Jump to content
SAU Community

Recommended Posts

  • Replies 51
  • Created
  • Last Reply

Top Posters In This Topic

With my current setup if I dont hold it on redline the value doesnt budge. Past redline , and yeah around 40 or so... Ive had it >120 a couple of times so dont do it too much and make sure I change gears and/or control right foot :-)

I guess what I'm suggesting is that hitting the rev limiter is more likely to increase the knock value on the PFC .. might not necessarily be pinging... the knock sensors are essentially just microphones tuned into a certain frequency.

Edited by Color_Of_Green
Nah, ignition is cut, not fuel. That why you see big backfires on skylines sitting on the revlimiter.

I'm curious, please explain when, where, etc, you have seen high knock on a engine reving at the revlimiter?

Thanks

Um...

It is my understanding that Power FC cuts fuel but Power FC Pro cuts ignition.

Where? my car.

Edited by Color_Of_Green
Um...

It is my understanding that Power FC cuts fuel but Power FC Pro cuts ignition.

Where? my car.

Thats correct, we run a pro in the race car and it cuts ignition, part of the launch control, like antilag setup. But yeh, if you brush redline while racing it does tend to spit like a dragon really easy. Thats why i like flat changes, not only does it scare people with massive shotgun noises it looks tough and probably does more damage to everything haha.

just one more question about the knocking guys not that i have understood it but how do u find out if your engine is knocking?

If you have a power fc then you can set the screen on the hc to monitor it with peak hold. You can even graph it as you drive along. Other am ecu's probably have similar features. If you don't have a power fc etc then the only thing you can rely on is an orange flashing light in the top right hand corner of your dash. It will flash on and off when you have a knock of over 60 or there abouts. I was getting knock when in fifth gear and going up a steep hill [retuned now so no longer happens]. The hill was steep enough to make you put the foot down about 3/4 throttle to maintain 100km/h, but no way was the car flat out and no way was it necessary to change gears. I used a trailing throttle to avoid knock on such hills until I got a re-tune.

no it wont do crap, its all wives tales. but yes putting optimax extreme in your stock ecu'd skyline is likely to achieve less detonation, but nothing more. i wouldnt expect much detonation on 98 premium anyway.

Would this alone be a good enough reason to for it? or would the change in knock be so minimal it wouldnt really matter? This is using it over BP 98

As soon as the servo in findon has it I'll be doing a before/after run. Ign/afr (12:1) will be optimized before and after.

I may even fiddle with seeing how it goes leaning it out a touch more. Fingers crossed the egt guage is in by then.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...