Jump to content
SAU Community

Recommended Posts

  • Replies 47
  • Created
  • Last Reply

Top Posters In This Topic

i say: "meh"

agreed!

they already said that the possibility of a tsunami hitting the coast of Northern QLD is very unlikely, let alone hitting the NSW coast, but need to issue the warning because it's still possible.

Link to comment
https://www.sau.com.au/forums/topic/162826-tsunami-warning/#findComment-3022556
Share on other sites

$10 says its a fizzer

The NSW State Emergency Service advises that:

· People at the beach should probably have sand castle building competitions also maybe bury each other up to your heads in the sand.

· People in boats in shallow water should immediately start drinking champers. It'll be an awesome adventure of alcohol and tidal waves.

· Boats and ships at sea should move to shallow water and aim for beach goers.

· · If you see the sea go out like a very low tide then immediately go to the shore and take a closer look. Its an phenomenal site to see and the closer you are the better.

· People should keep listening to the local media for updated information so they can use this event as an excuse to get off work for a day.

This warning will be updated by 1pm EST.

Link to comment
https://www.sau.com.au/forums/topic/162826-tsunami-warning/#findComment-3022701
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I see what you posted, but how could a warning light be going on and off if there is no sender for it?  The only other explanation is that the wire that used to go to the sender from the warning light is earthing somehow in the loom or at the connector, or that you have connected the warning light wire to something (maybe the temp sender?).  
    • The original pressure sender (switch) had the standard connector and the temp sender had the single terminal connector also. The pressure switch is gone and those wires eliminated from the harness.  I left the temp wire as I too used the temp sender to plug the extra hole. I was hoping for an easy answer but I guess I'm going to need to trace some wires to see where my ghost oil pressure light voltage is coming from or maybe I'll just pull the bulb out as there's no pressure switch any longer.
    • Can you guys tell me a workshop that have installed E85 please and thanks.   I know about Tune house and Powerhouse 
    • Over an year later, I'd like to ask what as your solution in this. Did you keep the R35 coils with the stock ECU? Or slapped the Link in and tossed the 90s chip in the bin?
    • I’m having a gear issue where it doesn’t want to go in 2. It’ll shifts all the way in when car is off, doesn’t like to shift up to second but will shift down into second some times. And I’m curious if you had any alignment issues or if it’s just the transmission. I’m running the serial 9 shifter. 
×
×
  • Create New...