Jump to content
SAU Community

Recommended Posts

Last night the Hobbies in the Hills, hobby shop above UAS was completly destroyed by fire. The fire did not get down stairs so except for being very wet, UAS survived. My car was getting its clutch replaced and I was lucky enough along with all the cars to get out without a problem. I dont think it is known if UAS will be ok but John has a lot of cleaning up to do!

Link to comment
https://www.sau.com.au/forums/topic/140230-uas-almost-burnt-down/
Share on other sites

Theis stock should be Ok but stuff like computers, phones and paper work will be gone.

The bigger issue will be the chance they will have to re-locate because of the dammage to the upper floors might make the building a write off!

Theis stock should be Ok but stuff like computers, phones and paper work will be gone.

The bigger issue will be the chance they will have to re-locate because of the dammage to the upper floors might make the building a write off!

Thats a really shitty situation - glad nobody was hurt all the the cars were safe.

Im watching the footage of the fire on TV right now :P Thats one serious blaze

actually apparently one of the fire fighters was injured :P

you would have to expect a hobby shop would go off like an H bomb. all that flamable glue, pressurised spray paint, model rocket engines, heaps of RC car fuel = KABANG with a side dose of KABOOM!

Does anyone know how the blaze started? I really feel for John as he is going to get reamed through no fault of his own.

actually apparently one of the fire fighters was injured :P

you would have to expect a hobby shop would go off like an H bomb. all that flamable glue, pressurised spray paint, model rocket engines, heaps of RC car fuel = KABANG with a side dose of KABOOM!

Does anyone know how the blaze started? I really feel for John as he is going to get reamed through no fault of his own.

According to the reports on Sky news, the cause is yet to be determined, but rest assured, that building is completely forked and will no doubt need to be demolished.

from website

---------------

URGENT NEWS

Due to fire in adjoining premises you may find it difficult to contact us at the moment.

You can fax us on 9634 8888 or email [email protected]

The phone no 9634 8000 has been diverted to one line so there may be delays until the problem is rectified.

If you have must talk to us, and are unable to do so please call 0425 303 019.

--------------

:P:D :D

feel for john and co

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Bah! I can't see the point in custom number plates at all. I went to the rego office, fished through a box of "premium" plates (the ones that had the "not as tall" option for the front plate) and picked the one that had a 32 in it. That's the limit of the effort and cost I will put into number plates. The only plate that I'd consider paying for would be 2332, but that's not possible here because it already exists from probably 90 years ago, and it would cost a fortune to obtain it, if it were available.
    • After chasing my tail with LS results..... and cheaper than a turbo swap... How confident are you that the dyno is accurate relative to other results? How fast is the car - What MPH does it actually run? Is this similar to what people running this power would expect?
    • Hi mate I am having an identical issue with my 98 R34 GTT. The engie suddenly cuts out under load at about 3-4k, black smoke out exhaust. Almost feels like traction control kicking in. No CEL but still going to check codes later today. Car was sitting in the shed for about 5 months before hand and only idled a few times, took her out with about 1/4 tank, filled up and thats when the issues started happening.  Threw on a spare set of coils/harness and checked plugs which was no help. Recently had fuel pump/filter changed so surely thats not the issue unless condensation in fuel, I just havent had the time to drain it It's running a hi flow turbo, bosch 1000cc injectors, walbro 450L, Z32, Nistune etc... All about 2000km old.
    • I always wonder where the obsession with legal/illegal spacing on number plates in the UK comes from. Because it comes up in comments in every UK-based video I see on youtube. From my point of view all of your plates look a bit odd. Just because there are no markings whatsoever. In Australia we have the state that has to be on it. In Europe you get stamps and state logos. Yours look a bit like a throwaway draft that people then stuck with. And attached with blu tack so that it falls off at the slightest disturbance. Not trying to hate, but it's interesting how things are done in different countries. Do you have to follow a lettering convention when choosing a custom plate?
    • Hybrid sounds like a supercharger... It's half a turbo, with a belt to drive it! Oh wait, they're just called super chargers...
×
×
  • Create New...