Jump to content
SAU Community

Recommended Posts

Photo's of my poor baby after going sideways through a roundabout. Didnt see it, no give ways signs or roundabout signs, a lamppost was out one was lit but it wasnt enough. Locked up the brakes the car went sideways as I tried to steer around the rounabout, blew the drivers side rear tyre and then beached itself on the far corner in some sand between the kerb and the footpath. It seems I was quite lucky, the sideskirt is beyond repair I think, and I had to put some new rubber on (so I went ahead and put the 2 18" rims I had on the rear) though it seems I need a wheel allignment as anything over 100km/hr and the wheel vibrates.

Link to comment
https://www.sau.com.au/forums/topic/26836-roundabout-carnage/
Share on other sites

Originally posted by skyzerr33

so whats it like to drive with the space saver?

Scarey. I wouldnt want to be driving on it too much, cant do more than 80km/hr and even then I was only doing 70km/hr just to make sure I got home ok. Seriously its about 1/4 the width of the new 265/35 rubber.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Latest Posts

    • I've been doing some looking around and honestly was just considering throwing a new rack at it. I saw that the dmax silvia rack bolts up into the 33 with the silvia bushings but not sure if the high pressure lines will sit in the correct spot. I believe other version of the 33 rack are the same/similar to the racks that can be opened up without as much fuss so I assume the dmax rack would fit but any ideas?
    • I've never played with one, but I would expect that you are correct. That slot looks like it is intended to be used to unscrew the end, and the flats on the body would be better than grabbing it around the round bit with a pipe wrench. So, yeah, probably unscrews. You'll probably have to make a tool to drive in that slot.
    • A bit late but A disk S13P fit over stock R32 GTR brakes, usually A disk front, O disk rear works.
    • Or, the height of the release bearing is not correct for your combo. Start with the bleeding and checking the slave moves throughout its range when you press the pedal (2 person required), but it is possible for the height to be internally wrong too (box back off to measure.
    • Yes, there's quite a few things that can go wrong during a clutch install. Very unlikely. I have a similar clutch. They (ACS) make good gear. No, it is not normal. It is possible that you just need to bleed the clutch slave. But the new clutch will also have a more aggressive actuation force/pressure, and so your old slave cylinder might be a bit leaky or otherwise compromised, and not up to the extra force required. Or the master cylinder, same.
×
×
  • Create New...