Jump to content
SAU Community

Recommended Posts

Ryan in the red R33 hear, just to set the record straight troy and damo are the most pussiest skyline drivers i have ever seen. Both are too scared 2 push there cars to the limit both are crap drivers nether can put there cars sideways without spinning out of control. When you's boys are ready to play Ill be Drifting more sideways and racing harder and faster they both of you put 2gether. RED R33 DRIFTGOAT...

BARR... BARR... BARR...

GTS Skyline TopSpeed Record Holder 272@7340RPM

dude give a ****

1 day your gonna be wrapped around a tree

its u guys that give jap import drivers a bad name

every1 says it

all the cops know you

i dont give if i drive like a *****

i got the car cause i like the car

i didnt get it to have an ego and to drive it like an idiot

u sound more like a commodore driver

haah

made us piss

i know u would of but we did the LEGAL LIMIT

and how do i seem full of shit ? :D

also good sound system to me is better than havin a big turbo :(

for now anyway

u know another thing that happened

gave ryan in his red r33 a drag down ewans road

it was a dead even heat to the end

i thought i was gonna get owned

;)

Guest
This topic is now closed to further replies.


  • Similar Content

  • Latest Posts

    • Thanks MBS206, i got that PDF but got abit overhelm with all the connections and tracing of wires. I wasn't expecting to plug the dash harness anywhere. i was just going to use my electronics jumper wires to plug into the right pins like ECU power, ecu ground, ignition trigger etc... I do have a few ratchet straps locking it down tight. Fire extinguisher ready and only a small amount of fuel at a time, enough to submerge the pump.
    • Thanks GTSBoy, i will do abit more digging. I am missing a blue relay near the ECU connector... so i will chase that up in the next few days as well  
    • https://yariksteel.ru/manual/R33/Skyline_R33_elektroprovodka.pdf   Page 18 should be what you want for the Dash Cluster wiring. Though, you don't need the dash plugged in to get the motor running. What you want is power as how GTSBoy said. You need to power the ECU. Find in the above link the ECU pin outs (Verify them before just connecting them up from things written on the internet). Find anything needing power, give it power, find anything needing ground, give it ground. Then give the starter motor power through a big cable, and bridge the solenoid on the starter straight to power too.  ECU will be on, and when you give the starter power, it'll spin the starter motor, and it should start. I also hope you have a proper stand, and not just the engine sitting on some wood. You will want it bolted down properly.
    • Hello everyone, I am happy to join you.
    • Whereabouts are you, that looks exactly like Akira's old car....
×
×
  • Create New...