Jump to content
SAU Community

Recommended Posts

What compressor Chad?

18,20 or 25G

It will be laggy, like 4500rpm full boost.

What rear housing size as well? 8 or 10cm2

Im waiting to hear back, but it comes with elbow, dump pipe and braided lines and should bolt straight in.

Edited by DSTROY
  • Replies 14.2k
  • Created
  • Last Reply

Top Posters In This Topic

We got any suspension experts that can tell me what tie rods do? they simmilar to caster rods.

im hoping to be able to move the front wheels forward n back say adjusting the wheel base of the car. dosnt need to move a lot just a inch or so.

Tie rods are on the ends of the steering rack, what your after Dan is Castor/radius these go from the front mounts on the sub frame to the lower control arm. Tie rods will adjust toe in/out and camber slightly.

On another note, a nice big box with Apexi written on it arrived today and a smaller one yesterday with the Turbosmart logo :banana:

??IS ANYONE LOOKING FOR A RENTAL PROPERTY??

We where looking at selling, but now we want to keep it and rent it out again.

heres some details.

2 bedroom unit in St Agnes

Built in wardrobes in both rooms

brand new bathroom

brand new kitchen with stainless cooktop/oven etc etc

instant hot water service

polished floorboards through-out

reverse cycle air conditioning (cold as)

just across the road from centro St Agnes shopping centre, and park, playground etc etc

no maintenance required on the outside, thats what we pay strata a cvnt load every 3 months for.

pass it on if you know anyone, we dont really want to go through an agent anymore.

will be roughly 220pw.

Edited by craig R33

Time for car update :blush:

After getting stuck on a dirt rd in Ashton and then towed to adelaide/loby rd and then towed to the workshop i decided to see how my clutch looked.

post-38653-1262690745_thumb.jpgpost-38653-1262690783_thumb.jpg

I actually manage to get the gearbox and clutch out all by myself :)

post-38653-1262690868_thumb.jpg

After that i decided that since im on holidays till monday i might start taking the motor out.

post-38653-1262690934_thumb.jpg post-38653-1262691009_thumb.jpg post-38653-1262691052_thumb.jpg post-38653-1262691089_thumb.jpg

I manage to do all that by myself from sunday to today :D

Time for car update :)

After getting stuck on a dirt rd in Ashton and then towed to adelaide/loby rd and then towed to the workshop i decided to see how my clutch looked.

I actually manage to get the gearbox and clutch out all by myself :D

After that i decided that since im on holidays till monday i might start taking the motor out.

I manage to do all that by myself from sunday to today :D

If you need a hand at all let me know...i don't have work till Friday, off Saturday, on again Sunday.

Edit: Helps if i look at the rest of the photos, nice work getting the engine out...now i know who to bring mine to when its time to do a rebuild :blush:

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Seat of the pants assessment of the new intake: The car is way less "doughy" when hitting the loud pedal, especially off idle when stopped or in traffic, I did use a cheapo lazer thermal thingo to measure the temp around where the pod filter got its air, it was between 55 - 60°C, in saying this the car was shut off and not moving, so the OEM intake pipe was not supplying any fresh air to where the pod was when the car was at least moving A weird bonus was induction noise on the throttle in the cabin increased a bit,  I was worried that I was actually going to lose some of that induction noise I love so much, outside though, when I got the daughter to do a WOT drive by pass for me, the induction noise has increased alot when on the throttle, not quite ITB doort, but well up there I'm extremely happy with the results and have been exploring the country roads in the region  As for house mods: 1.New front fence is up and is awesome, it really upgraded how the joint looks from the street, and the added security is nice 2. Electricians have replace some interior lights, and with more lighting in the garage, a few new motion detecting lights out the front above the garage, front room, and at the front door, which I have already found heaps helpful coming and going, also now has fancy pants CCTV all round the house The only hold point for power though is the solar and batteries due to supply issues, although this will happen over the next few weeks 3. I have done a heap of landscaping out the front and I'm almost ready to do a new small retaining wall with some nice blocks to replace the brick and cemented in rocks around the raised garden beds cemented in river stone "was the fashion at the time" the house was built. I currently have a pallet of retaining wall blocks and 2 bulka bags of 20mm blue metal to replace the wood chip that is in the raised garden beds around the house 4. I now have 3 big raised garden beds for out the back to grow some vegetables, about 70cm high, 200cm long and 100cm wide 5. My 2 compost bins are already pretty full with brown, green and kitchen waste from the landscaping I'vedone so far, but they will probably take a few months to break down, so anything else that gets chopped, trimmed, and kitchen waste will just start filling the base of the raised garden beds to about 30cm before I start throwing 40cm of good compost, and stuff, for the vegetables to grow in, I'll need a few ton of compost and soil, but the local supplier can sent me bulka bags of the stuff Basically the logs, wood chips and a few strategically placed rocks for drainage, will give the beds some good organic materials down low to break down over time, and they will hold moisture during the warmer months to save the water in my big arse water tank if we don't get alot of rain So, all in all, the car and house mods are going well, and I'm really enjoying being retired, I sleep in too 0700 and slowly plod around inside until I feel like actually doing anything, and only work in the yard for as long as want, which has actually been alot over the last few weeks,  although when you look at it, it seems that not a huge amount of work has been done,  until I look at the before I started the work pics Happy days and good times indeed 
    • hahaha yeah. Plan is to get side skirts and probably just rear pods. But going to do them one-by-one. I've got a set that I really like from RHDJapen, but that one isn't shipped to AU. So need to find someone who can get it for me
    • Here's an idea, answer the questions I asked you as they are trying to work out WHY the LSD will be binding up in a straight line.
    • You haven't driven many modern cars then have you? Most of them have sfa steering feel with their stupid electric bullshit steering systems.
×
×
  • Create New...