Jump to content
SAU Community

Recommended Posts

Just got the car back from a big-ish service incl all oils changed, fuel filters, gapped spark plugs etc and noticed that if I rev the engine and hold rpm somewhere between 1500 and 2500 rpm (I didn't try higher because I didn't want to attract attention to myself..) while the car is sitting idle in neutral, there's a muffled popping sound followed by a small shake (drive seat shakes noticably) every few seconds ..sometimes more than one in a row.

Like popcorn starting to pop ..just more muffled sound, and each pop shakes the car a bit. Is this just the exhaust note or should I be worried ? Detonation? Car's ecu was tuned before the service and it was NOT pinging/detonating...

The car's an R34 GTT with a turbo-back exhaust with a 3" catback (HKS SilentPower)

I never noticed this before but then again I never held the engine at 1500rpm for a few seconds before either..

Link to comment
https://www.sau.com.au/forums/topic/231130-popping-sound-and-car-shaking/
Share on other sites

hm are you sure this is missfire? I searched for "Popping" last night and read a lot of older discussions and a lot of people seem to be under the impression that these popping sounds are normal on skylines and a few said it's probably due to running rich in that rev range .. no mentions of missfire anywhere.

I have no idea which plugs they put in ... I'm taking the car back to unigroup to have a listen to this. Could it be due to old fuel? car's been at the shop for was 2 weeks and only 1/4 of tank of fuel sitting in it

Edited by Delta Force

mine runs rough in the same situation. though in mine i put it down to section of the map thats never been tuned.

It's just a rich miss and nothing to be overly concerned about. It's something tune related and i wouldn't expect it's a result of a service. I'm pretty sure unigroup will tell you the same thing but it doesn't hurt to have it looked at if you are concerned.

Took it back to unigroup and as soon as Yavuz heard the popping at idle and low revs he said "yep it's misfiring" .. and that it's due to the small gap (0.75mm) so they regapped the spark plugs to 1mm and no more misfire/popping sounds ;-) Best of all ..they did it all for free! That's good service. Cheers.

Took it back to unigroup and as soon as Yavuz heard the popping at idle and low revs he said "yep it's misfiring" .. and that it's due to the small gap (0.75mm) so they regapped the spark plugs to 1mm and no more misfire/popping sounds ;-) Best of all ..they did it all for free! That's good service. Cheers.

Hey mate was yours the black r34 there? I was there about a week ago also.. had a safc tune. Mine is doing the same thing and yavuz said its normal with running small gapped plugs.. Funny i also hear it pop every now and then only on idle

just one thing ... Yav also mentioned that the car may misfire at higher rpms with bigger gap (and non stock boost). But for me that's not really an issue as a very rarely go above 4000rpm anyway (daily driver)

  • 3 years later...

sorry to bring up an old thread but i think my input is relevant and not worth starting a new thread.......

i have been experiencing the same muffled popping/rumble sound then shaking when car is idling after cold start. i noticed the rumble and shaking start to settle down after the engine oil had warmed up to about 90 degrees.

couldn't figure out what was wrong, then 2 weeks later the check engine light came. it turned out an exhaust leak at the rear muffler was causing the rumble and shake while idling.

the leak was at the weld joints along the exhaust pipe that had started to rust. this was probably making the car run a little too rich as well, but i could be wrong.

cheers!!!

mine does it too at idle, is normal. atm mine has a dump pipe like 6 inches long and is running Super rich so it sounds worse, gaps are .8. is perfect when you apply any throttle though all the way to 7000rpm

mine does it too at idle, is not dangerous. atm mine has a dump pipe like 6 inches long and is running Super rich so it sounds worse, gaps are .8. is perfect when you apply any throttle though all the way to 7000rpm

ah crap that effort to edit a post was ABSOLUTE FAIL

Edited by PaulosECR33

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Ok cool, because I do have some OEM BMW options for light(er) wheels. 17x8.5 M Sport wheels are 11kg and I could put 255's on them. Maybe that's an initial test.
    • So, in the effort of pulling apart airboxes and testing enclosures to see if this aids in MAP loss at WOT I noticed: 1) The ducts up the OEM intercooler holes from the front bar help IAT drastically, whether the pod is shielded from the engine bay by an airbox missing a lid, or an airbox WITH a lid. Plus you get more induction sound without the lid. Having half the airbox (with no lid) acting as a barrier to the headers seems to help. 2) For shits and giggles I checked the TB. This was full pedal travel. This is actually full travel of the TB. Photos aren't perfect, but there was definitely an amount of play in it and it wasn't against the stop. After much swearing and adjusting the pedal, I realised that the cable is actually too long for the skyline pedal travel to fully articulate it. Having the pedal adjusted so WOT was actually hard open on WOT resulted in an idle of 3500rpm. As an aside, this was also the TPS registering at 3.1%. I removed the above to give the pedal enough travel to actually fully open the TB. I now get a satisfying 'thonk' on full open and full closed which you can hear pumping the pedal as it hits the TB stops (with the bonnet open and intake back on). Luckily for me, the screw screws into a raised metal boss under this plastic piece that is now acting as the new throttle stop. I've gained about 20mm (ish) of pedal travel and I can move it maybe a mm or two post open-thonk before it's hard against the stop. After all of this I did a bit of road tuning because a 102MM throttle is sensitive. The difference between holding an 950rpm idle and instantly stalling is about 0.4% of TPS movement. Will that help? I suppose it can't hurt. I set 'closed' point back to where it was, I can definitely feel the extra pedal travel that is needed to actually open the TB fully. But this morning I dropped the car off at Paint Jail again, so who knows when this will re-eventuate out to see if it helps with the top of the dyno hitting a ceiling.
    • Take heart that everyone else seems to have found a way. The OEM S1 indicators do slot in pretty firmly. It may simply be a case of having them sit slightly looser and nobody actually ever noticed this when attempting to remove a indicator from a JSAI bar :p
    • If the original NA ECU has a separate TCU then you are going to need to reroute wires that used to run between the trans and the TCU to the appropriate (1 to 1 equivalent) pins on the ECU. Other than that, it should work. Look up posts by @Kinkstaah on the subject.
×
×
  • Create New...