Jump to content
SAU Community

Recommended Posts

I just gave my S1 Stage a quick boost down some twisties towards the end of a long drive.

As usual when going hard i had 'Overdrive' switched off and 'Power' switched on. I think i also had the gear selector sitting in 2nd.

Anyway, at the bottom of the hill I put it back into 'D' and resumed regular driving (highway speeds, 100kph)

Whenever I put my foot down to accelerate in 3rd, the engine reved up but the gearbox didn't engage! (keep in mind O/D was still off)

I tried to switch back to 2nd, that pulled fine.

I put it back into 'D' and turned O/D on, and Power off. But still the same thing, where it would normally switch back to 3rd from O/D it just reved and didn't engage.

For the next 10mins on the way home I tried several different combinations, but still couldn't get 3rd to engage.

I also noticed when I parked the car in my driveway, the idle was pulsing from about 500-1000rpm.

Any suggestions???

Link to comment
https://www.sau.com.au/forums/topic/174795-auto-box-troubles/
Share on other sites

I've only ever had that happen once in my 32. (not shift into overdrive and sit at like 3,500rpm at 100. After a bit of a thrash.

Pulled over and shut it off - restarted and it was fine. Hasn't happened since.

When was the last time you got it serviced / replaced trans fluid?

I haven't started the car up since it happened. (few hours ago)

I've only had the car for a couple of weeks and all fluids were replaced at compliance.

It only has 2500km to go till 100,000km. so I was planning on waiting until then for a service.

Iwould book in for a trans service AND fluid flush ASAP. 1st and second in these boxes are standard bands, but 3rd is a wet clutch and it sounds like the clutch pack isn't engaging properly (just like a clutch in a manual doesn't engage or slips just before packing it in) This may not be due to the clutch being stuffed though, it may be due to a fluid pressure problem due to blockage or a sticky solenoid. Either way, a trans fluid flush and service will either fix it or give you a lot better idea what is wrong if it doesn't .

in the next few weeks I'll be taking my stag to MV Autos (SA, Blackwood) for a full trans service, flush 'n new fluid, and a stage 2 shift kit.

cant wait.

hitting (and holding) onto the limiter in first...... stupid highflow turbo :P

hey mate. had the exact same problem at round the same ks too. diagnosis was the shift solenoid is not engaging clutch packs properly. first and third gear use the same solenoid but you wont notice it in first till it gets really bad because of the tourque. the first sign of my problem was hitting the limmiter when third was changing under hard revs and it started to happen in first.. tip when fixing is go for a shift kit because its better for your clutch packs when the shifts are firm because of les slipage.

Get it serviced professionally as soon as possible. I dont just mean a fluid change, I mean someone who will open it up and check it out.

I've had an auto trans die on me before (lost all gears one by one within about a week, starting with 4th and working down). Much cheaper if it can be fixed early... :D

I've had the odd time when my stagea will free-rev but each time its been because the gear lever didn't click into the D position properly.

Hopefully its only a minor problem for you...

  genkin said:
I took it down to MV Autos today. Mike seems to be very knowledgable about Stageas.

Turns out my clutch has gone. So we are going to replace that and install a shift kit next week.

Nice, I've been wondering whether or not to get the shift kit, how much all up to have it installed?

Those of you with the kit, how much more pronounced is the gear change? Last thing I want is a clunk between gears.

I got mine done, mildest shift kit, 'stage 1' i think, slight jerk from 1st to 2nd, other gears are smooth and very quick. Plenty of topics talking about MVs shift kits with prices. Sent mine to MV, he modified it, sent it back around 3 days later, installed myself, quite a messy job, best given to a workshop to install.

Edited by chook
  chook said:
I got mine done, mildest shift kit, 'stage 1' i think, slight jerk from 1st to 2nd, other gears are smooth and very quick. Plenty of topics talking about MVs shift kits with prices. Sent mine to MV, he modified it, sent it back around 3 days later, installed myself, quite a messy job, best given to a workshop to install.

Yeah, being in Adelaide myself... and I definitely don't trust myself to do it anyways!

Is the jerk from 1st to 2nd noticeable even whilst accelerating "normally"?

Same prob with me the other day too. Lost first and fourth, then got first back and lost third. Then lost all except 2nd. Go figure, anyways, heaps of metal in box caused from moisture inside it somewhere. Prob from sitting in Japan, slight signs of rust on the tin where it should of been shiny. $2.5K to recondition, but I rang around and fluked a 2/h unit they guaranteed to work. Fitted it and its all good now. Defintely did not fit it myself, I would rather change the motor "again" before I attempt that. Now I have got a spare motor and box. Both needing a recond. One day they'll get the attention they need. :dry:

The boxes are out there and pretty cheap really, you just have to know where to look. The last one I sourced for a mate set him back a grand total of $120 leaving him with the old one to recon at his lesuire.

One thing I would really like to find out is, how much difference between the skyline auto and the stagea box is there? I have looked at both and I think it would be reasonable to assume that the transfer case will bolt onto the skyline box, but not having actually tried it, I am not sure.

Any takers to give it a go? Autos from skylines are really cheap due to everyone wanting a manual so it may be a good source of cheap parts that are allready here in Oz.

Very close yes, but not exactly the same. The clutch packs and torque convertor are the same, but the 4WD uses a bigger output shaft. I am thinking the same as you, just need to source a 2wd auto and have a workshop fit the internals to my buggered unit. 4WD uses the bigger output shaft where the transfer case bolts on apparently. I only know this from the auto shop that swapped my units over. F.Y.I. Nissan Patrol use a similar box RE403A 4WD and also the Mazda 20B cosmo thingy which is 2WD. Hence a little bit of background knowledge thank god.

  webng said:
Yeah, being in Adelaide myself... and I definitely don't trust myself to do it anyways!

Is the jerk from 1st to 2nd noticeable even whilst accelerating "normally"?

Its not very noticeable at all...but you will be aware of it. Its not uncomfortable at all and I'd 100% recommend it.

I'm from adelaide too so I just dropped the car off in the morning and picked it up in the afternoon. Cost me only a couple hundred more than just a transmission service...well worth it!

The gearchange is less jerky than driving a manual in my opinion :domokun: (nothing wrong with manuals, dont get me wrong - i'm just using it as a comparison).

Edited by pixel8r

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...