Jump to content
SAU Community

Recommended Posts

  • Replies 83
  • Created
  • Last Reply

Top Posters In This Topic

exhaust cam gear + S-afc, thermal wrap the dump pipe + BCPR7ES-11 plugs with 0.9mm gap. Add a good clutch and a light flywheel for something that will get you close to a 12second 1/4mile on the factory turbo at about 10-12psi,will get your present 230hp on that dyno at less than 4500rpm (think BIG torque gains).

Killer T is the 2nd best Forum member skyline of any model(after Gavs R) on this dyno so far but his car is in its street set up Gavs was turned up for the Shootout. But the thing here at the moment could change that by another 200rwhp soon but I will keep quiet on that and the owner can shock you all at a Shootout in the future. Rob77 has a big weapon in hand(sounds bad)to garranty his 300+ club membership.450rwhp is the best GTS ever on my Dyno so far and 620 for a GTR ,740.4 is the best car ever

but was 8.2L drag car with lots of NOS.We are doing Blowen

big block on Alky soon that should make 1500-1700rwhp in a Vintage Willys Rod.

  • 1 year later...
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • I’m not sure what happened I told them about sonic tunes free OTS tune and the next the I know .. I was booted..   To funny 
    • Yea - I mean I've seen my fuel pump which is decades old and uh, while I'm not saying this with real knowledge... but I sure get the ick at using anything in the fuel system that produced the state of that pump. Many years ago I went through multiple pumps (and strainers) before I dropped the tank to clean it out with extreme violence. I'm talking the car would do maybe 50km before coming to a halt, which resulted in me cleaning out the filter with some brake cleaner and going on my way. None of my stuff ever looked like what came out of your fuel tank. I don't think I'd be happy with it unless every single component was replaced (or at least checked/cleaned/confirmed to be clean here).
    • I'm not going to recommend an EBC pad. I don't like them. Just about anything else would suit me better. I've been using Intima pads for a while now.
    • Agreed, and in particular the earth strap that should go from the subframe to the chassis but it often broken or left off. There is a section in the R32 workshop manual you can follow for troubleshooting if you don't see anything suspicious, and depending where you are (there is no location on your user profile) you should be able to get your hands on a second hand replacement unit still if needed
    • Yeah they mention as a R34 for 2.5 Turbo...but then again thos "small" were also for R34 by that different site. But i look into it and that 310mm EBC is for R34 GTT. And by those you linked the specs are the same 🙂    EDIT: I found these on one site here: DBA 4000 series T3 DBA42304S They are 310mm...and it says are for R34GTT...are there good? EDIT2: ok they have pads too.  What "color" should i get for street use? I dont want/need some noisy ones...(and if they are not that dusty that is good too)
×
×
  • Create New...