Jump to content
SAU Community

Recommended Posts

guys has anyone got any idea what this ticking noise could be coming from my car? (other than a bomb)

it only happens sometimes... like tonight i filled up at the servo... took off... went to do a u turn and gave it a bit of stick round the corner... went to the lights and it started ticking! sounded like a metal ticking noise... quite loud.

then when i got home and went to check it out it stopped... well it stopped b4 i got home...

its happend a few times recently... seems to be after i give it a bit of a caining... but then again i took it around the rds just then and thrashed it and nothing... sounds normal.

Link to comment
https://www.sau.com.au/forums/topic/25977-ticking-noise/
Share on other sites

If its a turbo gasket you'll here it eminating from around the turbo (obviously), and it'll gradually get worse.

Thats what mine did.

When it starts ticking again, get someone to rev it and stick your head near the turbo and have a good listen.

Though my noise didn't come and go as yours does?

Link to comment
https://www.sau.com.au/forums/topic/25977-ticking-noise/#findComment-551859
Share on other sites

cool... hasnt done it for ages... oil is fine theres no leaks anywhere from what i can see... but eric ur suggestion sounds like it could have some merit as it did end up going away once the car was warmed up properly... mind u it hasnt happend since i posted this :)

Link to comment
https://www.sau.com.au/forums/topic/25977-ticking-noise/#findComment-551964
Share on other sites

Originally posted by pushead

the noise comes on right behind the dash right? like a clinging ticking noise but after the car is warmed up properly its ok .

yeah i get that too

its like a creaking sound but once the engine is warm it goes away

what is that?

Link to comment
https://www.sau.com.au/forums/topic/25977-ticking-noise/#findComment-557001
Share on other sites

I also get this ticking noise when I first start the car up from cold. Idles for about a minute then goes away...dosen't sound nice when it does it though...

It's not the lifters or injectors, very loud and distinct, and only happens when I start it in the morning.

I have read a few other forums and could it be the oil pump not working properly when it's cold?

I think we all would be GREATLY appreciative if someone knows what is happening...

Cheers

Link to comment
https://www.sau.com.au/forums/topic/25977-ticking-noise/#findComment-560394
Share on other sites

I had a decent listen this morning (sat) and I think it sounds like the lifters or something in that part of the engine, because it stills make noise after its started, so possible not the starter motor or something....I have no idea really, take it to the experts when I can...

Link to comment
https://www.sau.com.au/forums/topic/25977-ticking-noise/#findComment-565133
Share on other sites

  • 3 weeks later...

just to let anyone know still interested in this, I haven't been able to get to Ice Performance yet, but I found out (I think) why my engine was making a ticking noise; I was parking on a lean and the oil must of drained almost completely out of one side of the head and thus when I started it in the morning there was no oil there to lube up the cam and lifters, etc. until the pump got the oil up there. Have been parking on level ground since and not one ticking noise!!

hoorah!

Link to comment
https://www.sau.com.au/forums/topic/25977-ticking-noise/#findComment-587603
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Depending on how long the car sat it is very possible for injectors to be stuck open or closed, I'd get them cleaned and flow tested. Other than that, obviously when the loom changes and the car doesn't start any more....the loom is suspect so some tracing / comparing may be required
    • Harness is for a s1 Rb25det, and it is engine and lower harness.  the old harness had broken off plugs and was in very rough condition/exposed wires and splices etc. it is not able to be put back on the car, I could visually inspect to see if they had rewired any pins on the ecu plug. The fuel pump definitly isn’t turning off it’s an external pump and very loud you can hear it. Will look at the other harness tonight, am also going to pull the fuel rail and watch the injectors spray, will update here with what I find. Pretty sure at this point it has to be something to do with injectors because car will fire up on starting fluid and cas is clicking the Injectors. Fuel pressure is steady 43psi 
    • Check the injectors flow evenly, and are actually flowing what you and the ECU think they should be flowing. If it's starting up on starter fluid, you have a fuel issue. Is it possible under cranking your fuel pump is turning off?   The harness you replaced, is that the whole engine harness? Do yourself a test, and drop the old harness on and plug it into the Z32 ECU. It's possible they've wired things different. From memory S1 to S2 is different in RB25 and you may have a wrong loom
    • I haven’t pulled the injectors to watch them spray yet but they are clicking from the cas and all of the spark plugs are wet with fuel. I’ve thought the cylinders were being flooded from the beginning and was hoping fuel pressure would fix it. Tonight I am going to pull the rail and watch the injectors spray. Don’t know how to test/diagnose if the plugs are firing in correct sequence but that should be a timing thing and as far as timing goes my car still has the half moon for the cas can only install it 1 way. And my mechanical timing is 100% correct I posted photos above. Confirmed with the balancer on and off. 
×
×
  • Create New...