Jump to content
SAU Community

Recommended Posts

  • Replies 42
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

LAST SEEN IN BASSENDEAN AREA LATE LAST NIGHT BEING DRIVEN BY YOUNG ABORIGINAL MALE

car is most identifiable by being totally stock, it also has some chrome sils down the doors and a piece of carbon fibre under where the cooler would be.

had plates on it [1CDZ702] which were stolen but have most probably been changed again

Link to comment
https://www.sau.com.au/forums/topic/181952-stolen-r34-gt-t/#findComment-3304740
Share on other sites

I live in Ashfield (right next to Bassendean), I'll go throw some laps after work and see what I can find. The bastards eye my car off everytime I drive past a house full of natives :action-smiley-069:

Eh look dat one der cuz shes a fast one!

Edited by bubba
Link to comment
https://www.sau.com.au/forums/topic/181952-stolen-r34-gt-t/#findComment-3304837
Share on other sites

fkn hell.. well in a way i would consider yourself ina way half lucky as if it came into the hands of someone who knows the car, they can jsut strip it and sell the parts and motor ect..

sounds like this guy is a drunk wanker who needs a ride to the pub.. ud have to be a numbscul to take a stollen car out on the street.

really hope it turns up so we can approach the prick with a wheel brace

Link to comment
https://www.sau.com.au/forums/topic/181952-stolen-r34-gt-t/#findComment-3305145
Share on other sites

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...