Jump to content
SAU Community

Recommended Posts

so, for a series 1 1997 rb25det stagea, a R33 same year (ie series 2) heater core will fit, as will a Z32 (300zx 1990-1996) heater core?

just confirming prior to buying one and stocking it 'till ready to do the job

thanks all.

over and out for a few weeks. off to hospy................

cyas

There are actually 2 different part #s for the stagea heater core and 2 for the Series 2 R33, prob slight difference for colder areas, eg bigger core. I would be 99% sure that they are interchangable and the Z32 would be same.

also this link:

http://cgi.ebay.com.au/NISSAN-300ZX,-Z32-N...9QQcmdZViewItem

Edited by chook

For S1 Stagea's R34/R33/R32 ones fit in. I put a secondhand R34 one in because I only paid $100 for it and I thought getting a R34 one it would be less aged. Have fun with the install off it.......................

Also did you read my points in this post above:

http://www.skylinesaustralia.com/forums/in...&st=0

hey cy,just had dash back out finialy fixed that dam creak.under it stupid spot wields on the seams,but all fixed now.also the compression is even now must of had carbon build up on that cylinder.thanks for the ride bud.

  • 8 months later...

Hi all,

Well here it goes again... I have replaced my heater core 3 times now... first 2 was second hand heatercores so understandable why i had to replace them in a matter of 2 month but then I bough a brand new one from Nissan that was about 2 years ago and the other day it decided its going to leak... What the hell i thought they are suppose to last for at least 8 years or so not 2... so help would be appreciated as to why on earth a 2 year old heatercore is leaking...

looking forward to your responses guys :)

  • 6 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Dredgggggeeee time; I have recently finally started driving the car. It sat for so long that the fuel tank gave birth to rust sludge and blocked my lift pump sock and one of my walbro 460's and left grime, rust chunks and muck all through the surge tank and system. I decided to commit and pull the trigger on an oem r32 gtr fuel tank and Frenchys twin 460 / sender / surge tank hanger combo and all new larger lines and fittings etc, also boost doc heater hose kit / new heater core and a heap of other bits and shits like wideband sensor installed in the dump and Syltech iacv + lines and all wired and added to current tune. now having lightly driven it a couple times without issue, I can happily report on the hta3076 in its current tune. still no boost control switched on, 20psi gate springs, car makes 22psi at 3200rpm in 6th gear with 30-50% TPS from cruise at 100kmh. Going by the old graph, this means it should be making 300-325whp at the same numbers above. Very very responsive setup under true road driving loads. all that's left for the build is body loom + PDM, finish the remote aircon setup, install carbon fibre parts and go for full tune and 30psi. the 315 rear tyres are now performing like they're 195's, wheel spin in any gear at almost any rpm, whereas my previous setup hooked up in 3rd no issue, albeit Nt01's back then / RB25 5spd vs (new) old date r888r's Z34 6spd now, + obviously all the support upgrades I listed in the quoted post above. car sits at 1-3psi on cruise at 100kmh, expectations totally exceeded and I'm beyond stoked with all this so far. IMG_4848.mov
    • I've also been eyeing their rear axles for my car. I purchased seat mounts from them about 7 years ago and they were hot garbage so I've been a little wary about purchasing them. With that being said, please buy them and get back to us haha. 
    • Can a moderator please move this into the right category.. I've accidently put this into racing build thread 🤦🏽‍♂️
    • Being a manual, we very quickly ordered new R34 gearbox (From Nissan) and remaining parts from Kudos motorsports. Would highly recommend the team there. Ultra helpful and quick to share advice and upgrades. We are in the middle of taking the Auto out (Genuine 94,000/kms) and putting the Manual in this weekend. Part 2 of the build will include likely a Plazaman Intercooler and Plenium, Hks Exhaust with Tomei Dump (ordered).
×
×
  • Create New...