Jump to content
SAU Community

Recommended Posts

  • Replies 14.2k
  • Created
  • Last Reply

Top Posters In This Topic

http://poststuff3.entensity.net/050710/fla...p?media=dog.flv

HAHAHAHAHAHAHAHAHAAHAAAAA

click on it, you wont regret

**** pls note i am not Damo so it isnt a rickroll :)

put that shit on facebook. funny as.

Very very Nice. Did you need to test that engine in my shell? :P

why certainly kind sir... but i believe that there is a small chance of your gearsets being stripped :)

skwiz.. i wanna make love to your new toy.. thats heaps nice

went to the trouble of taking the 200 around to a potential buyers house tonight, which is no small thing when you dont have a licence and the only other manual driver in the house has recently had surgery on his knee, but anyways, i found a way.

get the car there (out in mile end), park up in the dudes very well lit drive way, and he spends 5 minutes looking around the car, doesnt pop the hood, doesnt look under the car, and doesnt ask any questions.

after hes done he comes up to me and says, "look mate, im a mechanic, and its obvious to me that this car hasnt been looked after, and i reckon its been drifted into a kerb or 2 eh, chuck us the keys and ill take it for a test drive, if im happy with it, ill give you $9k."

dont know what the hell he was expecting with that.

i bet he didn't RoR spewn Dave better luck next time

unfortunately he didnt. :P

he did tell me to get f**ked though, so im hoping to hear from him soon. :)

What movie?

id allow him to skip the dinner if he took me to see twilight. :)

Edited by scandyflick
Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • The downside of this is when you try to track the car, as soon as you hit ABS you get introduced to a unbled system. I want to avoid this. I do not want to bleed/flush/jack up the car twice just to bleed the f**kin car.
    • But again, the engineers said your cast aluminium would be fine based on the load that would be stretching that section. Same load stretching the bolts in a flex (not the twist), with a much smaller cross sectional area than the original part you've broken. It's why you'd need to be using higher strength bolts, but that's just making up for the strength you lose with less area...
    • I am truly amazed someone on this planet was able to cycle the pump using a scan tool. I've always ghetto cycled them on Nissan 90s shit boxes by slamming the brakes and pulling the handbrake to agitate the rear wheels enough to cause a speed difference
    • I didn't actually try it at the time but a Launch X431 with the appropriate software licenses/upsell will have the ABS bleed function. The Consult II you can still find some old sets of equipment but they're really, really expensive:   
    • Well I'll start by saying I'm not an engineer. I am going to go with the KiwiCNC ones.  They are made of 7050 alloy have good fillets and radius.  The material alone is in the order of double the strength and fatigue resistance - Those bolts, once torqued correctly place most of the load at the flat face of the mating surface - the 'stretch' you're talking about through torqueing them up would be far more than the extra stretch 'load' placed on them from a steering input or bump. (in my opinion) so I doubt they would flinch.    - but again "not an engineer".      oh and I don't think stitch welding 7050 is a good idea, likely just weaken the material (from what I read)
×
×
  • Create New...