Jump to content
SAU Community

Recommended Posts

What size and offset are your rims on the gtst mate?

They were 18x9 +20 front and 18x10 +5 on the rear. Front and rear guards were standard all I did for the rears was roll the lip flat with the guard (not pumped at all) just to allow a tiny bit of suspension travel and that was it. Fronts actually had a 5mm spacer from memory

Edited by Weapon

A few quick pics of my 33. Also a video of my new varex exhaust for anyone interested.

30c0oeq.jpg

j7dchf.jpg

mrsp60.jpg

Its almost complete in my eyes. It is stock height, stock wheels but I like it. I feel a lot more safe from police in this form.

As soon as my mate gets back from a week away, my new cat is being put in and some gauges wired up. All it needs now I think is a bit of a tune up. Only problem I have with the car really is the return to idle, it sometimes lopes as seen in the video but fortunately doesnt stall. Strangely it is a tiny bit laggier since installing the varex. A smaller air filter was installed at the same time. Will have to see which one is causing the problem.

Edited by Bennis
so gave the car a clean and had a play with the camera. the one thing i struggle with is framing a shot, so i drove around until i found a reasonably good place for photos. here are a couple of shots i took:


DSC04064_zps2a20024e.jpg


DSC04041_zpsd3805e59.jpg


DSC04040_zps8861ada3.jpg


DSC04067_zpseccd68bf.jpg


these were all taken using my 50mm SMC Super Takumar lens

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Dredgggggeeee time; I have recently finally started driving the car. It sat for so long that the fuel tank gave birth to rust sludge and blocked my lift pump sock and one of my walbro 460's and left grime, rust chunks and muck all through the surge tank and system. I decided to commit and pull the trigger on an oem r32 gtr fuel tank and Frenchys twin 460 / sender / surge tank hanger combo and all new larger lines and fittings etc, also boost doc heater hose kit / new heater core and a heap of other bits and shits like wideband sensor installed in the dump and Syltech iacv + lines and all wired and added to current tune. now having lightly driven it a couple times without issue, I can happily report on the hta3076 in its current tune. still no boost control switched on, 20psi gate springs, car makes 22psi at 3200rpm in 6th gear with 30-50% TPS from cruise at 100kmh. Going by the old graph, this means it should be making 300-325whp at the same numbers above. Very very responsive setup under true road driving loads. all that's left for the build is body loom + PDM, finish the remote aircon setup, install carbon fibre parts and go for full tune and 30psi. the 315 rear tyres are now performing like they're 195's, wheel spin in any gear at almost any rpm, whereas my previous setup hooked up in 3rd no issue, albeit Nt01's back then / RB25 5spd vs (new) old date r888r's Z34 6spd now, + obviously all the support upgrades I listed in the quoted post above. car sits at 1-3psi on cruise at 100kmh, expectations totally exceeded and I'm beyond stoked with all this so far. IMG_4848.mov
    • I've also been eyeing their rear axles for my car. I purchased seat mounts from them about 7 years ago and they were hot garbage so I've been a little wary about purchasing them. With that being said, please buy them and get back to us haha. 
    • Can a moderator please move this into the right category.. I've accidently put this into racing build thread 🤦🏽‍♂️
    • Being a manual, we very quickly ordered new R34 gearbox (From Nissan) and remaining parts from Kudos motorsports. Would highly recommend the team there. Ultra helpful and quick to share advice and upgrades. We are in the middle of taking the Auto out (Genuine 94,000/kms) and putting the Manual in this weekend. Part 2 of the build will include likely a Plazaman Intercooler and Plenium, Hks Exhaust with Tomei Dump (ordered).
×
×
  • Create New...