Jump to content
SAU Community

Recommended Posts

Spotted a Silver R32 Gts-t on Merrylands Rd turning into the Red Rooster car park. Was this afternoon at about 4pm. Had standard black on yellow plates and silver mesh wheels.  

A few minutes later, an egg yellow R33 GTS-t with GT-R kit.

was that r32 the the best gtst you had ever seen???

:rofl:

were you dirving?

nxtime you see me down there come say hello

bring your nissan NX with you.

was that r32 the the best gtst you had ever seen???

:rofl:

were you dirving?

nxtime you see me down there come say hello

bring your nissan NX with you.

It's probably the best silver R32 Gts-t with mesh wheels, GTR front bar and yellow number plates that I have ever seen on Merrylands Rd.

:)

I was in the middle of eating some Oporto's. :)

Do you work around there?

Oh, I'll bring the Nissan, alright :(

PS, do you always hang your arm out the driver's window or only while turning? :wassup:

I was in the middle of eating some Oporto's. :)

Do you work around there?  

Oh, I'll bring the Nissan, alright :rofl:

PS, do you always hang your arm out the driver's window or only while turning? :wassup:

the turns into an oven after a while.

lol

my gf works in merrylands

so what did you eat???

Seen a few lines around lately.

Firstly followed a beautiful black R34 GTR 'MADGTR' from Lane Cove to North Ryde last week.

Then yesterday had a clean white R33 GTR pull up next to me on the corner of Herring (I think?) and Epping Rd, opposite the Ranch. Gave eachother an acknowledging nod, and I proceeded to drool at his ROH rims and other aesthetical mods (subtle but very slick!)

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • Ok so after much research and talking with knowledgeable people I've got my turbo conversion done and it's all running great other than 1 small issue.  Car has remained auto with the na auto and tcm, I've used a stagea ecu with. NIstune board and everything is great other than my gear selection on the dash. It illuminates park, reverse, neutral, 3rd and 2nd. But nothing drive or what gear your in when you pop it into tiptronic.  I'm sure there is may e 1 wire in the ecu plug I need to move to rectify this. Dose anyone here have any ideas?   Cheers guys
    • Sorry I haven't been following all the detail, so you may have tried this. Does it idle with the tiniest bit of throttle you can add? You've mentioned the IACV, does it have an AAC valve and have you adjusted it at all (ie, screw the idle adjust screw all the way in, then back it out a couple of turns until idle is stable)?
    • My bad, I unplugged the one underlined in red instead of yellow before. With the car started, after unplugging the IACV (the one underlined in yellow), it idled at around 400/500 for 3 seconds before stalling. Attempting to start the car without the IACV will not start the car.   It does stutter and sputter for around 5 seconds before dying. However, immediately after starting it, you can already hear some slight sputters from the exhaust.   It won't start with the AFM unplugged. If it is when the car has already started, it stalls in a few seconds.   Yesterday, I did take some logs using Nistune of 3 scenarios. Car idling till it stalls Car idling and unplugging the IACV Car idling and removing the AFM I also have some previous logs of when the Car is idling till it stalls and when driving and it cuts. I am not really knowledgeable enough to understand what to look for. After every test, car idles rougher and rougher, until I have to stop. It will be fine the day after.
    • There is no difference between a 17x8 and an 18x8. The total diameter of the tyre needs to remain +/- the same (so you don't mess up the gearing, speedo reading, and clearance when turning front wheels..... so you just need to use a lower profile tyre on th 18 than you do on the 17. /rocket surgery.
    • I thought the same to start with. But then I thought it was one of those LCAs where the end of the ARB goes through a bushing in the LCA itself, instead of having an end link.
×
×
  • Create New...