Jump to content
SAU Community

Recommended Posts

Hey guys, I thought it would be interesting to see what kind of economy all our cars are getting!

Next time you fill up at the pump, reset your "trip-o-meter" and then when you fill the tank up after that (all the way to the top) note how many K's you've done, and how many litres you just bought! The best way to compare between cars is litres per 100 kilometres, so to find out yours use this site - Metric Fuel Consumption Calculator

So for example, I traveled 159k's and used 28L of fuel, therefore my car's guzzling away at 17.61L/100k's eek! :)

Link to comment
https://www.sau.com.au/forums/topic/157835-whats-your-fuel-economy-like/
Share on other sites

haha well atm i used half a tank for 60kms lol (just been rebuilt with lots off goodies dropped it off for a tune today lol)
:)

Mine's about 18.26L/ 100km's. The idling in traffic & start up with the 740cc injectors is what kills me :) :)

Hmm... I'm a bit of an Excel junky. So I have a done some work on this. LOL

My averages over the past two months are:

14.12 - L/100Km

7.10 - Km/L

461.19 - Max Range (at current Km/L)

5.84 - Km/$

0.17 - Cents/Km

Also I average 234.92Km between fuel up's (once a week normaly)

and fill tank with an average of 31.90L.

The average cost of BP Ultamate 98 over the past two months has been $1.22per/L

:) LMAO!!

Edited by CleanGTS-t

I've got 3 reading's for ya

Open Road (country Drive) = 10.5L/100kms

City (grampaing) = 13.1L/100kms

City (thrashing) = 18.97L/100kms

all run on BP Ultimate, was heap's surprising cause I think it's runnin a bit rich too...

I get between 5.46 and 6.7km/L .... most I have ever had out of a tank is 400km - my orange light comes on at around 280km most of the time :D

I am going to change the O2 sensor shortly as well as some other mods - hopefully will improve the economy

I get between 5.46 and 6.7km/L .... most I have ever had out of a tank is 400km - my orange light comes on at around 280km most of the time :laugh:

I am going to change the O2 sensor shortly as well as some other mods - hopefully will improve the economy

Surprised you haven't changed the O2 by now Andrew. With the economy you're getting you'll save a fortune if you change the sensor, should pay for itself in a matter of weeks.

I normally check mine each time I fill up. I do between 300 - 400km a week usually. My driving is normally all suburban with lots of hard launches & acceleration (I just cant help myself :D). For that kind of driving I normally average between 11.7 to 12.2 Litres/100Km, 12.2 being if I've been using the airconditioning most if the time.

If I start doing any major highway/country stuff I can get it into the 10's easy & have seen 9's

Before doing my O2 sensor my economy had crept up to about 15 Litres/100km..

Edited by JazzaR33

If you want fuel ecconomy buy a bike, if you want a performance car dont worry about fuel ecconomy. The more power you make the more fuel you need.

I have never worked my ecconomy out, but I know its not that good (but I dont care). Just because a Skyline offers great performance at a budget price (we they do now, but not so much when I bought mine) will not make them an ecconomical car. If you can't afford the fuel (and tyres and maintenance) to drive it, dont buy any performance vehicle.

/end Rant LOL

:laugh:

I sold my old VS 5ltr 5speed because it used too much juice, I bought a turbo'd skyline so I could limp it around off boost the majority of the time and be decent on petrol. When I want to give it a hit I do and it uses the juice.

I remember when new from factory the R32 GTST's were supposed to return 10.5L/100km's and the R33's 10L/100km's. Obviously thats when they were new, on jap fuel and driving it lightly.

As long as mine continues to return over 400km's per 50litres I care less.

A mate runs 800cc sard twin sprays making 270rwkw with his rb30det and that still returns over 400km's to a tank so there's no reason why some should see less in my eyes.. Obviously if he gets stuck up it for long periods of time (which is near impossible not to mention damn dangerous with 270rwkw) it will suck the juice.

Thats my story/rant. LOL :P

r31 - rb20det, on a really empty fill i get nearly 50L in........for a 55L tank i dont let it go taht far (usually max 45L is an empty fill for me)

when it was auto id get 300km to a tank........mainly cos it would hang in 3rd at 60 and not go into overdrive

since manual, ive been gettin 400-450km per tank..........usually gets a good floggin on a weekend

Hi Guys,

I've been monitoring my economy for the past 18 months. Since my last tune in September 2006, I average 14.4L/100km. My best recorded was 13.3 and worst 15.7 to date.

This is ALL city driving.

I wouldn't expect much better than maybe 12.5 on a country run as the Microtech LT12 doesn't have closed loop and doesn't utilise the O2 sensor any more. With the Microtech, economy has to be tuned on the dyno.

It's much better now as prior to this tune, my worst was 18.8 and that was the fuel prices were through the roof!

Cheers, Mike

i get a bit over 350km and normally fill up 50-55lts

i figure that leaves 10-15lts in my tank

last week i think i got 400km ive been takin it real easy of late due to comming close to a clutch change

same.. but lol, I also got quarter tank fuel problems due to not caring enough during the installation of my fuel pump (not mounted low enuff)... So now on empty (1/4 tank) I'll get down there and mount it lower in the tank.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • This. As for your options - I suggest remote mounting the Nissan sensor further away on a length of steel tube. That tube to have a loop in it to handle vibration, etc etc. You will need to either put a tee and a bleed fitting near the sensor, or crack the fitting at the sensor to bleed it full of oil when you first set it up, otherwise you won't get the line filled. But this is a small problem. Just needs enough access to get it done.
    • The time is always correct. Only the date is wrong. It currently thinks it is January 19. Tomorrow it will say it is January 20. The date and time are ( should be ! ) retrieved from the GPS navigation system.
    • Buy yourself a set of easy outs. See if they will get a good bite in and unthread it.   Very very lucky the whole sender didn't let go while on the track and cost you a motor!
    • Well GTSBoy, prepare yourself further. I did a track day with 1/2 a day prep on Friday, inpromptu. The good news is that I got home, and didn't drive the car into a wall. Everything seemed mostly okay. The car was even a little faster than it was last time. I also got to get some good datalog data too. I also noticed a tiny bit of knock which was (luckily?) recorded. All I know is the knock sensors got recalibrated.... and are notorious for false knock. So I don't know if they are too sensitive, not sensitive enough... or some other third option. But I reduced timing anyway. It wasn't every pull through the session either. Think along the lines of -1 degree of timing for say, three instances while at the top of 4th in a 20 minute all-hot-lap session. Unfortunately at the end of session 2... I noticed a little oil. I borrowed some jack stands and a jack and took a look under there, but as is often the case, messing around with it kinda half cleaned it up, it was not conclusive where it was coming from. I decided to give it another go and see how it was. The amount of oil was maybe one/two small drops. I did another 20 minute session and car went well, and I was just starting to get into it and not be terrified of driving on track. I pulled over and checked in the pits and saw this: This is where I called it, packed up and went home as I live ~20 min from the track with a VERY VERY CLOSE EYE on Oil Pressure on the way home. The volume wasn't much but you never know. I checked it today when I had my own space/tools/time to find out what was going on, wanted to clean it up, run the car and see if any of the fittings from around the oil filter were causing it. I have like.. 5 fittings there, so I suspected one was (hopefully?) the culprit. It became immediately apparent as soon as I looked around more closely. 795d266d-a034-4b8c-89c9-d83860f5d00a.mp4       This is the R34 GTT oil sender connected via an adapter to an oil cooler block I have installed which runs AN lines to my cooler (and back). There's also an oil temp sensor on top.  Just after that video, I attempted to unthread the sensor to see if it's loose/worn and it disintegrated in my hand. So yes. I am glad I noticed that oil because it would appear that complete and utter catastrophic engine failure was about 1 second of engine runtime away. I did try to drill the fitting out, and only succeeded in drilling the middle hole much larger and now there's a... smooth hole in there with what looks like a damn sleeve still incredibly tight in there. Not really sure how to proceed from here. My options: 1) Find someone who can remove the stuck fitting, and use a steel adapter so it won't fatigue? (Female BSPT for the R34 sender to 1/8NPT male - HARD to find). IF it isn't possible to remove - Buy a new block ($320) and have someone tap a new 1/8NPT in the top of it ($????) and hope the steel adapter works better. 2) Buy a new block and give up on the OEM pressure sender for the dash entirely, and use the supplied 1/8 NPT for the oil temp sender. Having the oil pressure read 0 in the dash with the warning lamp will give me a lot of anxiety driving around. I do have the actual GM sensor/sender working, but it needs OBD2 as a gauge. If I'm datalogging I don't actually have a readout of what the gauge is currently displaying. 3) Other? Find a new location for the OEM sender? Though I don't know of anywhere that will work. I also don't know if a steel adapter is actually functionally smart here. It's clearly leveraged itself through vibration of the motor and snapped in half. This doesn't seem like a setup a smart person would replicate given the weight of the OEM sender. Still pretty happy being lucky for once and seeing this at the absolute last moment before bye bye motor in a big way, even if an adapter is apparently 6 weeks+ delivery and I have no way to free the current stuck/potentially destroyed threads in the current oil block.
×
×
  • Create New...