Jump to content
SAU Community

Recommended Posts

post-14136-1185869252_thumb.jpg

this is from the 1st page. i feel sorry for the forklift driver who has to take this thing off the pallets. how on earth did it get on one to begin with . ?

haha, I've seen it lots of times, normally they do it with two forklifts, on opposing sides of the car, lift it up while a bunch of guys quickly get the wooden pallets out from underneath the car, then they lower it again. They build the car up on two airline pallets so it fits into the plane sideways. Lamboghini, Ferrari etc would have a heart attack seeing their cars dangling off two small fork lifts.

Shane - there is only one. So if it was red with a white stripe - it's mine.

We put standard VIC Euro plates on it as the OZGT-1 ones are silly.

:down: Cool, thought it may have been. Couldn't get close enough cos a 318 in front of me was driving too slow :D

Shane - there is only one. So if it was red with a white stripe - it's mine.

We put standard VIC Euro plates on it as the OZGT-1 ones are silly.

Euro Vic plates on a Seppo car.... please explain? :rofl:

Actually i think i need to see this in person :D

Spotted a few things on my trip to Perth.

Firstly when I got there I went to take the car for a shake-down at AHG and found these there. An EVO X ready for the launch there the next day and Steve Jones testing his R35 for Targa West in a couple of weeks time.

21072008.jpg

21072008(002).jpg

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Working through possible solutions of converting my mechanical speedo.    Anyone know what type of speedo sensor the factory r34 gtr getrag has ? what the output is ? I assume its not a VSS and more a voltage like earlier speedo sensors ? Can an ECU read it ?  
    • roof rail delete used to be a thing, they were made locally for a while too
    • I can get more photos of it here soon and I plan to make a thread detailing the process. I received the car this way and it sorely needs refinishing. That is probably the most appealing photo of it. Up close it is fading, cracked, and needs to be re-glued. Depending on their condition I'm on the fence between refinishing or making a new set.  Another angle hiding the pimples and razor pumps  
    • According to this thread the RS4V with build plate RC40 comes with the R200 diff @ 4.083 ratio as well (mine has said RC40 denotation). We may need to check if the axle stubs are the same pattern as well. The auto subframes have longer axles. However I think yours being a later Series 2 as well, we should have the same bolt pattern for the diff stubs. Unless your upgraded rear also has upgraded axles. Either way, I would not be opposed to pulling the covers to check so I can inspect that  fancy rear core  Also I don't have HICAS. I don't believe that should change things but I hope the people here with heaps more experience than me can correct me if I'm wrong   Let me know if you want to attempt to make this work and I can get some pictures of mine from under the car. 
    • It's not that straightforward. For example I have had this code because my ignitor/power transistor wires were unplugged. It knows something is wrong but has no idea what it means. If you want to actually diagnose this I recommend following the service manual flowchart for code 21. Ohm out the harness, coilpacks, inspect the ECU, etc. And again, it's entirely possible for there to be no problem at all but if you're running a different coilpack it'll trigger the code because it doesn't like what it sees.
×
×
  • Create New...