Jump to content
SAU Community

Recommended Posts

Thanks for all the replies! Where to start...guess i started learning about imports and engines through my boyfriends and their mates. I picked things up quickly and just found that when it came to digging into an engine i was always up for getting my hands dirty. The passion manifested from there started learning more and more about how everything works with engines and turbos and how the differences between various engines produced more or less power. I'm actually a nursing student in S.A. lol and alot of people were surprised when i came out of the closet (so to speak) and bought my baby. So cheers again and heres some pics.

post-47417-1202443935_thumb.jpg

post-47417-1202444004_thumb.jpg

post-47417-1202444075_thumb.jpg

heya cass welcome! thats a pretty full on BNR32 u got there... kinda makes mine look..... weak.... baahahaha

what is it with you guys and ladies joining the forum... first question is always pics!

ull find us a bunch with alot of knowledge in every department and always happy to help... just avoid the forum during school holidays.. u'll find out why!! puts us to shame!!

all the best for u and your stunning new Bnr32 aka godzilla

also... mods and dyno results??

peace

mark

Edited by jenkies

wow that bonnet is a pretty nice design. do you know where the previous owner got it (I'm assuming they put it on) or what model it is if you don't mind me asking?

car's hawt. good buy.

Welcome welcome!!

Nice to see more girls in GTR's!

I'm a 22 year old chick as well and have an R34 GTR :thumbsup: We should start a GoddessZilla Club hehe

Best wishes!!

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • UPDATE: Yes the GSP Axles are compatible. I installed it on my R34 today and they are working a treat! Turns out that the S13, S14, S15, and 200 SX all used the same axles as the HR34, and ER34 NA models. Which is 2 bolt x 3 pairs.  
    • Also build this EH ute with 370z motor and gearbox with a couple of turbos just for fun.  
    • Got the passenger door on plus the master cylinder and booster. Loaded up to take it home. At home, the colour changes a lot in the light.
    • Nothing cheap, but I have seen the AC Hydraulic DK13HLQ which is pretty close to what you're asking for. The problem is the hydraulic cylinder mandates that the back of the jack be a certain height and Skylines have fairly deep inset floor jack points. A more certain and cheap option is to get some nominal 2x10 inch lumber boards and have one board be 1.5 feet, the other board 3 feet. Glue it all together with lots of clamps to maintain pressure. Make two of these. The ramp suggested above is a good idea, it takes quite a bit of clutch slip to get over each of the boards. I only need the first ~1.5 inches for my low profile jack on a standard ride height car but a lowered car you want to go up to the full ~3-3.5 inches. Paint it or store indoors if you want it to last.
    • Ok. And Nistune? I read (here too) mainly on Stagea threads that it can by "turn off" with Nistune. But they say they still had the sensor plug in. Next week iam going to the Nistune(and other ECUs) tuner so i can finally make it work. I drove the car home and apart from the cut it drove great. No misfire no smoke no hesitation or rough start...so hoping it is this sensor that is missing  
×
×
  • Create New...