Jump to content
SAU Community

Radiator Air Deflectors, New Group Buy (no 5)


Recommended Posts

I'm interested, but in the middle of a GTR front end conversion for my R34 GTT... What are my options then chief???

  • Replies 113
  • Created
  • Last Reply

Top Posters In This Topic

HEy all.

Current list looks like this..

STAGEA Series I

Xmetal

STAGEA Series II

None

R33 Series I

_Scotty_ (Bare)

rd-runr (Bare)

Scadtional

H@ME

reflexman

Krishy

Dan_AE86

R33 Series II

SkyKC

bnew

Silver_R34_GT-T (Bare)

Rhinorebel (Bare)

cjpwrx

t.head_wood

STRYKR 33

sfrizza

typevu

ToMMaH

GtstCoupe

Pauly33GTS-t

bryno

inthisglass

R33 GTR Series III

None

R34 GT-T STD BAR

Silver_R34_GT-T (Bare)

mr_tea_pot

Hopeyz

yld34t

jrm

fishy

Howie

uncouth32

putraged

viet_boi

jeffboyracer

R34 GT-T Nismo Bar / Series II

Magic

lastarfighta

wisey18

charlie22

R34 GT-T Aftermarket bar

Icy

Thanks for the update bass junky.

Just a correction... mine is a R34 GT-T Nismo Bar not a R34 GT-T STD BAR.

Cheers again.

Inline with GB rules about having a start & end date - this is now closed.

http://www.skylinesaustralia.com/forums/Th...Gro-t81129.html

SAU is clamping down on these GB's that never occur, never end, and so on.

PM me if you have a problem. However, before you PM me think about this.

A group buy, is a group of people buying the product together to lower the price.

Buying single units here and there is not what constitutes a GROUP BUY

Thanks

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Yeah well per the video it took 15s for the stock unit to start up....even if I give it a few seconds discount for starting that is at least 12 sec before you get a reverse camera if you are trying to leave a park.  The android unit is way faster, but 2016 for the stock unit is a long time ago in consumer electronics
    • Yea that’s why I said ima test them with multimeter and see the reads.
    • Only at idle. Isn’t a problem when rev it seems.
    • @Haggerty This seems silly to ask, but are you confident in your ability to tune the Haltech?  
    • Next on the to-do list was an oil and filter change. Nothing exciting to add here except the oil filter is in a really stupid place (facing the engine mount/subframe/steering rack). GReddy do a relocation kit which puts it towards the gearbox, I would have preferred towards the front but there's obviously a lot more stuff there. Something I'll have to look at for the next service perhaps. First time using Valvoline oil, although I can't see it being any different to most other brands Nice... The oil filter location... At least the subframe wont rust any time soon I picked up a genuine fuel filter, this is part of the fuel pump assembly inside the fuel tank. Access can be found underneath the rear seat, you'll see this triangular cover Remove the 3x plastic 10mm nuts and lift the cover up, pushing the rubber grommet through The yellow fuel line clips push out in opposite directions, remove these completely. The two moulded fuel lines can now pull upwards to disconnect, along with the wire electrical plug. There's 8x 8mm bolts that secure the black retaining ring. The fuel pump assembly is now ready to lift out. Be mindful of the fuel hose on the side, the hose clamp on mine was catching the hose preventing it from lifting up The fuel pump/filter has an upper and lower section held on by 4 pressure clips. These did take a little bit of force, it sounded like the plastic tabs were going to break but they didn't (don't worry!) The lower section helps mount the fuel pump, there's a circular rubber gasket/grommet/seal thing on the bottom where the sock is. Undo the hose clip on the short fuel hose on the side to disconnect it from the 3 way distribution pipe to be able to lift the upper half away. Don't forget to unplug the fuel pump too! There's a few rubber O rings that will need transferring to the new filter housing, I show these in the video at the bottom of this write up. Reassembly is the reverse Here's a photo of the new filter installed, you'll be able to see where the tabs are more clearing against the yellow OEM plastic Once the assembly is re-installed, I turned the engine over a few times to help build up fuel pressure. I did panic when the car stopped turning over but I could hear the fuel pump making a noise. It eventually started and has been fine since. Found my 'lucky' coin underneath the rear seat too The Youtube video can be seen here: https://www.youtube.com/watch?v=uLJ65pmQt44&t=6s
×
×
  • Create New...