Jump to content
SAU Community

Recommended Posts

Hi guys, I'm in a bit of a rush to get my car ready to leave for alot of work that will be completed in november. So I have finally gotten around to spending some time with the ratchet and getting off the parts that I want to sell.

What's remaining that I would like to get rid of today are ;

Genuine Ganador CF finish mirrors for r34 with the blue tinge lens.

$500 outright or $400 swap with standard mirrors.

Work S2R rims , good rubber all round, 18x9 , 18x10.5, good agressive offset, fill r34 guards, rears will need to be rolled. $1500 or $1200 with trade for any r34 5 stud stockies/na stockies that will fit.

Apexi AVC-R, good working order, $350

Signal CF bonnet with nose piece, $1200 or $900 swap over

Pair of Recaro Millenium with r34 rails, small rip on passenger seat from my belt, apart from that i'd give em a 7.5/10. $ 800!!!

The fabled TK dash, $750 or $550 with swap of standard cluster.

All pics of everything can be seen in my other threads.

All prices negotiable,

i'll be pulling this shit out all day so sms me on 0421 120 034.

Thanks ya'll.

Mods, if you'd be so kind to leave till around sun down, that'd be appreciated.

Located, inner east.

Link to comment
https://www.sau.com.au/forums/topic/279777-pulling-parts-of-my-car-today/
Share on other sites

Always intended on going Craft Square's so still not sure =/

eat the pudding eat the pudding eat the pudding eat the pudding eat the pudding eat the pudding eat the pudding

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


  • Similar Content

  • Latest Posts

    • Yep, the closest base tune available was for the GTT, I went with that and made all the logical changes I could find to convert it to Naturally Aspirated. It will rev fine in Neutral to redline but it will be cutting nearly 50% fuel the whole way.  If I let it tune the fuel map to start with that much less fuel it wont run right and has a hard time applying corrections.  These 50% cuts are with a fuel map already about half of what the GTT tune had.  I was having a whole lot of bogging when applying any throttle but seem to have fixed that for no load situations with very aggressive transient throttle settings. I made the corrections to my injectors with data I found for them online, FBCJC100 flowing 306cc.  I'll have to look to see if I can find the Cam section. I have the Bosch 4.9 from Haltech. My manifold pressure when watching it live is always in -5.9 psi/inHg
    • Hi My Tokico BM50 Brake master cylinder has a leak from the hole between the two outlets (M10x1) for brake pipes, I have attached a photo. Can anyone tell me what that hole is and what has failed to allow brake fluid to escape from it, I have looked on line and asked questions on UK forums but can not find the answer, if anyone can enlighten me I would be most grateful.
    • It will be a software setting. I don't believe many on here ever used AEM. And they're now a discontinued product,that's really hard to find any easy answers on. If it were Link or Haltech, someone would be able to just send you a ECU file though.
    • Yes sir am asking is there possible way from aem tuner from wiring pins 
    • Have you checked cam to crank timing and confirmed balancer marks are correct?
×
×
  • Create New...