Jump to content
SAU Community

Recommended Posts

hi all,

i did a quick search, and now im trying to figure out if it was a genuine m spec nur that i saw this morning. apparently there arent very many in the country, and someone was saying in another thread that there was an imitatin m spec going around in qld, but this thing seemed pretty genuine to me.

anyone know if the owner is on here? they were qld plates too by the way (i left a couple of numbers in the plate). also had buddy club p1 rims, and a large exhaust tip, about 4.5 inch id say.

i saw it in boronia, on my way back from dropping my car off for an alarm install. it pulled up next to my sis's car at the lights, i didnt see the "M Spec Nur" badge until it took off, and went past.

only got one crappy photo on my phone (was a bit difficult for my sister 1.7L renault to catch it:P), and you cant see the farking m spec nur badge properly, but you can still kinda see it...

r34_m_spec_nur.jpg

well, it was absolutely awe-inspiring. i was impressed when i thought it was a gtr, then when i saw the spec nur badge, i had to get my head around the fact that this is the car ive been fantasizing over, looking at pics on the net. i never thought id randomly see one on the road. :(:(

Yep, It's Michael's, it is genuine. Just got off the truck from QLD on Friday and I went for a spin in it. It's very nice. Was taken to Vic Roads to change reg on Friday. It will hopefully be at the Show and Shine in December.

It's going into Race Pace today to have some work done to it.

I've attached pics I took on Friday when he brought it in to my work.

post-8874-1156126362.jpgpost-8874-1156126384.jpg

Yep, It's Micheal's, it is genuine. Just got off the truck from QLD on Friday and I went for a spin in it. It's very nice. Was taken to Vic Roads to change reg on Friday. It will be at the Show and Shine in December.

it's going into Race Pace today to have some work done to it.

I've attached pics I took on Friday when he brought it in to my work.

post-8874-1156126362.jpgpost-8874-1156126384.jpg

nice!! i saved the pics, and noticed they are titled "mines r34" so has it been tuned up by mines? :( ZOMG teh awesome!!1!11! if it has :(

blur plates for him? or you think he wont mind? :)

whats different about it vs normal bnr34 ?

300kmh speedo, gold build plate, metallic gold paint on rocker cover, timing cover

Optional Millenium Jade paint scheme

N1 engine specs: features

Metal BB turbos

N1 spec block

N1 spec pistons, rings, conrods, all balanced

N1 oil pump with relief valve

N1 high flow water pump

N1 exhaust manifold and turbo flanges

N1 cold air duct

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Well, yes, every CU on the bus is available via the Consult port, but whether the scanner you are using is capable of talking to the TCU, the ABS/TCS modules, etc etc, is what is at question here. Many of them are only for engine codes. So, if you have one of those, you won't know if the ABS is having a bitch.
    • That's now. R chassis Skylines come from a time when the tolerance in the ADRs was a bit more....slack. My car, on 235/35-17, which is damn near the exact same size as the original 205/55-16, is pretty much bang on correct indicated speed across the whole legal range. That's demonstrated with constant speed run over 5km, and GPS speed. It's just the luck of the draw. My particular speedo head has to be the thing that is "calibrated" that way, because everything else (the diff ratio, the gearbox and the speedo drive**) are all same same as most other Skylines. **OK, so the speedo drive is a Navara unit to drive the R32's cable, not the electronic unit than an R33/4 would normally have with teh same gear on it. Otherwise, I applaud your OCD tendencies, and I would do the same if I needed to.
    • Not too sure, I believe the Nissan consult port does everything? Also just filled up the reservoir to full and the light is still on. The float seems to move up and down fine.
    • The speedo's can be very conservative, when my Mazda NC MX5 speedo is showing 118kph, the GPS, and a calibrated radar.... cop mate.....hits me at around 110kph +/- 1 or 2 kph, and that is on a 215/45 17, stock tyres size is 205/45 17 as well, so weirdly conservative with stock tyre size When my Commodore speedo red 116kph GPS had me at 110kph on 255/40 17, so again conservative Google says manufacturers need to set the speedo from 4 to 10% slower than actual road speed.....for safety.....and compliance  After doing some offset and clearance measurements to see what can fit the NC on 17x8 +40, without guard rolling or rubbing anything at my current ride height, I've decided that when my tyres are toast, I'm going to fit 225/45 17 and see where that gets me IRT actual speed of my speedo and GPS/radar From the online calculator I should be still be doing around 5kph under an actual 110kph when the speedo is showing 110kph My ADHD requires that when I'm doing 110kph on the speedo, that the actual road speed is actually really close to that, and not alot slower And going from 205 to 225 still keeps the car within the %/mm allowable in the NSW vehicle rules and regulations, which is nice, as long as I'm looking at the latest version that is.....LOL https://www.nsw.gov.au/sites/default/files/2021-02/RMS-13.464-Light-vehicle-modifications-Vehicle-Standards-Information-No-6-November-2013.pdf
    • Take the value it measured as, and pick the closest range available that is above the reading on the screen.   Also, no point just testing the coils. Read what has been said again. You need to test all your wiring, everything.
×
×
  • Create New...