Jump to content
SAU Community

Brembo Break Setup

pavel
 Share

Recommended Posts

Blitz Grand Master

Blitz

Posted
Posted

Can you prove they are actually genuine BNR34 calipers?

I don't mean to bring your post into question but the paint and logo colour is wrong, and the Brembo logo itself is way off.

Owgasm Grand Master

Owgasm

Posted
Posted

They aren't R34 Brembos. From the colour and logos.

If you check the bracket where you bolt the caliper on. The bolt is larger and the hole is bigger itself aswell.

Blitz_R33 Mentor

Blitz_R33

Posted
Posted (edited)
What difference does it make. Arent they the same thing apart from the colour.??

Are you being sarcastic? Its like asking whats the different with a R32/33/34 GTR except for shape of the car?

Edited by Blitz_R33
FineLine Grand Master

FineLine

Posted
Posted
Are you being sarcastic? Its like asking whats the different with a R32/33/34 GTR except for shape of the car?

No I wasnt being sarcastic. The differences between those cars can be identified with careful scrutiny (that was being sarcastic)

I asked a question. Are the 33 and 34 brembos the same item other than a coat of paint?

GTRgeoff Grand Master

GTRgeoff

Posted
Posted
No. They are different.

Thus difference in cost.

Yes, 14mm holes as opposed to 12mm, otherwise exactly the same so no difference in value unless you must have gold.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share
Go to topic listing


  • Similar Content

  • Latest Posts

    • MBS206
      NC MX5

      By MBS206 · Posted

      This sounds like someone who would have owned an R33 in their past... It's okay, I'm 100% picking up what you're putting down Mark.
    • MBS206
      Jacks that fit under GTR lips that can reach the subframe?

      By MBS206 · Posted

      Just back on what was raised about jacking off the the tow/tie down point on the front of cars. I've used it plenty. I've also watched it on a car where you could see it move the front end of the car. It was like the front end/whole car being tweaked and twisted a bit. I will say, I struggle to find good jacking points on MOST cars. The ones that have good points, I then normally struggle to find a jack tall enough to make the car change height!   One of my go to points for either the jack, or the axel stands though, is either a suspension pickup point, OR a subframe to chassis major bolting point. I actually think its the subframe on my R33 that has a bit of a bend in it, from being jacked in the middle too. However, it could have been one of my many other cars I've had over the years! Or it could also be the from me jacking it up, and the fact the top of the front radiator support isn't there, so it can allow the front of the car to move and bend etc.
    • GTSBoy
      M35 Aftermarket Fuel Pump

      By GTSBoy · Posted

      My apologies. I forgot we were talking about weird beard M series stuff. Had been talking elsewhere with someone about an R33 with similar subject and got confused.
    • The Bogan
      NC MX5

      By The Bogan · Posted

      Nope, I don't like the look of ND RF, or any ND really, I don't like their faces or arses, why, because of their "modern" lines, the NC, whilst "modernish" has a more rounded shape that I like Well, that's how my overly judgemental eyes see it anyway  
    • Dose Pipe Sutututu
      M35 Aftermarket Fuel Pump

      By Dose Pipe Sutututu · Posted

      Should be more than fine, especially the overall fuel pressure would never exceed 3.5bar (assuming that thing never gets more than 0.5bar of boost in stock form). According to the chart, it's 11amps.
×
×
  • Create New...