Jump to content
SAU Community

Recommended Posts

SAFC: SAFC II

GearBox: AT

Turbo: r33 hi-flow front/vg30 rear

Exhauset: 3inch splitdump, wrapped.

Air Filter: open pod

Injectors: Factory

Intercooler: Copy Hybrid

Fuel Reg: Stock

Fuel Pump: Stock

Boost Controller: rb20 act. running 10-12psi

BOV: plumb back

234.9rwkw@10-12psi

  • Replies 43
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

Just for the guys asking about the Fuel Pump

If you want around the 200rwkw then you need a new pump, the stock will reach its limit about 170 - 180rwkw.

then you can wid the boost up a little more aswell cause fuel supply won't be an issue.

I think thats what happened to me, cause i had my boost set at 12psi but it was knocking so they had to drop it to 9-10. Do you think by getting a new fuel pump, putting the boost back up to 12 and getting it dyno'd again will get me to 200?

I think thats what happened to me, cause i had my boost set at 12psi but it was knocking so they had to drop it to 9-10. Do you think by getting a new fuel pump, putting the boost back up to 12 and getting it dyno'd again will get me to 200?

stab in the dark but it could be your spark plug gaps for 10psi plus boost they should be gapped at 0.7 - 0.8mm gap

Yeah i guess if you got that power on stock fuel pump then itshouldnt matter, but mine could be stuffed. Wouldnt hurt changing it anyway its not that expensive compared to buying a new ecu.

r33madd i gapped my spark plugs to .8 when i changed them after i got the car. Would changing them to .7 help?

my car made 200.2kw without an safc and my afr at 10.5:1 top end, on 12psi dropping back to around 10psi top end also. What do you guys think I could gain with a safc??? and say tuned at around 12:1 afr??

I have a 96 r33 s2 with 3" turbo back zorst, fmic 600*300*76mm, high flow fuel pump and stock turbo with steel front wheel? ( series 2 should have plastic one.)

Cheers

Russ

Roughly what kind of time is required on the dyno to get one of these doovas working properly. I have read about 1.5 to 2 hours yeah?

yea mine took 1.5 hours but it can also depend on your car and the tuner

so do you reckon that i should be investing in a upgraded fuel pump before i get a dyno tune with my safc?

will there be much of a gain if any?

running 12psi boost, hks pod, fmic, full exhaust including dump and afc neo?

should i go for a pump and wat power should i be expecting?? around 180 hey?

anything else that i could upgrade easily to get me more power?

HI,

Guys if your fuel pump is causing you issues, some may be faulty change it. If not leave it.

What I am saying is save your money(or if you can afford it buy it). On the other hand I didnt have money to throw around and went to the dyno with a 'it will make as much power as it wants to attitude'..

stock fuel pump I made 234.5rwkw..and so many others also...this proves that the stock pump is capable? Unless there were different model gtst r33 pumps, which I doubt.

I dont want to mislead anybody, just trying to shed some light..

Fuel is important in the long run, as if there isnt any well you engine will cease to work.

Cheers

my2c

well its obvious a fuel pump and reg increases power but that auto Steg with 160 at the wheels is pretty impressive

plenty of auto stageas in australia with >200 awkw. Same upgrade potential as skylines but you lose an extra 10-20kw through the drivetrain due to the extra weight. They're about 250-300kg heavier than a skyline :P AWD helps to overcome the weight a little bit - especially when you increase the kw.

You can gain an extra ~20kw by removing the front drive shaft, making it RWD, but the reality is that people have done this and found that the car is actually faster in AWD (almost a 1sec difference in 1/4 mile times). Factory RWD-only stageas are a LOT lighter (front diff and ATTESA setup adds about ~200kg!!) however so these would have performance very similar to an equivalent RWD skyline. :(

yeh i am going to go on the dyno and get my afc neo tuned and see how the stock fuel pump handles it, hopefully everything goes all good, if not well i will have to upgrade it.

i will have, afc neo, fill 3" exhaust with dump pipe, air pod, fmic, bc runs 12psi.

what kind of figures do you think i will be expecting? hopeing for 180 or something higher or there abouts.

should be up on the dyno within the next month or so

Paulr33...

time will only tell if it is a timb bomb tune..Can you explain to me why it is a timb bomb?

I know many people change the pumps because of the info they get on these type of topics and some times they would probaly definately not need it. It has been a few weeks of testing the car and it is holding up fine for now. It seems to be suppyling fuel fantasticly as the AFR's when dynoed were fine?

Can someone please post up if they have had there stock pump run of efficency at higher power levels. All the time I hear people claiming that there faulty not that they cannot supply the fuel at certain power levels. My pump is old now at 12years of age, I think this is the cause sometimes. Some last longer then others or quality may vary. There are alot of variables.

Paulr33 I will update you in a couple of months to see if the pump is holding up..

Cheers

before I went onto the dyno I ran NULON INJECTOR CLEANER through the car also as i use to drive around on the bottom of the tank alot which sifts all the gunk from the bottom of the tank into the injectors and is known to clog them up..It may of cleaned the fuel pump also as you put it straight into the tank.

Cliffgtst Use some injector cleaner before hand and maybe run some ethonal fuel before hand as this is also known to clean some gunk laying around in the fuel systems and engine..

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • For these last 7 years of ownership, I've always had to use a small scissor jack under one of the front tow hooks to raise the front just enough so my low-profile jack fits under to reach my subframe jack point. I'm beginning to get annoyed of always having to do this. Are there any lower low-profile jacks that fit under the gtr lip on a dropped car?
    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
×
×
  • Create New...