Jump to content
SAU Community

Recommended Posts

Goodmorning peoples

ok.. as many of u may be aware

before the autosalon i said that i would organise a club shoot for skylines australia for HPI magazine

well i think its about time i did so.

Firstly ill put up a poll to see the interest that the idea generates then we shall take it from there

All cars in the shoot must be a nissan skyline of any series

Thanks

ambz

Link to comment
https://www.sau.com.au/forums/topic/26147-skylines-australia-in-hpi/
Share on other sites

  • Replies 52
  • Created
  • Last Reply

Top Posters In This Topic

Am I allowed to post in here Matty? [smoothline] ? :P

I am keen too ;)

Get Ben Ellis to bring his Black 34 Project car down for the event - heck we could even get about 5 or 6 black 34's together...ourselves - which is just silly :S

good voting options btw :P cbf

This is good timing Amber.

Will be great if we can get club membership shiznit sorted beforehand so we can have details in the mag.

Dale: Ben is selling his GTT. Is on eBay: http://cgi.ebay.com.au/ws/eBayISAPI.dll?Vi...&category=45571

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Did you pay with a credit card? I'd be putting a charge back through then finding a new sparky to sort it out. 
    • If you mean the alarm immobiliser; theyre internal to the alarm itself which makes that difficult; I couldnt even see where he put it; its not in the same place as last time; but with all black wiring it might be very challenging to trace  I had someone turn the key for me as I know it only primes for a couple of seconds As my post above; I am getting no voltage to the pump at all; but I am testing continuity of the power line (SB) from the pump plug to the relay fine. As well as the negative from the pump plug to a 12V constant.    Yeah; he blammed the no start on a bad battery; said I needed to get a new battery and it'll start. Turns out the battery drained because the tail lights had been on for half the day during the install (the rubber cushion on the brake switch gave out while he was testing it as I have a picture of the car from that morning with the tail lights off..i've replaced that). The battery was turning over the engine just fine for a long time; but got low since lights were draining it so it was too low to test a start after he finished. I bought a new one on his advice...$250 wasted. My original battery charged up just fine and is healthy.    It was running perfectly fine when I messed up the old alarm (programmed out the remotes). He couldnt start it after removing the old alarm; my assumption is that when he unhooked it; he didnt bridge the circuit back when trying to start it. Its always been perfectly fine. The ECU swap and pump were 2 years ago. It's never missed a beat in that time. 
    • This is a big issue for me without the diff. I just have zero drive from the passenger side when drivers side has no traction. Bec's parents place has a crazy steep driveway with odd camber and I have never been able to get up. My bro-in-law's 130i with an (unknown brand) LSD gets up fine as does their dad's Hiace. My car stays at the bottom. We have other odd camber roads around here as we're elevated a bit and if it's raining I can get totally stuck around some hairpins. 
    • Yeah, I am super excited for this.
    • Was the car running before he touched the car?
×
×
  • Create New...