Jump to content
SAU Community

Recommended Posts

Spotted Satanic driving pass the Wynard bus stop at 11:30ish, would've stuck my thumb out for a ride home but you were long gone.  Even with the bus blocking my view, your impuls just gave u away. :P

:P BWAHAHAHAHA!!!! (don't mind me) Hahahahahahahahaha! :P

I saw 2 yellow R34 GTR's yesterday. One in the greenwood plaza carpark AG????, its there again this morning. And other one turning onto elizabeth dr at 4pm, it had some lovely pannel damage on the drivers door.

Spotted gal driving KAZ25T, a nice white R33 in hunters hill (Ryde rd, on the bridge over burns bay rd)

Smiled and got a smile back B)

Really nice tidy looking 33

Saw another guy in broadway, grey 33 S2 -big FMIC turning left into mountain st from shops. appreciative nods going both ways :P

BTW: did a search on my plate (since i havn't been on the forums for a while) and was shocked to find a spotted thread wayyy back where Moanie claims i was rude! hA, I must have zoned out and missed you...

moanie: the post said it was in 2003! haha.

anyway, the last time you FLEW past me, i gave u a hi beam and wave... even tho had my mom and two pet dogs in the car

hahahaha.. what tha!!!! link me :P

and i think i remember that!!! was it on carlingford road? :D you were taking your dogs to the vet?!

Guest
This topic is now closed to further replies.



  • Similar Content

  • Latest Posts

    • There are black hose clamps as well if you care. Plazmaman for example sells some: https://plazmaman.com/product/black-hose-clamps-premium-quality-stainless-breeze/
    • After using a protractor for an actually accurate assessment of what is required,  and by NOT using my uncalibrated eyeball I worked out I need a 25° silicone bend from the TB ro the MAF, but, my choice was either a 30° or a 23° (23° is a weird spec), so I grabbed the 23° one from Raceworks I also grabbed 1mtr of 3" straight from Just Jap, I needed 350mm, but they only had 300mm, or 1mtr lengths....meh Also ordered a 1/2" hose bulkhead fitting from fleabay, this has a smoothish mushroom looking head (they are designed for below the water line of boats) that will fit inside the bend, the hose bit and threaded bit looks to long, but nothing that a hacksaw cannot fix if required, the hose will then just get jamed on the threaded bit up to the retaining nut Fingers crossed and the unsightly amount of hose clamps will be reduced down to 4 once all the parts arrive 
    • Oil change does not trigger code 21. Code 21 is for coilpacks primary side connection. You can try to clear the code with a battery disconnect, hold down the brake pedal to drain capacitors through the brake lights with the ignition on for 10-15 seconds before you reconnect the battery. I have seen R35 coil conversion permanently cause this code with no ill effects so it might be the resistance it wants to see isn't quite right on one or more coilpacks. Could be inside the ECU, could be the harness, could be a coil. You can test it all if you want or just ignore until the car actually starts misfiring.
    • I forgot you have a Nistune ECU. Use Nistune to do all the tests I mentioned instead of faffing with 30+ year old electrical connectors. You can read MAF volts off that too, there are reference values in the service manual to tell you roughly what it should be in different conditions.
×
×
  • Create New...