Jump to content
SAU Community

Recommended Posts

Car started fine at work! i got home. pulled up in the driveway. turned off car. opened roller door (electric door has had the dick for some reason) and went to start it again! and it was like i had no battery at all.

got dads car out and jumpered it. got it inside the garage and left it run for a bit. turned it off.. tried to start again and the dash lights barely light up.

i have a dry cell sealed battery which i have never ever had a power problem with. tho i did get it out of a car at my brothers work. so it is slightly second hand :thumbsup:

is there anything other than the battery that could be my problem??

Car be the 32 gtr

Cheers

Andrew

sounds like alternator to me. check the battery with the car off make sure it's ok, then check what the altenator is putting out when the car is running.

Battery reads 12.7 when turned off

When i try to start now, I hear what i think is the fuel pump trying to kick over. and the dash lights are faded. but then they come alite and fuel pump kicks in for a second. then it goes all dim again.

ok now with what i'd say a shorting sound somewhere at the rear of the car above the fuel tank???

Thats the only way i can descrive the sound.

Tho i think i usually hear it when its running good. cant quiet remember

Edited by Angus Smart
There are any number of previous threads that describe how to test and evaluate these sorts of problems.

My initial guess is a dead voltage regulator.

well generaly speaking. its alot easier to just ask. considering I DONT KNOW WHAT THE PROBLEM IS

and to check for a dead voltage regulator is done how?

clean the battery terminals... check the voltage after the terminals while cranking ill bet you find a massive drop. if it was the alternator, the car would have cut out before you got home, and not continue running after you jump start it, and battery wouldnt show 12.7v either.

clean the battery terminals... check the voltage after the terminals while cranking ill bet you find a massive drop. if it was the alternator, the car would have cut out before you got home, and not continue running after you jump start it, and battery wouldnt show 12.7v either.

Yeah a massive drop is what i found! down to around 4 volts.

i had battery on charge all night and tried to crank it in the morning. also with my jumper pack. which also seems it had the dick yesterday as it wouldnt charge up over night either.

the battery terminals are very clean! its a dry cell battery so they dont really leak or get dirty.

I didnt get to check the alternator. as i had to move too many cars around to be able to jump start it.

This would have to be the first electrical problem i've had! the car hasnt missed a beat!

You need ~10V to turn the motor.

I had the same problem as you about six months ago. Battery was flat. It also read 12V static but you could see the drop on the voltmeter as you cranked it.

PS You'll receive more help around here if you keep your cool.

sounds to me like the battery is dead. how old is it? try to find a letter and a number thats been burnt/melted into the top of it. example. L6 would be november 2006. letters are for the month except they dont use I cos it looks too much like a 1 A=jan B=Feb...H=Aug J=Jul etc

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • You very likely need to get it on a dyno and tune it. My assumption is, you've got an RB25DET tune in it, which has a different manifold, different injectors, and different cams as a minimum. What O2 sensor are you running?   When you say it runs extremely rich from idle all the way to redline, is this just free revving it you see that?
    • I seem to the be only person that is using a Haltech 2500 on an NA motor, I've installed a Bosch DBW throttle body to the OEM intake manifold and am having problems maintaining AFR even with the wideband o2.  It will run extremely rich at idle and up to redline, but under load it will go extremely lean in the 20s and i'm essentially having to rev it over 4k and feather the clutch to get it up to speed.  I've read a few other threads of about the butterfly, it seems removing the vacuum to it is supposed to have it remain open, i've noticed no difference under 4k with the vacuum line to it plugged.  I'm hoping someone here has had luck using the NA manifold with Haltech, and if they happen to have a tune for it.  
    • I don't know any details, but I really wouldn't be surprised if they do it as a LHD only version, at least initially.
    • Thanks for the replies everyone. Definitely a coolant push. Oil catch can is empty and always has been. As the engine is out now I'll be having a good look over things. I do have some detonation on the piston tops from a trigger issue back about 5 years ago. I felt it and shut off then bought a new ecu and changed the trigger. Never been an issue since. It never hurt the power, its made almost 80hp more since that incident but I will pull the bearing caps to take a look. If the bearings are damaged I will do a bottom end refresh. Head is being re conditioned at the moment and the block will be cleaned and checked to ensure it's flat. I'll go with a kameari gasket and see how it ends up. The other thing I'm not super keen on is the cylinder colours. I suspect this is from the inlet manifold. The plan will be to put it back together, retune and then stick a plazmaman billet inlet on it and retune. I'm happy with the power, if it makes a little more, then great, but I would rather just make everything more efficient at this stage.
    • Maybe they'll look to do a bunch of presales to help inject some cash fast for their financial issues...
×
×
  • Create New...