Jump to content
SAU Community

Recommended Posts

yeh i got a fuel smell in the car, but it only seems to come around when im low on petrol. friend suggested leaky injectors (apparently a problem for vls), really dont know...i wana get it fixed up cuz well i dont wana have to keep lying to all the girls and saying things like (the car is so high performence that it has to have that smell).

i looked around the forum, couldn't really get any ideas (also if ure not 100% sure what it cud be, but have an idea dont b shy we're all nice skyline loving ppz here :P)

thanks in advance :ermm:

Link to comment
https://www.sau.com.au/forums/topic/218406-fuel-smell/
Share on other sites

Fuel filler cap is leaky.

Usually compliance, they dont use fuel resistant sealer around the insert for the fuel filler.

It'll cost you about $5-$10 for a tube from Repco from memory, follow the instructions and away you go.

i gota say...that was quick :P... i took a look at the sealer seems to be fine.... im gona re-seal it and see whether nething changes :ermm:.... if ne1 has any other suggestions (besides changing fuel lines) it be good to hear them just incase this doesnt work out and for ne1 else that might have the same problem :D

thanks

Link to comment
https://www.sau.com.au/forums/topic/218406-fuel-smell/#findComment-3853093
Share on other sites

Its just fuel resistant silicone or something along those lines, i forget the name of it its been so long since i used it.

Repco, Bursons etc, just go in there mate

yeh i'l check it out tomorrow...thanks :P..going to sleep...

Link to comment
https://www.sau.com.au/forums/topic/218406-fuel-smell/#findComment-3853169
Share on other sites

if it is the fuel filler seal you'll also get a fuel smell when you make hard right turns (fuel filler is on left). There's a couple of different sealers that I went through before I found one that worked. I tried Sikaflex 221, then loctite something. but these were soft setting so whenever I'd do up the petrol cap it'd turn the insert slightly until it eventually the seal broke. Then i bought selleys knead it, which is hard setting and i haven't had that problem since.

Link to comment
https://www.sau.com.au/forums/topic/218406-fuel-smell/#findComment-3853341
Share on other sites

It is also worth checking the fuel lines running in and out of your fuel filter under the bonnet to see if they have aged...although the fact it only happens when low on fuel seems to discount this theory. I used to get a slight fuel smell in my car...found the lines had cracked due to aging and after I replaced them problem was solved.

Link to comment
https://www.sau.com.au/forums/topic/218406-fuel-smell/#findComment-3853482
Share on other sites

It is also worth checking the fuel lines running in and out of your fuel filter under the bonnet to see if they have aged...although the fact it only happens when low on fuel seems to discount this theory. I used to get a slight fuel smell in my car...found the lines had cracked due to aging and after I replaced them problem was solved.

Yep, well worth a look. Had the same problem with my car. As soon as I changed the fuel lines, it was all good.

Link to comment
https://www.sau.com.au/forums/topic/218406-fuel-smell/#findComment-3853619
Share on other sites

um im not sure if it makes the sound when fuel tank is open... i dont think so :S...neways i bought some hard setting gasket type stuff :S....it says that its fuel resistant so im gona give that a go tomorrow (it only cost 6.50) and i'l let u guys know....but from inspection the seal looks alrite..but i do remember seeing lil lines coming down the quarter panel..so jeh lets hope its that and not the fuel lines...cuz i seriously dont wana go through the pain of taking off fuel lines from the fuel filter :@... that was the biggest bitch in the world

Link to comment
https://www.sau.com.au/forums/topic/218406-fuel-smell/#findComment-3855528
Share on other sites

I am having a similar prob with my R33 GTST. Fuel smell now and then. I thought it was over sized injectors, but now I am not so sure, maybe my lines have perished. Wont be the filler cap because the smell is entering the cabin whilst driving straight, like its being blown in. Will check lines next weekend...piece of mind I have an extinguisher on board!

Link to comment
https://www.sau.com.au/forums/topic/218406-fuel-smell/#findComment-3857916
Share on other sites

I am having a similar prob with my R33 GTST. Fuel smell now and then. I thought it was over sized injectors, but now I am not so sure, maybe my lines have perished. Wont be the filler cap because the smell is entering the cabin whilst driving straight, like its being blown in. Will check lines next weekend...piece of mind I have an extinguisher on board!

lol to the fire extinguisher...:)

Link to comment
https://www.sau.com.au/forums/topic/218406-fuel-smell/#findComment-3858719
Share on other sites

  • 2 years later...

I'm getting the fuel smell now, after changing my fuel pump last weekend. My tuner suggested it is the black round rubber fuel tank seal (not on the fuel filler cap), its the one inside the boot under the plastic cap that seals the tank. It is a b*tch to fit and the big plastic cap screw-on that comes after it is worse, have to tap with hammer..

Car is R34 and I think I got the seal in right - had to wedge the edges in with a flat screwdriver, but still theres a smell from boot area??? aaaaarghh - do i need a new seal or re-fit the existing????

Link to comment
https://www.sau.com.au/forums/topic/218406-fuel-smell/#findComment-5766903
Share on other sites

I'm getting the fuel smell now, after changing my fuel pump last weekend. My tuner suggested it is the black round rubber fuel tank seal (not on the fuel filler cap), its the one inside the boot under the plastic cap that seals the tank. It is a b*tch to fit and the big plastic cap screw-on that comes after it is worse, have to tap with hammer..

Car is R34 and I think I got the seal in right - had to wedge the edges in with a flat screwdriver, but still theres a smell from boot area??? aaaaarghh - do i need a new seal or re-fit the existing????

Thats one old thread you revived buddy lol.

Check the hoses mate. I had the same problem with mine after I changed the fuel pump, you put in a higher output pump? Open up the flap where the fuel pump is located, get somebody else to turn the ignition on and see if fuel squirts from a crack in one of the hoses. Mine was a split hose and you are only able to tell once the car was switched on.

Link to comment
https://www.sau.com.au/forums/topic/218406-fuel-smell/#findComment-5767027
Share on other sites

U mean u dont have the rubber seal insert? Man thats dangerous, u can have a lot of fuel leaking out / poor fuel economy and danger from cigarrette smoke / spark etc

I don't have the piece of metal that restricts which pump nozzle u can put in to fill the car. My fuel tank and associated pressure etc is fine. I just have the normal factory fuel hole :P which is exactly the same as the one I had in my aus delivered pulsar before I bought the skyline. All I'm in danger of is accidentally putting diesel in... Which I'm not stupi enough to do

Link to comment
https://www.sau.com.au/forums/topic/218406-fuel-smell/#findComment-5767052
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • ok so if i wanted to go 18's i would go for 8's  in front 30+ or 32+ off set at front and the back 9 would be ok? what offset should i aim for.. then can i do some  hunting for wheel rim choices..    If i get this - will this fit all around: Size: 18 x 8.5 +37 - n what tyres size tyre should i get for front n back?  
    • Absolute f*cking nightmare. I had to take breaks constantly, and I was always pissed off when I got home. The line split in Italy on day 2 (we drove from the Netherlands), lol. Driving any narrow European town was... well, sh*t.   Appreciate it man. Here, I'll just drop a favourite from the load I took on Saturday.   I'll update here when things happen with the car, the thing is, with stock power and almost everything chassis-wise taken care of, there really are no problems. 268,000kms now and counting.  
    • Ah! I actually managed to snag a lightly used set.... that aren't so suitable for me right now. They don't work on a GTT without some cutting or creative heat moulding. I thought about reselling them myself cause I didn't want to murder them, but it looks like I'm probably going to attempt to murder them/melt them because I may as well. @GTSBoy @PranK can somebody close this thread?
    • Hey mate,  I have a set, one is slightly damaged but wont be noticable once installed.  Shoot me a message if your still after them 
    • I couldn't wait But, the black constant tension hose clamps were too thick and there wasn't enough clearance at the T/B and I couldn't get it to seat properly, so I had use a silver one there I also added some 3" silicone over the alloy bit that goes through to hole on the radiator support as it looked like it was sitting on the edge of the hole in the radiator support, I never noticed a rattle or anything, but there was a witness mark It is basicly done, and I can live with the silver hose clamp at the T/B, I will get a black clamp for the head vent though where it is attached to the bulkhead fitting  It never stops...LOL, only issue now with the shock tower brace is it slightly touches the under bonnet liner now, if I leave it it will either wear some paint off the brace where it touches, or damage the liner, so I removed the liner to see what I have to work with, with the liner removed I have about 20mm of clearance, but sadly the middle part of the underside of the bonnet is only dusted with paint and looks crap, so I cannot have that, but.... as I have a roll of Carbuilders premium under bonnet insulation in the garage laying around that is only 5.5mm thick (we were going to use it on the boys Patrol, but he crashed the front of it a few months and it was written off, hence why he now drives my old Honda Accord Euro), I'll use the OEM liner as a template and get the Carbuilders stuff fitted up to cover that dusted paint up
×
×
  • Create New...