Jump to content
SAU Community

Recommended Posts

  • Replies 83
  • Created
  • Last Reply

Top Posters In This Topic

exhaust cam gear + S-afc, thermal wrap the dump pipe + BCPR7ES-11 plugs with 0.9mm gap. Add a good clutch and a light flywheel for something that will get you close to a 12second 1/4mile on the factory turbo at about 10-12psi,will get your present 230hp on that dyno at less than 4500rpm (think BIG torque gains).

Killer T is the 2nd best Forum member skyline of any model(after Gavs R) on this dyno so far but his car is in its street set up Gavs was turned up for the Shootout. But the thing here at the moment could change that by another 200rwhp soon but I will keep quiet on that and the owner can shock you all at a Shootout in the future. Rob77 has a big weapon in hand(sounds bad)to garranty his 300+ club membership.450rwhp is the best GTS ever on my Dyno so far and 620 for a GTR ,740.4 is the best car ever

but was 8.2L drag car with lots of NOS.We are doing Blowen

big block on Alky soon that should make 1500-1700rwhp in a Vintage Willys Rod.

  • 1 year later...
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Ok thanks..that was my second question if i can somehow bypass this even with Nistune(that is all i have right now...aparat from stock ECU. So with some aftemarket it can by "bypassed" or make it work?  I know there is Link or Haltech (mainly used). We have ECUmaster here so i will gather some info about it.
    • Yes. You will need to get the original boost sensor and wire it in. That is.... if you plan to use a stock ECU - even a Nistuned ECU. The Nissan ECU will not operate correctly without it connected. And yes, it will do annoying stuff like you are experiencing. You will almost certainly be better off with some aftermarket ECU, than trying to hunt down rare sensors.
    • Ok so ABS/TCS is "not" the problem. Yeah i know now about the ABS with Nistune(i told that to the Nistune guy) but iam not 100% why or why i dont have ABS. ABS cube is in the engine (always has been) but i had braked couple of times rly hard and brakes just locked and scream. Does all Skylines have ABS cube? That boost sensor https://www.sau.com.au/forums/topic/367633-wtb-r34-gtt-turbo-pressure-sensor-pics-inside/ Is this it? I need to ask but i have a picture of engine bay and i do not see that (100% is not in that place) If i do not have this the car can do what mine is?(cutting around 4000 rpm) Here is the pic of my engine bay(only one i have) BUT i think i dont have that cuz loom was used from my RB20DE NEO and i know (obviously) that it does not have boost control or any wire to that...) so maybe that is the problem? (i dont know for 100% if that car where the engine is from had that)...but i dont have the loom from that
    • I'm with you here. It's either loom has an issue, OR, injectors are not functioning properly. It could even be they're just constantly dribbling, hence the wet, but not firing.
    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
×
×
  • Create New...