Jump to content
SAU Community

Recommended Posts

Well, for what must be about the most maligned Rb engine out there, it does ok. I mean over the standing half mile (where the rwd launch hurts vs AWD) , a Z-Tune on RE55s ran a 17.29sec, my little RB20 did ok to run a 17.98 at Shepparton Airport. A worked 996 Turbo did a 16.32...so its not just a peaky power figure either. For a 2L they can make a good spread of power and the dougy bottom end can be masked as its in a relatively light platform. No way you woudl want to be pulling any more then 1270kgs with only 2L.

  • Replies 49
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Posted Images

  • 3 weeks later...

There was a blue coloured R32 with stroked RB20 (RB24) that

I have seen for sale in Japan (built for dragracing) that produced

around 550ps.

Here's what looks like another stroked RB20 in a 180sx with a huge

T51R turbo and 600ps. Again the dyno's computer (laptop) has the dyno

chart -

http://www.youtube.com/watch?v=2PVE_im5l-M

Also there's a white R32 GTS-T with series 2 front bumper

(Australia) that produced around I think was roughly

319rwkw? with stock motor and roughly 358rwkw? with a

strengthened motor, cams, etc at a dyno competition. It

had RB25 gearbox, etc.

Here's another RB20DET in a S14 that produced around

335rwkw (449.8rwhp) -

I'm not 100% sure but I think that S14 dyno run was done

in Australia.

Edited by SKYPER

I wonder what a custom twin turbo setup would be like....maybe slap a couple of R34 N1s on running 24psi or something....im getting 322awkw with R34 N1s on 20psi in my GTR, I know the rb26 is probably a fair bit more advanced in terms of head flow and setup to achieve that easily but surely with only .6 of a litre capacity less you could still see some pretty good power figures with good spool time instead of a big single child eating turbo.

What does everyone else think?

Cheers!

Gagz

Edited by R31 Gagz
Correct me if im wrong but thats the 9 second GTSt i mentioned in an earlier post?

really?

well its in my mates shed at the moment its the 405rwkw one I was talking about

I didnt know it ran 9's in Japan

Mac go go ftw

edit

ah nah sorry Roy your talking about Red Zone(think) off the hpi vids different car

hence Mac go go above (thats the shop)

Edited by 1400r
  • 14 years later...

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • I've heard the Tomei USA head gaskets are decent if you want to o-ring the heads but otherwise not recommended.
    • The 296mm rotors are the R33 turbo brakes. The 310mm rotors are the R34 turbo brakes. The calipers are nearly the same, but not. They're the same caliper but the R34 caliper has longer legs so that it sits out far enough to go over the rotor. The pads are the same for both. When you say, "I bough tsome EBC"....did you just mean pads? Or rotors? 310mm rotors fit under 17" wheels. There may be some wheels without enough clearance though. I can't fit my fingers between the barrel of my wheel and the "corners" of my R34 calipers, but there is plenty of room behind the spokes. This is on Enkei RPF1. You can fit 324mm rotors inside a 17" wheel, but I'd be willing to bet that it would be close to impossible with the Nissan/Sumitomo caliper (using an adapter, of course), because the Sumitomo caliper is fatter than the Brembo caliper that is supposed to go on the 324mm rotors.
    • Hi. Can someone tell me what brakes(and mainly WHERE) can i buy brakes on R34 GTT? I bought some EBC which SHOULD go on my car(i have GT but it has GTT brakes) but it does not fit, Brakes are "too" small(296mm) Are 310mm be good or? I have 17 inch wheel so no "big boys" but for me driving i just need one that fits and i can get here in EU/Czech.
    • Since winter isn't that harsh anymore in Poland, i will definetely drive it 365 days a year 😉. But if the snow hits i will try it for sure and let U know. Only swap i am planning to do is of course R34 GTR front 😍.
    • Hey. Very valuable information about pitwork, I will pay attention when buying any consumable parts 🙏 As for the carpets - I got a handful of information from nengun, from which it appears that indeed the carpets for the driver's side are OEM. They are not able to show me any pictures due to the long chain of different sales entities but after I place the order, as soon as the goods arrive at the nengun warehouse from which they will send the shipment to me they can send me photos and if my purchase differs from OEM I can immediately return it / cancel the purchase. I think I will give it a try 😉. Of course i'll let you know what's what as soon as i get them P.s. I know the topic is not relevant to the thread, but both nengun and amayama have these SICK 😍 trunk room lamps available. Do you know anyone who ordered them? I need to have one in my car
×
×
  • Create New...