Jump to content
SAU Community

Recommended Posts

Hey Crew, I have 2 x DEFQON1 Tickets for sale on the Ultimate Party Island in Sydney

:D:P:bunny:

Saturday 19 September 2009.

Sydney International Regatta Centre!

Peeved I cant make it anymore so these tickets are now Available.

Preview

$250 for both. PM me or call me on my cell 0404 822 143

S!N

:ninja:

Edited by Sinista32
  • Replies 44
  • Created
  • Last Reply

Top Posters In This Topic

I just put them all on Facebook today :P

Can you get onto Shane's facebook and have a look? Otherwise I can start a thread and post them up if people want to see them... just didnt want to attention whore them around everywhere LOL

Thanks Sin, handy info in there :)

I'm perfectly set for transport - driving up and leaving car at a mates place 10 mins walk from Penrith station :D

SO pumped, shame you couldn't go - but then I wouldn't haha, not to mention the afterparties no doubt

I didn't even know what a lad was until I read that. Then I promptly lol'd pretty hard.

What a bunch of wankers.

The one thing that bewildered me, and slightly annoyed I suppose, is where you're not allowed to wear a shirt bearing a brand name. I mean, I've got a Billabong shirt I was going to wear, now I can't. Most of my shirts have a brand name, the only one that doesn't is just a plain white tee....kinda lame.

I didn't even know what a lad was until I read that. Then I promptly lol'd pretty hard.

What a bunch of wankers.

The one thing that bewildered me, and slightly annoyed I suppose, is where you're not allowed to wear a shirt bearing a brand name. I mean, I've got a Billabong shirt I was going to wear, now I can't. Most of my shirts have a brand name, the only one that doesn't is just a plain white tee....kinda lame.

Where does it say about brand names.... I can only see the "Lads and Lad clothing will not be allowed into the event" bit ???

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now



  • Similar Content

  • Latest Posts

    • Even welded diff, in a dead straight line is quiet. It's what's in my R33, and you only notice it is welded when attempting to turn.   This to me sounds like there is play somewhere. But I'm not sure where I'd look to be honest.   OP: are your tyres the same size left to right? Can you check what the markings on the rear left and rear right tyre are, and then how much tread is on each tyre?
    • sold listed as a Tomei LSD 1.5 Way For 1998+ Nissan Skyline ER34 25GT RB25DE w/Open R200 https://www.ebay.com/itm/174006114594?campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=&mkrid=711-53200-19255-0&loc_physical_ms=108689&loc_interest_ms=&campid=5338967980&mkevt=1&mkcid=1&toolid=10050&customid=71883f2ccc571356e0a757bc7adfdde2&mkrid=710-53481-19255-0&loc_physical_ms=108689&loc_interest_ms= it went in like butter all gears, alignment, back lash etc, rotation and clearances correct, and if rolling all rotates smooth and free when coasting down road , clutch in or out over 10 mph smooth... its the binding, clunking and jerking from a stop that is most concerning, also seems like its going to tear the tires off in 10 miles of normal road driving. 
    • What 1.5 way? There's no such thing really as a 1.5 way, just different ways of explaining 2 ways with different ramp rates. HOWEVER. In any driving in a straight line your 1.5 or 2 or 1.7 way should have no clunking at all. With the clutch fully depressed the diff should be silent (unless it's welded but I'm assuming it's not). Something aint right here.
    • Clutch is a spec brand, new clutch system,( PP, flywheel, friction disc, etc. pull type) installed 100 miles ago, with no problems.
    • looking for some help and maybe some insight on others experience with a new LSD. R34 GT ran and drove beautifully, but always alot of grip loss due to the open R200 rear end, so I just installed a new 1.5 LSD way into the stock open R200 for a ER34. Simple. Everything seemed right. I test drove for the first time this weekend. as I started to back out the garage the first time slowly with tires straight it sounded and felt like I had a loose or half disconnected drive shaft...that was clucking around loose and shaking entire vehicle, and making it feel like the trans clutch was spontaneously slipping then grabbing very roughly while just letting out pedal slowly. I backed it out went to pull forward with the same noise, shake and slip grab feeling with hesitation, I turned the tires to back out more and then pulled ahead some same thing but worst because of added wheel resistance (which that I expected) puzzled … pulling it back in checking everything over and finding nothing wrong, I tried it the next day. same thing, couldn’t believe how it shook everything again making a terrible noise and making it feel like the trans clutch was slipping and grabbing, but I got it out of garage into the driveway, got it straight, drove forward and then reveres a few times in a straight line everything shaking , causing what felt like clutch slip and grab every time, sounded like right behind front driver tire and I could feel it in the floor board with my feet,... worst right when beginning to let clutch pedal out to engage slightly, shuttering and sounding terrible along the way…I managed to slowly get down the road, babying it the whole way, once I was rolling (out of 1st) seemed to be better and between shifts, then clutch felt closer to normal…not slip/ grab etc., but back down to any stop, straight road or turning, same thing. Made no difference if all tires were straight or if I was turning. All other gauge read out correct. with in 2 miles as planned I reached the empty parking lot and performed the break in procedure that came with lsd, essentially to drive in a figure 8 a bunch.  Did this, binding chattering, and shaking the car the whole way. I drove it back home seemed somewhat normal once I was in straight line and past 10 mph or so, and I know it will “bind” on corners and cause some tires squeal when turning especially from a stop, but when I begin to move it still causes what feels like the trans clutch to slip and jerk badly as well as shaking the entire car, and sounds terrible, that I didn’t expect. I used the fluid they supplied with LSD kit and did the breaking, planning to change fluid as they suggest after breaking, but wondering will it get smoother or less aggressive with use? maybe a 1.5 is just too aggressive for normal road driving?   I have a LSD that I put in my 71 cuda when I restored it, with amazing smooth , quite yet effective results. Different style LSD but that ones a joy to drive. maybe expecting too much from this R200?
×
×
  • Create New...