Jump to content
SAU Community

Recommended Posts

  • Replies 58
  • Created
  • Last Reply

Top Posters In This Topic

As BB says, horses for courses. I am more regularly at 120-130 degrees towards the end of a session whereas he is more around the 105-115 I'm guessing.

spot on. On track I'm up around the 115 mark at max, but oil pressure is still a steady 6 bar at anything above 3,000rpm (which is all the time).

I wouldn't worry too much about winter oil/summer oil your car pretty much runs the same temps summer or winter, maybe water temp get's up a bit in summer traffic. but even startup temps would only be 10degrees difference at most.

maybe try the 10W40 one trackday and see what the oil pressure is like?

Sorry I meant 15w50. It's the 300v Competition. I have been thinking about using the Chrono for winter but my car has always run fairly hot so I appreciate the extra thickness at high temp. I probably should use a better quality oil cooler but the one I have works ok and the 15w50 gives me the protection I need.

I do notice quite high oil pressure when cold and am particularly careful when warming up the car because when using a thicker oil like this I think the turbo is more suseptible to damage due to lack of oil flow. I never boost at all before the water is up to temp and would be lucky to hit 0.3bar before the oil temp has risen.

As BB says, horses for courses. I am more regularly at 120-130 degrees towards the end of a session whereas he is more around the 105-115 I'm guessing.

Thanks for the explaination.

I do use the 15w50 300v Competion oil, for my R32 GTR. Just Jap use it for thier GTR's that run in Targa and seems to be good.

I spoke the guy at Green Goanna and he said that he does not stock the Motul brand oil. But he suggested to use Shell Helix Ultra 15w50 for $205 incl GST for 20L. The Shell oil is used in alot of the rally cars.

Has anyone used this oil?

Cheers

Cheers

  • 4 weeks later...

Nope Tafe is being a pain in the ass with financial year end coming up as well as new rules.. they are trying to work a way around it atm... I will post in this thread after dad goes back to work .. think school hols start next week.... or the week after... can never remember!

  • 2 weeks later...

Guys try Harold at performancelub.com.... Royal purple is 10.90$ for a quart (946ml)... this guy imports his stuff form America.

he is located in Melbourne, but even with postage he is cheaper then most places.

Cheers.

I picked up some Mobil 1 0w40 for 54$ (i picked it up though).

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Yeah well per the video it took 15s for the stock unit to start up....even if I give it a few seconds discount for starting that is at least 12 sec before you get a reverse camera if you are trying to leave a park.  The android unit is way faster, but 2016 for the stock unit is a long time ago in consumer electronics
    • Yea that’s why I said ima test them with multimeter and see the reads.
    • Only at idle. Isn’t a problem when rev it seems.
    • @Haggerty This seems silly to ask, but are you confident in your ability to tune the Haltech?  
    • Next on the to-do list was an oil and filter change. Nothing exciting to add here except the oil filter is in a really stupid place (facing the engine mount/subframe/steering rack). GReddy do a relocation kit which puts it towards the gearbox, I would have preferred towards the front but there's obviously a lot more stuff there. Something I'll have to look at for the next service perhaps. First time using Valvoline oil, although I can't see it being any different to most other brands Nice... The oil filter location... At least the subframe wont rust any time soon I picked up a genuine fuel filter, this is part of the fuel pump assembly inside the fuel tank. Access can be found underneath the rear seat, you'll see this triangular cover Remove the 3x plastic 10mm nuts and lift the cover up, pushing the rubber grommet through The yellow fuel line clips push out in opposite directions, remove these completely. The two moulded fuel lines can now pull upwards to disconnect, along with the wire electrical plug. There's 8x 8mm bolts that secure the black retaining ring. The fuel pump assembly is now ready to lift out. Be mindful of the fuel hose on the side, the hose clamp on mine was catching the hose preventing it from lifting up The fuel pump/filter has an upper and lower section held on by 4 pressure clips. These did take a little bit of force, it sounded like the plastic tabs were going to break but they didn't (don't worry!) The lower section helps mount the fuel pump, there's a circular rubber gasket/grommet/seal thing on the bottom where the sock is. Undo the hose clip on the short fuel hose on the side to disconnect it from the 3 way distribution pipe to be able to lift the upper half away. Don't forget to unplug the fuel pump too! There's a few rubber O rings that will need transferring to the new filter housing, I show these in the video at the bottom of this write up. Reassembly is the reverse Here's a photo of the new filter installed, you'll be able to see where the tabs are more clearing against the yellow OEM plastic Once the assembly is re-installed, I turned the engine over a few times to help build up fuel pressure. I did panic when the car stopped turning over but I could hear the fuel pump making a noise. It eventually started and has been fine since. Found my 'lucky' coin underneath the rear seat too The Youtube video can be seen here: https://www.youtube.com/watch?v=uLJ65pmQt44&t=6s
×
×
  • Create New...