run on 91 (Whether it be E10 or normal 91) usually sees absolutely no real world difference in fuel economy for the normal man, woman, or dog.
    • We've got some servos around me that have 91 with E10, 91 (no E10), 95, and 98. At those stations the change from 91 E10 to 91, is typically around 8c/L.   But lets not get started on the price of fuel in Oz. It's ridiculous. All the service stations around me, bar one, the price of fuel has been over the $2 mark per litre for the cheapest, 98 being around $2.45. That one service station is a CostCo, fuel from it comes from the same refineries, and makes no pitstops, it runs great, including the 98. In fact, I've had no issues on CostCo fuel, but plenty of issues at other stations!. The CostCo fuel, was $1.65 roughly this week for 94 with E10. $1.88 for 98. Servos directly across from it, $2.10 for 91 E10, and $2.48 for 98. The part I had to laugh at? If I drive multiple HOURS away from Brisbane, say out near Nanango, or Kingaroy, or even out to Goondiwindi, the price of their fuel, is the same as what it is at the CostCo... Oh, and that BP servo at Goondiwindi is HUGE and goes through epic turnover of fuel, so it's not sitting there for weeks going to shit. And what blows me away, my mate is one of the people who drives the Fuel Tanker all around QLD, delivering to all those places. At the same company his previous role was doing the "local haul" deliveries... Same truck, same driver, same pickup point it all comes from. So you tell me, how the hell it is 60c/L CHEAPER for fuel, when nearly all else is equal, except they require a B-Double to drive half a day out of Brisbane, and half a day back, every second day, compared to the delivery that can be under 30 minutes drive from the fuel pickup point... Not to mention, go five blocks down the road, and Ampol to Ampol will vary 30c/L... And I've had this conversation with my mate... The way it's priced, is just typical, pure and utter rubbish... He also does runs from Brisbane, to all over QLD, down to Newcastle, Sydney, Nowra, Melbourne, Geelong, and even out to parts of the NT depending on the companies needs. His main stuff is all the longer distance away from home for a few days at a time, then when he's back, he loves to just pickup extra shifts wherever he can in whichever truck, hence all the weird different places.   Oh, as for getting E10 into all the fuels in Australia... It was very quickly highlighted, that we don't have enough biomass available to use to make E10 sustainably like they require, and it would dramatically cut into our, and the worlds food chain supply...   I vote we all just start running on liquid methane gas... Plenty of that just getting tapped off at tips from underground decay... (Note, this is pure just stupid commenting. I could very easily highlight the reasons its not a good idea especially on scale...)
    • Am I correct in assuming that the R35's are getting the classic skyline haircut off the odometer?  Quick search on carsales, there are 33 08 and 09 GTR's for sale, only 2 of them have more then 100,000km's on them (116,075 and 110,000 respectively).  And somehow there are about 25 for sale with around 60,000kms? Looks like the classic skyline haircut to me =/
×
×
  • Create New...