Jump to content
SAU Community

Recommended Posts

Add me also. keen on both gearstick and handbrake boots!!!!

When do i pay?when will i recieve them?etc.

Dan.

EDIT: please PM me and i should be able to pay tomorrow if you need it..

Edited by Dan_AE86
  • Replies 518
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

my mum, took my brothers torn and worn down one, and that night when watching tv, she made him a brand new one outt leather, it looks awesome and stock.

so good infact she has made 2 others for some of my friends with r33s, story short, she made 3 for less thatn charged. so if ya mum or someone is good with the needle, give it a go :ermm:

Payment details have been sent to everyone in the group buy.

Seeing as though I can't edit the first page (due to admins removing everyone's right to do it :ermm: -_-") I will post your names here when I receive your payments.

It's still not late to join so PM me if you are interested!!

  • 1 month later...
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • The final part arrived today to un-clampify and simplify the intake Who would have though a 1/2" hose stainless bulkhead fitting designed for below waterline bilge pumps would be what I needed Test fit on a 3" offcut I had laying around to see if it would work, and it worked a treat All going well the intake will be on its "final version" tomorrow 
    • Good luck on the weekend mate
    • Must have been an absolute nightmare to drive when the power steer was out, the rack ratio/wheel size/caster is all set up for power assistance
    • Welcome to SAU, what are you looking at buying?
    • I checked the injectors again (1 and 2, since they’re easiest to access) to make sure they weren’t clogged. Even though the entire fuel system had been cleaned, I wanted to be certain. Everything looked clean, so I reinstalled and connected everything. When I started the car to confirm everything was okay, it immediately revved up high, so I shut it off straight away. I checked to see if I’d missed a vacuum hose or something, but everything was connected. On the second attempt, the car ran without the high idle, but I noticed a distinct “compressed air” sound coming from the engine bay. Tracing the sound, I pushed injector #6 forward slightly and the noise stopped — it turned out it wasn’t seated properly, despite the fuel rail being bolted down. While holding it in place, the car idled steadily without stalling and ran for over 5 minutes. At this point, I pulled all six injectors out just in case I hadn’t seated them correctly or dirt had gotten onto the O-rings. Unfortunately, I discovered that I had damaged 3 out of 6 injectors (the OEM 270cc ones) during installation. So yes, this was my fault. Since only the pintle caps were damaged, I’ve ordered a Fuel Injector Service Kit from NZEFI to refurbish them. In the meantime, I reinstalled my new injectors – the car now idles fine for over 15 minutes without stalling. I have not attempted to drive it so far. It’s not perfect yet, as it hesitates when the throttle is pressed, but it’s a big improvement. Unplugging the IACV with the new injectors idles at around 800rpm, even with the IACV screw tightened fully. But this is probably due to tune.
×
×
  • Create New...