Jump to content
SAU Community

Recommended Posts

easy way to pick them is look in the mouth of the front bar where the cooler sits.. the siren is there

the other way to pick out undercover cops is too look at the antenna, if its a tall one with a thick base (usually thick black rubber at the base) then watch yourself :D

Edited by Baconer
Link to comment
https://www.sau.com.au/forums/topic/161664-nice-cop-car/#findComment-3008888
Share on other sites

Signs its undercover cop car:

Plates are Normal issue - I.E Not a white,blue,purple, custom yellow, black etc.

Windows will have squares in them for lights ussually mounted top left and right corners and on dash front centre and rear centre top!

If stock car will have NO hub covers

Will have stock alloys if its a GT-P or any up-market performance car

Will floor it off the lights to waste petrol unless your infront.

Plates will now often have LPG sign as many cars are now going environmently friendly and also cheaper.

If non of these items are on the car (barring the lights) it is a impounded vehicle. Ussally only sporting some features if any, Almost always will have Blue/red lights in the blinkers.

Ussually two people will be in the car - two people are better than one at over powering a person if they get violent!

Although I've never been able to pick a cop car via its ariel they often do have a ariel front of the left hand side comming out of the bonnet gap, rear comming out of the boot gap (left hand side) or in stock position on the middle rear radio ariel situated directly centred on the rear window or above.

Hope this helps some people from being booked, if it doesnt then you deserve it.

Remember impounded and retrieved cars are virtually un detectable.

Oh and in NSW the undercover car of choice is ussually a silver GT-P ford because of its power, common-ness and hoon like apearence.

Edited by DECIM8
Link to comment
https://www.sau.com.au/forums/topic/161664-nice-cop-car/#findComment-3008931
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...