Jump to content
SAU Community

Gold Coast Cruise On Sat 30/08/03


GODRAVER
 Share

Recommended Posts

Any1 interested in a cruise this saturday around gold coast? everytime some1 posts a cruise theres barely any1 showing up.

The last cruise - gold coast and brisbane crew... there was 2 cars from gold coast (and the meeting place was in gold coast as well! the rest came from brisbane...) thats it! thought we can do better than that...

So is any1 interested in a cruise or meet this saturday? and drive throught the coast and a few highways...

Place - where ever

Time - 20.00

Day - Saturday 30/08/03

Link to comment
Share on other sites

ok thanks for the advice chaos...

in that case if any interested in the cruise just reply yes its a good idea or nah i got better things to do... later on ill post a meeting place via pm or ********* and bob's your uncle.

besides its not like a cruise is illegal anyway if the cops want they can come as well and join us.

Link to comment
Share on other sites

i almost got pulled over by an off-duty cop around my mates neighbourhood yesterday. good thing i didnt stop after that wheelspin or else he would've given me sh*t, my mate said the cop was running after us.. :S

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
 Share



  • Similar Content

  • Latest Posts

    • Got some decent progress after work yesterday and also today. Got the ECU all wired and passenger side interior all back together. Kept the wiring up nice and high to avoid people standing on it. Got the surge tank relays rewired and tidied up the pump wiring and cut a hole to bring the cables through.  I found a spare USB cable I had lying around so I decided to cut it up and see if I could use it for my CAN 1 bus. Turned out one of the pins I needed was to the shield of the cable so i cut it up and desoldered it and resoldered to the correct pins.  Had the issue with the powersteering hose hitting the A/C compressor and fan shroud. I pulled the bracket off and modified it to remove the front mounting point which now clears it all. Will keep an eye on it to see if theres any signs of fouling once it's up and running.
    • That's some good input mate. Nice.
    • So today I went well outside my comfort zone (again) to replace my valve cover gasket.  I have had a big leak over the exhaust leading to a lot of smoke and smell every time I drove it. The leak was in the rear driver's corner.  The job wasn't hard as such, just a bit finicky and time consuming.  The old gasket was rock hard and broken right where the leak was.  The leaky corner had so much sitting oil in it.  The good news to my amateur eyes was no buildup or sludge under the cover. It all looked fairly nice in there.   I haven't started it yet. I ran out of light and body when putting the coils and injector loom back in. Probs only 30min left for the morning.  I was so nervous putting the cover back on, I must have lifted it 5 times to make sure the gasket was still seated properly. God it's going to be nice to be leak free and not make other traffic light queuers think my car is about to explode.
    • Gave the Mazda it's first wash, it will need some clay, a light compound, and polish polish to remove a few swirl marks, but that will be a job for when I have a full day to get my DA polisher action on
    • Just did this job on my 32 with the boost doc kit. was quite simple to fit, hardest part was getting the rubber bungs back on the firewall. does anyone know how the heater will work now without the flap in the bend? Will I just have a heater on 24/7 now?
×
×
  • Create New...